What is the reason for being stuck in fifth gear and unable to shift out?

1 Answers
DiEvelyn
07/29/25 5:54pm
It may be caused by excessive gear clearance in the car's transmission leading to gear jamming. The following is a relevant introduction about gear shifting: 1. Shifting timing: Gear shifting should be timely, correct, smooth, and quick. When starting the car, generally use the low gear (first gear) to start. After starting, as long as road conditions permit, quickly and timely shift up to higher gears step by step. Generally speaking, higher gears are more fuel-efficient than lower gears. Therefore, after starting, shift up in time and avoid driving in a gear that is too low for the speed. Do not use high gears to force driving on slopes or when the speed is reduced; nor is it allowed to use lower gears for long periods under good road conditions. 2. Pay attention to coordination: When shifting gears, pay attention to the coordinated operation of the clutch pedal, throttle, and gear lever. The gear lever must be pushed firmly into place during shifting to ensure complete gear engagement, to avoid damaging the gears or the transmission automatically disengaging while driving. The key to upshifting lies in increasing the speed before shifting up. The throttle should be 'steadily increased' and 'quickly released'. After starting in first gear, you can shift to second gear without 'accelerating suddenly'; when shifting from second to third gear, gently press the throttle to shift to third gear. In subsequent upshifting processes, the degree of throttle pressing gradually increases, but excessive acceleration should also be avoided.
Was this review help?
5
4
Share
More Forum Discussions

What documents are needed for car registration?

The required documents include: vehicle certification, purchase invoice, and compulsory traffic insurance policy (commercial insurance can be purchased after registration). In Beijing, Shanghai, and Guangzhou, proof of vehicle purchase quota is also required. Before going to the vehicle management office for registration, you should make three copies of your ID card, temporary residence permit (if any), vehicle certification, purchase invoice, and compulsory traffic insurance policy for backup. The process for new car registration is as follows: 1. Obtain the vehicle certification: The vehicle certification is very important and is required for registration. Currently, some car 4S stores delay providing the vehicle certification, which may postpone the registration. Therefore, you should communicate with the 4S store frequently and firmly to obtain the certification as soon as possible. 2. Keep the triplicate purchase invoice: After purchasing the car, the 4S store will issue a triplicate purchase invoice. Be sure to keep it safe as it will be needed for subsequent registration. The invoice has red, yellow, and blue copies. Generally, the red and yellow copies need to be submitted, while the yellow copy should be kept by yourself. 3. Pay the vehicle purchase tax and obtain the tax certificate: After purchasing the car, you should pay the vehicle purchase tax as soon as possible. You can usually do this at the nearest vehicle management office. After successfully paying the tax, you will receive the tax certificate, which should be kept safe. 4. Prepare various documents: Prepare the original ID card and copies (make several copies for backup). Non-local residents need to provide the original and copies of the temporary residence permit (organizations need to provide the original and copies of the organization code certificate). 5. Register and inspect the vehicle at the vehicle management office: Once all the procedures are complete, you can go to the vehicle management office to apply for a license plate. First, a specialized traffic police officer will inspect the vehicle, mainly checking the vehicle identification code, appearance, and warning triangle. Prepare these in advance. 6. Choose the vehicle license plate number: After the inspection, you can go to the vehicle management office hall to select a license plate number. Generally, there are two options: self-selection and random selection. Additionally, most regions now offer online license plate selection. 7. Pay the fee and wait for the license plate: After selecting the number, pay the fee and wait for the license plate. It usually takes three to five working days to receive the license plate.
15
3
Share

Should the Buick Regal use 5W30 or 5W40 engine oil?

Buick Regal uses 5W30 engine oil. Compared with 5W40, 5W30 has the same low-temperature fluidity but differs in high-temperature performance. 5W40 has higher viscosity, providing better high-temperature protection and sealing performance. However, the increased viscosity results in greater engine running resistance and higher fuel consumption. For the Regal's engine, 5W30 engine oil is more suitable. 5W refers to the range of ambient temperatures in which the oil can be used, indicating its viscosity grade. It can be used in extremely cold regions during winter, with temperatures ranging from -40°C to -10°C. This viscosity grade of oil is relatively thin, with excellent low-temperature fluidity, resulting in relatively low running resistance at low temperatures and making it easier to start the car. Key factors to consider when choosing engine oil: The selection of engine oil should be based on the requirements of the engine. It is unnecessary to use overly advanced oil in engines with lower requirements, nor should lower-grade oil be used in engines with higher requirements. Precautions for changing engine oil: The engine must be preheated before draining the oil. At this time, the oil is thinner and flows more easily, helping to carry away impurities and ensuring thorough drainage. Remember not to drain the oil when the engine is cold, and replace the oil filter simultaneously. The old oil filter may be clogged with impurities, and a blocked oil filter can slow down oil flow and reduce engine lubrication. The amount of oil added should be measured, and for some vehicles, the oil level can be checked with a dipstick to ensure it is within the proper range.
10
5
Share

How many points are deducted for not using the turn signal when making a U-turn?

