What is the range of the BYD S2?

Why is the BYD F3 fan not spinning?

When the fan gets damp, the fan's shaft sleeve is prone to oxidation, increasing resistance and causing the fan to stop spinning. After turning off the power, apply some lubricating oil to the shaft to reduce resistance, and the fan should start spinning again. Below are other reasons that may cause the fan to stop spinning: 1. For wear-induced fan blade immobility, the simplest solution is to replace the parts, especially the shaft sleeve, as wear can easily lead to burning out. 2. If the fan stops spinning due to reduced capacitor capacity, you can remove the capacitor and replace it with a new one of the same model. It is recommended to choose a capacitor 20% larger than the original for better spinning performance. 3. If the axial clearance of the shaft is too large, you can disassemble the motor and adjust the shim. However, when reinstalling the motor, ensure the rotor is concentric with the bearing. Tighten the screws diagonally for lubrication and gently tap the shaft with a wooden handle to ensure concentricity. Disassembling the motor is easy, but reassembly is more challenging—take care not to rush, or you may damage the fan. If severe wear is found on the bearing during disassembly, replace it with a new part. 4. If the issue is due to an electrical fault, check all wiring connections, as sometimes wires may be damaged.

9

4

Share

What is the service life of tires?

Tires have a service life of 5 years. Automotive tires ensure good comfort and smooth driving performance, providing excellent adhesion between the tire and road surface. During hot weather, it is crucial to closely monitor the tire pressure to prevent excessive pressure due to high temperatures. In daily driving, it is important to check whether the tire pressure falls within the normal range, as it fluctuates with temperature changes. Tires are circular elastic rubber products mounted on various vehicles or machinery for ground contact and rolling. They often operate under complex and demanding conditions, enduring various deformations, loads, and extreme temperature effects during driving. Therefore, tires must possess high load-bearing capacity, traction performance, and cushioning properties.

4

2

Share

What Causes a Car Wiper to Suddenly Stop Working?

Reasons why a car wiper suddenly stops working are as follows: 1. First, refer to the vehicle manual to determine the model of the wiper being used. 2. Pay attention to whether the connection method between the wiper arm and the wiper linkage is correct. Some arms are screwed onto the linkage, while others are secured with a snap-lock mechanism. 3. Lift the wiper and use your fingers to inspect the rubber after cleaning. Check for any damage to the wiper blade and the elasticity of the rubber and blade. If the blade is aged, hardened, or cracked, the wiper is already damaged. 4. During testing, set the wiper switch to various speed positions and check whether the wiper maintains a consistent speed at different settings. Especially in intermittent mode, observe whether the wiper maintains a steady speed during operation. 5. Examine the wiping performance and check for uneven swinging or missed spots in the wiper linkage.

1

2

Share

How many cylinders does the 2016 Lingpai engine have?

2016 Lingpai is equipped with a 4-cylinder engine. Below are relevant introductions and precautions regarding the 2016 Lingpai engine: 1. The engine is a 4-cylinder naturally aspirated engine with a maximum power of 100KW, maximum torque of 169N-m, maximum horsepower of 136Ps, and maximum power speed of 6500rpm. It is paired with a CVT continuously variable transmission. 2. Avoid coasting in neutral: The engine itself has a fuel cut-off function during deceleration, and coasting in neutral is not conducive to fuel economy. 3. Pay attention to observation when using the vehicle. If oil is found on the ground, determine whether there is an engine oil leakage phenomenon and communicate with the car 4S store in time to eliminate potential safety hazards. 4. For vehicles equipped with turbochargers, do not turn off the engine immediately after high-speed driving or climbing. Let it idle for 10 minutes before shutting down. Vehicles with turbochargers accumulate carbon deposits several times faster than naturally aspirated vehicles. 5. When brake oil is mixed with or absorbs water, or when impurities or sediments are found in the brake oil, it should be replaced or carefully filtered in time. Otherwise, it may cause insufficient braking pressure, affecting braking performance.

17

1

Share

Is an imported car considered a stock car after 1 year?

An imported car is considered a stock car after one year. Here is the relevant introduction about stock cars: 1. A stock car refers to a vehicle that has not been sold for more than 3 months after being manufactured and leaving the factory. Due to import channels, it takes 1-2 months for imported cars to be transported from abroad to domestic markets, so any car unsold for more than half a year is considered a stock car. 2. For parallel imported cars, the time from leaving the foreign factory to arriving in the domestic market varies depending on the location of the foreign factory, such as the USA, Canada, Europe, or the Middle East, with the longest time being 3 months to reach the port. However, if there are delays in customs clearance at the port, the time could be even longer. Therefore, any imported model that has been in stock for more than 6 months since leaving the factory is considered a stock car.

14

1

Share

How often should the first maintenance be done for the Chevrolet Cavalier?

The first maintenance for the Chevrolet Cavalier is required at six months or 5,000 kilometers. Before the first maintenance, the following preparations should be made: 1. It is advisable to call the 4S store for an appointment before going for the first maintenance. Due to the increasing number of vehicles, service workshops in 4S stores are often overcrowded, and without an appointment, you may have to wait for a long time. 2. When going for maintenance, be sure to bring the maintenance manual and the vehicle registration certificate. Although the 4S store will perform the routine (free) maintenance even without the manual, keeping relevant records in the maintenance manual is crucial for future maintenance rights and other matters. 3. Before going for maintenance, carefully recall any faults or questions encountered during normal driving, note them down, and inform the staff during the first maintenance to facilitate their relevant inspections. 4. Generally, maintenance is required every 5,000 kilometers, but some models may require maintenance every 7,500 or 10,000 kilometers. Vehicle maintenance does not necessarily have to be done immediately upon reaching the specified mileage. If the maintenance mileage has not been reached but a long trip is imminent, and the mileage will exceed the limit upon return, you can opt for early maintenance or choose to have the maintenance done at a 4S store in another city.

9

2

Share

What is the range of the BYD S2?

Why is the BYD F3 fan not spinning?

What is the service life of tires?

What Causes a Car Wiper to Suddenly Stop Working?

How many cylinders does the 2016 Lingpai engine have?

Is an imported car considered a stock car after 1 year?

How often should the first maintenance be done for the Chevrolet Cavalier?

What Causes an Automatic Transmission Car to Stall While Driving?

What is the method for adjusting valves in a four-cylinder engine?

How to Start a Car with a Dead Battery?

How to Check a Vehicle's VIN Number?