What is the penalty and point deduction for exceeding the speed limit of 40 by more than 50%?

1 Answers
LunaRose
07/29/25 11:22am
Exceeding the speed limit of 40 by 50% results in a 6-point deduction and a fine of 200 yuan. Penalties vary depending on the road level and speed limit. Below are the relevant penalties for speeding: 1. Exceeding the speed limit by 50%-70%: On roads with a speed limit between 40 and 60, 6 points are deducted, and a fine is imposed; on roads with a speed limit of 80 or above (mainly highways), 12 points are deducted, and a fine is imposed. 2. Exceeding the speed limit by more than 70%: On roads with a speed limit of 60 or above, 12 points are deducted, and a fine is imposed. 3. Exceeding the speed limit by less than 50% but more than 20%: On roads with a speed limit below 40, a warning is issued without point deduction; on roads with a speed limit below 80, a warning or 3-6 points are deducted, and a fine is imposed; on roads with a speed limit of 80 or above, 6 points are deducted, and a fine is imposed. 4. Exceeding the speed limit by 10%-20%: On roads with a speed limit below 60, a warning is issued; on roads with a speed limit of 60 or above, 3 points are deducted, and a fine is imposed.
Was this review help?
17
2
Share
More Forum Discussions

How to Reset the Motorcycle Oil Light?

Haojue motorcycle engine oil light reset method is as follows: 1. There is a round rod below the left side of the steering wheel, with a 'mean' button next to it. Press this button, and the front screen will display a menu. 2. Rotate the round rod to navigate, and after selecting the engine oil option, press and hold the top of the round rod for three seconds to reset the engine oil light. Here is additional information: Haojue Motorcycle is a well-known Chinese brand with many popular domestic products, such as: Zuanbao, Lishuang, Dishuang, Ruishuang EN, Yueguan, GN Prince, Yinbao, KA Tianlongxing, Haiwangxing, Fuxing, Yuexing, Tianying, Tianyu, Xiyun, Yuzuan, Hongbao, etc., as well as the high-performance sports bike GW250 Lichi.
9
1
Share

What kind of car can seat 10 people?

Large Jinbei minivans or Toyota Coaster and other commercial vehicles. The following is a related introduction about minivans: 1. Introduction: In the "Classification of Motor Vehicle Structure Terms", minivans are defined as: flat or short-head body structure, single-layer floor, mid-engine (referring to the layout form where the entire engine block is located between the front and rear axles of the vehicle), aspect ratio (referring to the ratio of the overall vehicle width to height) less than or equal to 0.90, seating capacity less than or equal to 9 people, and passenger cars with installed seats. 2. Advantages: Minivans are inexpensive, come in many varieties, and are economical and practical, making them widely applicable in many industries. In modern society, as an important member of the automobile family, minivans will certainly be promoted and popularized throughout society.
5
3
Share

What are the reasons for the engine warning light in Baojun 530?

Sensor issues, engine misfire, vehicle maintenance problems, fuel quality issues, poor combustion of the air-fuel mixture, engine intake problems, turbocharging issues, exhaust system problems, and anti-theft system malfunctions are all primary reasons for the engine warning light to illuminate. Additionally, during vehicle startup, the system performs a self-check on the engine. Normally, the engine warning light should turn off after the self-check is completed. If it remains on for an extended period, it is advisable to visit a repair station promptly for professional assistance to diagnose and eliminate potential safety hazards. Below is a detailed explanation of each potential issue: Sensor Problems: Sensors include coolant temperature, crankshaft position, air flow, intake temperature, oxygen sensors, etc. When these sensors are damaged, have poor connections, or experience signal interruptions, the vehicle's ECU cannot accurately obtain engine data, leading to the illumination of the engine warning light. Solution: Seek professional inspection and repair at a service center promptly to eliminate safety hazards. Maintenance Issues: Poor engine maintenance is the most common cause of the engine warning light. Vehicles have specific maintenance schedules. Failure to adhere to these schedules, combined with poor driving habits, can increase the engine's operational burden, eventually triggering the engine warning light to alert the owner of a problem. Solution: Follow the maintenance schedule in the vehicle's manual, performing comprehensive maintenance on time or at the recommended mileage to prevent non-maintenance-related issues. Fuel Quality Issues: This refers to both fuel and engine oil. The fuel used in vehicles typically has a specific octane rating, and engine oil can be semi-synthetic or fully synthetic. Manufacturers usually recommend specific fuel grades and oil types. Failure to use the recommended fuel or oil can lead to engine wear over time, causing the warning light to illuminate. Solution: Use the recommended fuel grade and appropriate engine oil for the vehicle. Poor Combustion of Air-Fuel Mixture: Issues such as faulty spark plugs, fuel pump malfunctions, or clogged fuel lines can lead to poor combustion of the air-fuel mixture in the engine. This can result in engine carbon buildup or knocking, which the oxygen sensors detect and report to the ECU, triggering the warning light. Solution: Inspect the engine's ignition coils and spark plugs; check the performance of relevant sensors (e.g., oxygen sensors, coolant temperature sensor, intake temperature sensor, throttle position sensor, air flow meter, intake manifold pressure sensor). Also, inspect the air filter for contamination—clogging can cause a rich air-fuel mixture, requiring cleaning or replacement. Check for fuel injector leaks and the fuel pressure regulator's performance, as malfunctions can also lead to a rich mixture. It is recommended to visit a professional 4S shop for a thorough inspection of related sensors and the engine control unit. Intake Problems: Engine combustion requires proper air intake, where the air filter plays a crucial role. A dirty or uncleaned air filter can affect intake efficiency, potentially leading to blockages over time and, in severe cases, triggering the engine warning light. Solution: Regularly clean or replace the air filter to ensure the intake system operates correctly. Turbocharging Issues: Problems with the intake boost system or turbocharger can also cause the engine warning light to illuminate. The most common issue is turbocharger failure, often accompanied by symptoms like oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Solution: Visit a 4S shop for inspection and replacement of the turbocharger. In most cases, repair is not cost-effective, and replacement is the better option. Exhaust System Issues: Rear oxygen sensors, catalytic converters, exhaust camshafts, and bearings can cause problems. The most frequent issue is catalytic converter failure, which can be triggered by physical damage or fuel system malfunctions. Solution: Use lead- or silicon-based lubricants for catalytic converter maintenance and cleaning. Anti-Theft System: If the vehicle's electronic anti-theft system malfunctions or if the anti-theft controller is incompatible with the engine control unit, the engine may not operate correctly, and the warning light may illuminate. Solution: Visit a professional repair shop for a systematic diagnosis and repair, as this issue typically requires expert intervention.
1
4
Share

