What is the range of the Hongqi HS9?

What are the requirements for an A2 driver's license?

A2 driver's license specific requirements are as follows: 1. Age requirements: (1) Applicants for the A2 tractor driving category must be between 24 and 50 years old. (2) Full-time driving vocational education students applying for the tractor driving category must be between 20 and 50 years old. 2. Physical requirements: (1) Height: At least 155 cm. (2) Vision: Naked or corrected visual acuity must reach 5.0 or above on the logarithmic visual acuity chart. (Corrected vision refers to achieving 5.0 with glasses.) (3) Color vision: No red-green color blindness. (4) Hearing: Able to distinguish the direction of sound sources with each ear at a distance of 50 cm from a tuning fork. (5) Upper limbs: Both thumbs must be intact, and each hand must have at least three other fingers intact, with normal limb and finger movement function. (6) Lower limbs: Both lower limbs must be intact with normal movement function, and the length difference must not exceed 5 cm. (7) Trunk and neck: No movement dysfunction. 3. Application requirements (1) Cannot be obtained as an initial application; it can only be obtained through an additional driving license. That is, you must first obtain another driver's license and then apply for the A2 driver's license through an additional driving test. (2) Additional driving conditions: According to Article 14 of the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses" (Order No. 123), applicants must already hold a motor vehicle driver's license to apply for an additional driving category.

17

1

Share

Should a Chevrolet Use 92 or 95 Octane Gasoline?

According to the official vehicle manual recommendation, Chevrolet should use 92 octane gasoline. In addition to checking the suitable gasoline grade in the vehicle manual, you can also find it marked on the fuel tank cap. Generally, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with an engine compression ratio between 8.6-9.9 should use 92 octane gasoline, while those with a compression ratio between 10.0-11.5 should use 95 octane gasoline. However, with the application of new technologies, the gasoline grade can no longer be determined solely by the compression ratio. High compression ratio engines can also be tuned to use lower octane gasoline. This is because, besides the compression ratio, other factors such as ignition timing, turbocharging technology, and Atkinson cycle technology also play a role. Generally, the higher the gasoline grade, the higher the octane number and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane. If you occasionally use the wrong gasoline grade in a Chevrolet, simply switch back to the correct grade after the current tank is used up. However, long-term use of the wrong gasoline grade can have the following effects: For vehicles recommended to use lower octane gasoline, using higher octane gasoline will not cause damage, but the increase in octane number will alter the fuel's ignition point, leading to delayed combustion in the engine. This means both the engine's power output and thermal efficiency will decrease, resulting in poorer performance. For vehicles recommended to use higher octane gasoline, using lower octane gasoline can cause engine knocking. Because the octane number is too low, the gasoline will ignite prematurely during the compression stroke before the spark plug fires. This premature ignition creates resistance during the upward stroke. Such resistance makes the engine run very unstably. If the knocking is mild, it only increases noise without significant damage to the engine. However, if the knocking is severe, it indicates serious engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring.

19

2

Share

What is the structural principle of run-flat tires for explosion prevention?

Run-flat tire structural explosion prevention principle: The reason why RSC run-flat tires do not collapse after air leakage is mainly due to the thickened rubber sidewalls. Even when air pressure is lost, the sidewalls can still support the vehicle's weight without causing severe deformation. Below is an introduction to RSC: 1. To prevent the tire from detaching from the rim after deformation, the rim is specially designed with protrusions that prevent the tire from coming off after a sudden pressure drop. Vehicles equipped with run-flat tires may not alert the driver to minor air leaks, so RSC also includes a TPI electronic warning system installed on the rim. Once tire pressure begins to drop, RSC immediately alerts the driver. 2. The design principle of RSC run-flat tires relies on sturdy sidewalls to provide support. Another design for run-flat tires involves installing a device called a fixed ring inside the tire. This fixed ring supports the tire from the inside, preventing it from being crushed and also stopping the tire from detaching from the tire bead.

17

5

Share

What Causes Abnormal Noise When Turning the Steering Wheel?

