What is the optimal tire pressure for the Tayron?

2 Answers
VanKayden
09/08/25 2:08am
The normal tire pressure range for the Tayron is around 2.3-2.5 bar. According to the international standard GBT2978-2008, the recommended tire pressures for different types of tires are as follows: Standard tires: 2.4-2.5 bar; Reinforced tires: 2.8-2.9 bar; Maximum pressure: should not exceed 3.5 bar. Hazards of overinflated tires: Reduced tire friction and adhesion, affecting braking performance; Causes steering wheel vibration and misalignment, reducing driving comfort; Accelerates wear on the central tread pattern, shortening tire lifespan; Increases vehicle vibration, indirectly affecting the lifespan of other components; Overstretches tire cords, reducing tire elasticity and increasing the load on the vehicle during driving; Decreases puncture resistance. Sharp objects like nails or glass can easily penetrate the tire, leading to internal cracks or blowouts. Hazards of underinflated tires: Increases friction with the road surface, raising fuel consumption; Causes heavy steering and misalignment, compromising driving safety; Increases movement of tire components, leading to abnormal heat generation due to excessive rolling; Weakens cord and rubber functionality, causing delamination, cord breakage, or excessive friction with the rim, damaging the bead area and causing abnormal wear; Multiplies friction with the ground, rapidly increasing tire temperature, softening the tire, and drastically reducing strength. High-speed driving may lead to blowouts; Increases tire deformation, causing sidewall cracks and flexing movements, leading to overheating, rubber aging, cord fatigue, and breakage. It also increases the tire's contact area, accelerating shoulder wear.
Was this review help?
18
2
Share
OHannah
09/19/25 7:49am
When I was driving the Tayron, I read in the manual that the recommended standard tire pressure is between 2.3 and 2.5 bar, usually around 2.4 bar for the front tires and 2.2 bar for the rear tires, but it also depends on the vehicle's load. When the car is empty, adjusting it to 2.4 bar is fine, and it's best to add 0.2 bar when fully loaded. I often check with a tire pressure monitor connected to my phone, and I feel this value provides the smoothest ride, with less tire wear and not too much fuel waste. In winter, higher tire pressure is better for cold starts, while in summer, slightly lower pressure helps avoid blowouts due to high temperatures. Remember to check it monthly with a pump to ensure safety and save money.
Was this review help?
7
1
Share
Expand All
More Forum Discussions

What are the reasons why the BYD G5 won't start?

The reasons why the BYD G5 won't start are as follows: 1. The battery is dead or the fuel tank is empty; 2. The gear is not in the correct position or the steering wheel is locked, preventing startup; 3. Automotive circuit or electronic failure, such as damaged spark plugs, blown fuses, or fuel pump malfunction. 4. Fuel quality issues, where poor-quality fuel causes the engine to malfunction. Additional information: 1. Human operational reasons: dead battery, empty fuel tank, incorrect gear position; 2. Vehicle usage reasons: improper fuel, lack of antifreeze, excessive carbon buildup. A dead battery may result from leaving the headlights on for an extended period or the battery reaching the end of its lifespan. Installing xenon headlights, high-power audio systems, or DVD players can also cause vehicle circuit failures.
3
4
Share

Where is the air conditioning relay located in the Buick Encore?

Buick Encore's air conditioning relay is located in the fuse box: 1. The function of the relay is to control the start and stop of the air conditioning. When the interior temperature reaches the target temperature, the sensor will instruct the relay to stop the air conditioning's cooling operation; 2. When the interior temperature rises above the set temperature, the sensor will instruct the relay to start the air conditioning's cooling operation; 3. In a circuit, a relay is a device commonly used as a switch. Based on the type of control voltage required for its coil, relays can be divided into AC relays and DC relays; 4. The specifications of a relay are indicated by the coil control voltage and contact current. Generally, when the load current is less than 10A, the relay's contacts can be used directly to connect or disconnect the circuit.
7
2
Share

What are the basic requirements for driving specialized motor vehicles within the factory premises?

There are several basic requirements for driving specialized motor vehicles within the factory premises: 1. Introduction: Operators of factory motor vehicles are classified as special operation personnel, and their qualification assessment and certification are organized by safety administrative departments at the municipal level or above. 2. Physical requirements: Drivers must be in good health, pass training and examinations, and hold a valid license to drive. 3. No lending of credentials: Driving licenses should not be lent to others, and drivers should not operate vehicles that do not match the specifications of their license. 4. Driving requirements: Drivers must comply with traffic rules and operational procedures, inspect the vehicle's condition before driving, and promptly address any potential hazards; otherwise, the vehicle should not be driven. Drivers must strictly adhere to safety protocols, maintain equipment in good condition, and ensure safe driving.
1
3
Share

Is It Necessary to Use a Car Cover?

It is necessary to buy a car cover for your vehicle. In summer, it can provide sun protection, preventing direct sunlight from damaging the car paint and interior, thereby delaying the aging of both. Below are specific details about car covers: 1. Function: The primary purpose of a car cover is to protect the car paint and windows from direct sunlight exposure. It can also shield the car from rain, snow, and falling leaves, while serving a cleaning function. 2. Usage Notes: When using a car cover, it is best to apply it after the car has been parked, cooled down, and washed. The cover should be the right size for your car to be effective. It is important to note that if the car cover gets dirty, it must be washed before the next use; otherwise, it may have the opposite effect, allowing dirt to stick to the car continuously.
7
3
Share

Where is the trunk switch located on the all-new Bora?

The trunk switch of the all-new Bora is located below the driver's door armrest, above the door storage compartment, with a trunk capacity of 490L and 506L. Method to open the trunk: gently lift the trunk button to open it. If the button fails, you can also use the key to unlock it directly. Some models have a trunk unlock switch on the key, which can be pressed directly to open. The all-new Bora is built on Volkswagen's MQB A1 platform and is the first China-exclusive model on this platform. It adopts Volkswagen's new family-style design, featuring an integrated front face design and raised waistline. The wheelbase of the all-new Bora has been increased by 74 mm, reaching 2688 mm, and the body dimensions are 4663 mm in length, 1815 mm in width, and 1462 mm in height.
12
1
Share

Does BYD still offer battery warranty after vehicle transfer?

Second-hand BYD vehicles' batteries are eligible for the lifetime warranty. However, the battery will not be covered under the lifetime warranty policy if it sustains abnormal damage, which refers to damage caused by human factors. The battery mainly consists of the casing, power management system, cooling system, and battery cells. The primary function of the battery is to store energy. However, the power management system, cooling system, and casing are also crucial. Without these systems, the battery cannot function properly. Within the six-year warranty period, BYD will replace all the aforementioned components free of charge. Over prolonged use, the battery's capacity will gradually decrease as the number of charge and discharge cycles increases. Given the high cost of replacing new energy vehicle batteries, the ability to replace the battery for free is particularly important. To meet consumer demands, BYD offers a lifetime battery warranty policy. BYD's warranty policy is exceptionally favorable, and when the power battery's capacity degrades by 20%, it can generally qualify for a free replacement.
7
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.