What is the original spark plug model for Haval H6?

1 Answers
DiMia
07/29/25 4:33pm
The original spark plug for Haval H6 is the Champion RC8PYCBX single platinum. Spark plugs are installed on the side or top of the engine. In the early days, spark plugs were connected to the distributor via ignition wires, but over the past decade, most car engines have been modified to connect the ignition coil directly to the spark plug. If the spark plug is damaged, it can directly cause problems such as leakage in the vehicle's ignition system, increased fuel consumption, and reduced power. The most significant issue is difficulty in ignition, affecting the normal use of the vehicle. Severe erosion of the spark plug, such as scarring at the top, damage, or melting and erosion of the electrodes, indicates that the spark plug is damaged and should be replaced. Spark plug replacement cycle: Under normal maintenance conditions, replacement is recommended after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine, so it is advisable to follow the user manual. Generally, platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers.
Was this review help?
10
0
Share
More Forum Discussions

What is the size of the spare tire for the Geely Vision X6?

Geely Vision X6 spare tire size is T145/80R18. Below is a detailed introduction to the spare tire of the Geely Vision X6: Full-size spare tire: The size of the original tire and the full-size spare tire are the same, so there are no restrictions on the mileage or speed when driving with the spare tire. Non-full-size spare tire: When replacing with a non-full-size spare tire, it can only be used on non-driving wheels, and the maximum speed of the car is limited to 80 km/h. Since the diameter and width of the non-full-size spare tire are smaller than the other four tires, there are various limitations. It can only serve as a temporary replacement, and the owner should promptly visit the nearest car shop for tire repair after replacement.
19
0
Share

Should New Cars Be Equipped with Tire Pressure Monitoring?

It is necessary to install tire pressure monitoring in cars. The functions of tire pressure monitoring are as follows: Preemptive Safety Protection: Apart from sudden tire blowouts caused by hitting large potholes or sharp objects, other types of blowouts usually show some warning signs. With tire pressure monitoring installed, drivers can monitor tire conditions in real time: TPMS helps drivers easily and accurately grasp tire conditions from inside the vehicle, enabling them to make accurate judgments. This avoids driving with hidden dangers, especially on highways. TPMS directly monitors tire pressure and temperature, promptly alerting the driver when abnormal changes occur, allowing them to take appropriate measures to ensure driving safety. Preventing Damage to Tires and Rims: When a tire is punctured, slow leaks will trigger an immediate alarm, allowing the driver to stop and replace the spare tire in time and find a nearby tire shop for repairs. If a tire has a slow leak (such as from a nail puncture) that might otherwise go unnoticed, tire pressure monitoring can detect the issue early, preventing damage to the tire and rim.
11
1
Share

What is the reason why the four windows of the Santana cannot be raised or lowered?

It may be due to issues with the control module or circuit. Problems with window raising and lowering may occur in the following situations: Damage to the lift mechanism: If there is a burnt smell or abnormal noise inside the door panel when holding down the window button for a long time, it is highly likely that the window lift motor components are damaged. In this case, it is recommended to directly visit a 4S shop or auto repair shop to replace the window lift motor. Motor overheating protection: To protect the power supply circuit, window lift motors generally have an overheating protection mechanism. If the components overheat for some reason, the motor will enter an overheating protection state, causing the window to fail to raise or lower. Excessive resistance in the glass guide channel: The door glass guide channel is a detail that is easily overlooked. During use, dust accumulates in the glass guide channel, increasing resistance, which over time may make it difficult for the glass to rise.
16
4
Share

How long does it take from ordering to delivery for a Bentley Flying Spur?

Bentley Flying Spur typically takes about one to two months from ordering to delivery. Here is relevant information about the Bentley Flying Spur: Powertrain: The new Flying Spur is equipped with a 6.0-liter twin-turbocharged W12 engine, delivering a maximum power output of 635 horsepower and a peak torque of 900 Nm. It is paired with a ZF 8-speed dual-clutch transmission, achieving a 0-100km/h acceleration time of 3.8 seconds. Interior: The exquisitely designed three-spoke multifunction steering wheel is wrapped in genuine leather, offering a full and refined grip. The left, right, and outer spokes feature concave leather surfaces to enhance friction. The shiny chrome rollers on the horizontal spokes and the small hollowed-out chrome decorations at the bottom elevate the visual sophistication. Functionally, it supports electric adjustment for height and reach, and comes with paddle shifters and memory functions.
12
4
Share

Will a faulty turn signal affect the engine of the Teana?

The faulty turn signal of the Teana will not affect the car's engine. When the turn signal malfunctions, the primary focus is on checking the related circuits of the turn signal, inspecting whether the central control box has a fault (likely a BCM setting issue) or if the turn signal circuit is short-circuited. Check the anti-theft alarm unit. Open the rear cover of the unit and follow the two brown wires from the connector to locate the relay along the circuit board. Carefully cut with a blade and sand the contacts with sandpaper. Inspect the relay and find that the alarm unit is responsible for the left flash safety. Remove it and observe whether the left light does not flash during an alarm, or if the alarm, turn signal, and hazard lights have no effect. The turn signal is an important indicator light when the vehicle turns, alerting vehicles and pedestrians in front, behind, left, and right to pay attention. The turn signal bulb uses a xenon tube, controlled by a microcontroller circuit, with continuous left and right flashing operation. The turn signal uses a flasher to achieve light blinking, which can be divided into three types: wire-block, capacitor, and electronic.
4
5
Share

How to Deal with Insufficient Power When Going Uphill in Subject 2?

When facing insufficient power while going uphill in Subject 2, you can increase the vehicle's throttle to compensate for the lack of power. Below is a detailed explanation of how to handle insufficient power when going uphill in Subject 2: 1. Method of coordinating throttle and clutch in Subject 2 exam: Use the vehicle's clutch in conjunction with the brake to control the vehicle's speed, and apply throttle at the appropriate time. Otherwise, the vehicle may experience insufficient power, leading to stalling and resulting in failure of the Subject 2 exam. Especially during the uphill start in Subject 2, it is difficult to complete the test item if the vehicle does not apply throttle. 2. Reason for using the clutch to adjust speed in Subject 2 exam: The clutch can effectively control the vehicle's speed. Generally, the idle speed of driving school training vehicles is set relatively high. Using the throttle to control speed would increase the difficulty of the exam. This is designed to help students better complete the specified subjects.
16
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.