According to the "Road Traffic Safety Law", not using the turn signal when making a U-turn results in: 1 point deduction; fine: 100 yuan. Other situations that result in a 1-point deduction include: not using lights as required; not meeting vehicles as required; motor vehicles carrying cargo exceeding the prescribed length, width, or height; motor vehicles driving on the road without inspection qualification marks, insurance marks, or without carrying the vehicle license and driver's license. Article 57 of the Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China states that motor vehicles shall use turn signals as follows: When turning left, changing lanes to the left, preparing to overtake, leaving a parking spot, or making a U-turn, the left turn signal shall be turned on in advance; When turning right, changing lanes to the right, returning to the original lane after overtaking, or parking by the roadside, the right turn signal shall be turned on in advance. Turn signals: Must be turned on when the vehicle is turning, flashing intermittently to alert vehicles and pedestrians around. The timing of turning on the turn signal should be well controlled, and it should be turned on about 30 to 100 meters before the turning point. Situations where U-turns are allowed: Intersections with U-turn signs: If there is a clear U-turn sign at the intersection, a U-turn can be made; if there is a U-turn signal light, the U-turn must be made according to the signal light. If there is no signal light, a U-turn can be made based on the specific situation, provided it does not hinder other vehicles or pedestrians. Intersections without explicit prohibition of U-turns or left turns: If there is no explicit sign prohibiting U-turns, a U-turn can be made. "No explicit prohibition of U-turns" means that as long as there is no "No U-turn sign," "No left turn sign," or the center line is not solid, a U-turn can be safely made. Yellow grid lines also allow U-turns: Yellow grid lines are actually no-parking grid lines painted at intersections prone to temporary parking congestion, important unit entrances, and other locations where they are needed. Any vehicle stopping on the no-parking grid line (including waiting for traffic lights) is a violation. Although vehicles cannot stop in the yellow grid line area, U-turns are allowed. As long as there is no central isolation barrier, the yellow grid line is equivalent to "U-turn allowed." Intersections with U-turn signal lights: This is easy to understand. If there is a U-turn signal light, you must follow the signal light and only make a U-turn when it is green. When "No left turn" and "U-turn allowed" signs appear together: U-turns are allowed but left turns are prohibited. However, "No U-turn" is not the same as "No left turn." Things to note when making a U-turn at an intersection: Observe the road markings. If it is a solid line, U-turns are not allowed under any circumstances, and you should continue driving to find a suitable place for a U-turn. If there is a "No left turn" sign ahead, even if there is no mention of prohibiting U-turns, U-turns cannot be made at this intersection because the actions of left turns and U-turns are very similar, and a U-turn must involve a left turn first. U-turns must be made from the innermost left-turn lane. If you are in the second left-turn lane, you cannot make a U-turn at this intersection. When making a U-turn, you must yield to vehicles going straight and only make the U-turn without interfering with their normal driving. Otherwise, you will bear full responsibility for any accident. Generally, near the intersection stop line, lanes are marked with guiding arrows for vehicles to choose lanes. The leftmost lane is not always marked with a left-turn arrow. On some roads, if there is a straight arrow, even if there are no explicit signs prohibiting U-turns, U-turns are not allowed.
10
5
Share

How to Open the Rear Door of a Business Vehicle with Automatic Doors?

If the business vehicle is equipped with automatic doors, you can simply pull the door gently by hand to open it automatically. Some models use button-operated doors, where passengers can close the door using the buttons inside the vehicle after boarding.
6
2
Share

What to Do When the Car Windshield Fogs Up on Summer Nights or Rainy Days?

You can slightly open the windows on both sides to create air convection between the inside and outside of the car, which reduces the temperature difference and slowly dissipates the fog. Using the air conditioning system to defog is the most common method. Simply adjust the air conditioning to the appropriate setting, and the wind from the air conditioner will help remove the fog.
17
1
Share

How to Reset the Car Tire Pressure Warning?

Park safely by the roadside and first check the tire pressure monitoring function on the car's navigation screen for any wheel anomalies. Check whether the tire pressure of the wheels is too high or too low. If the tire pressure is low, inflate the tires to the safe pressure value. If the display indicates that the tire pressure is too low, reset the system and drive for a short while. The tire pressure warning will then be reset, and the issue will be resolved.
10
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.