Where to Recycle Waste Tires?

Waste tires are generally not accepted by regular facilities, as specialized companies handle them uniformly. Below is relevant information about automotive tires: 1. Overview: Automotive tires are one of the key components of a vehicle, directly contacting the road surface. Together with the vehicle suspension, they help absorb shocks during driving, ensuring good ride comfort and smooth operation. They also maintain strong traction between the wheels and the road, improving the vehicle's acceleration, braking, and off-road capability. Additionally, they bear the vehicle's weight, and their importance is increasingly recognized. 2. Usage Tips: (1) Avoid abrupt starts; whether the vehicle is loaded or unloaded, accelerate smoothly at low speeds to minimize tread wear caused by dragging against the road. (2) On well-paved roads, drive straight ahead. Except when passing or avoiding obstacles, refrain from swerving or making sharp turns to prevent lateral cutting damage between the tire and rim. (3) When descending long slopes, adjust speed appropriately based on gradient, length, and road conditions. On steep, lengthy, or complex terrains, engage gears and use gentle braking to control downhill speed. This not only avoids emergency braking and reduces tire wear but also enhances driving safety.
15
3
Share

How to Repair Leather on Car Dashboard?

Restoration and refurbishment with strength. Below is relevant information about the dashboard: 1. Introduction: The dashboard is the most complex interior component in passenger vehicles, requiring processes from design to installation including creative styling, structural design, model making, and trial assembly of prototypes—each step is indispensable. For instance, regarding styling alone, interior components of the roof may skip styling design and proceed directly to model making, but the dashboard is different: without styling renderings, model making is impossible. Additionally, the dashboard involves various aspects such as ergonomics, material engineering, processing methods, and production processes. 2. Dashboard Classification: Based on installation position, dashboards can be categorized into three types: main dashboard, center console, and overhead dashboard. The main dashboard houses the most indicator lights, gauges, and commonly used control buttons. To facilitate the driver's real-time monitoring of driving conditions, all operational indicators are placed on the main and overhead dashboards. Data requiring constant observation by the driver (such as speed, brake indicators, fault displays, etc.) must be positioned on the main dashboard aligned with the central axis of the driver's seat. Furthermore, the main dashboard also features 2-3 air conditioning vents.
7
0
Share

How much more fuel does using the AC consume?

Overall, the difference in fuel consumption between using the AC and not using it is not very significant, typically around 0.5-1L per 100 kilometers. Below is an introduction to car air conditioning: 1. Introduction to Car Air Conditioning: Car air conditioning consists of a compressor, condenser, throttle element, evaporator, fan, and necessary control components. It is an air conditioning system designed to regulate the temperature and humidity inside the vehicle, providing a comfortable environment for the driver. 2. Working Principle: When the compressor operates, it draws in low-temperature, low-pressure gaseous refrigerant from the evaporator. After compression, the temperature and pressure of the refrigerant increase, and it is sent to the condenser. Inside the condenser, the high-temperature, high-pressure gaseous refrigerant transfers heat to the outside air passing through the condenser, causing it to liquefy into a liquid. The liquid refrigerant then flows through the throttle device, where its temperature and pressure decrease, and it enters the evaporator. Inside the evaporator, the low-temperature, low-pressure liquid refrigerant absorbs heat from the air inside the vehicle passing through the evaporator, causing it to evaporate into a gas. The gas is then drawn back into the compressor to begin the next cycle.
10
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.