Reasons for abnormal noise when turning the steering wheel: 1. Friction between the steering column and floor mat. If the noise comes from below the steering wheel while turning, check the steering column and floor mat. An oversized aftermarket floor mat may directly contact the steering column, causing friction during rotation. Lack of lubrication can produce noise—applying lubricant usually resolves this. 2. Clock spring (spiral cable) malfunction. If the noise originates inside the steering wheel, it's likely caused by interference with the airbag clock spring. 3. Lack of lubrication in strut mount bearings. When external noises occur during steering, it may indicate dry strut mount bearings needing lubrication. 4. Loose stabilizer bar bushings. If the noise isn't from strut bearings, inspect stabilizer bar bushings for looseness or damage. Worn bushings cause noise during steering and on rough roads. Tightening with shims may help, but replacement is necessary if damaged. 5. Contaminated power steering fluid. Dirty fluid increases system pressure, causing a "humming" noise from the power steering pump, requiring immediate fluid replacement.

14

3

Share

What is the fuel tank capacity of the Changan CS55?

The fuel tank capacity of the Changan CS55 is 58 liters, as officially announced. Owners who have purchased the Changan CS55 can also check this information on the vehicle's configuration sheet. The Changan CS55 requires 92-octane fuel, with a fuel consumption of 6.5 to 6.6 liters per 100 kilometers. A full tank of fuel allows for a driving range of 879 to 892 kilometers. During daily driving, it is essential to monitor the remaining fuel level in the tank. This is typically observed through the fuel gauge inside the vehicle. Under normal circumstances, the fuel level will be accurately reflected on the gauge. The fuel gauge usually has 5 to 6 segments, and it is advisable to refuel when only 2 segments remain to avoid running out of fuel mid-journey. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the manufacturer's specified tank capacity is measured from the bottom of the tank to the safety limit. There is additional space from the safety limit to the tank opening, designed to accommodate fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked tank capacity.

2

Share

How to Open the Engine Hood of the Mazda3 Axela?

First, pull the engine release handle located on the left side of the driver's seat. Once you hear a "click" sound, move to the front of the car. Below the center of the hood, there is a latch with a lock pin. Flip the lock pin and lift the hood to open it. Below is an introduction to the functions of the engine hood: 1. Airflow guidance. For objects moving at high speed in the air, the air resistance and turbulence caused by airflow around the object can affect both its trajectory and speed. The shape of the engine hood can effectively adjust the direction of airflow relative to the car's movement and reduce the resistance force, minimizing the impact of airflow on the vehicle. 2. Protection for the engine and surrounding components. Under the engine hood lie critical components of the car, including the engine, electrical circuits, fuel lines, braking system, and transmission system, among others. 3. Aesthetics. The design of a vehicle's appearance is a direct reflection of its value. The engine hood, as a crucial part of the overall exterior, plays a significant role. 4. Assisting driving visibility. During driving, the driver's accurate judgment of the road and conditions ahead heavily relies on the reflection of natural light and the forward visibility. 5. Accident prevention. The engine operates in a high-temperature, high-pressure, and flammable environment, where overheating or unexpected component failure can lead to explosions, fires, or leaks. The engine hood effectively blocks potential harm from such explosions, acting as a protective shield. 6. Special-purpose platform. In special-purpose vehicles, the high-strength engine hood can serve as a work platform, providing support.

14

3

Share

What is the range of the Hongqi HS9?

What are the requirements for an A2 driver's license?

Should a Chevrolet Use 92 or 95 Octane Gasoline?

What is the structural principle of run-flat tires for explosion prevention?

What Causes Abnormal Noise When Turning the Steering Wheel?

What is the fuel tank capacity of the Changan CS55?

How to Open the Engine Hood of the Mazda3 Axela?

What is the size of the Jetour X70 spare tire?

What are the reasons why a Tiguan car won't start?

Where is the OBD interface of the X-Trail located?

Is the CT5 equipped with a longitudinal engine?