What is the number of the fuel pump relay for Chery Flagcloud?

2 Answers
JuniperRose
07/29/25 5:49am
The fuel pump relay for Chery Flagcloud is located in position No. 2, inside the drainage channel in the engine compartment, next to the engine control unit. Exterior design: The side body design of the Chery Flagcloud differs from the traditional inward-tilting style, featuring a vertical design instead. The vertical design provides a larger effective interior space, with smooth body curves and a naturally transitioning high waistline. The rear design is more conventional, with a slightly protruding tail complemented by an embedded inverted trapezoidal license plate frame and integrated combination taillights, giving the rear a strong sense of dynamism. Interior design: The dashboard of the Chery Flagcloud is designed simply, primarily in light gray, with many elements borrowed from other Chery models. The steering wheel has a novel and fashionable shape with moderate thickness, and the hemispherical instrument panel offers a larger display interface for clearer driving data.
Was this review help?
14
2
Share
OVanessa
08/12/25 9:21am
The fuel pump relay for the Chery Fulwin is usually the No. 7 relay, located in the third position from the left in the fuse box under the hood. I've been driving this car for over a decade and have often encountered starting issues due to relay failures. I've replaced it myself several times. The key is to first confirm the model year, as the position may vary slightly between the 2010 and 2015 models. It's best to check the fuse diagram on page 25 of the owner's manual. If you don't have the manual, use a diagnostic tool at a reputable shop. A faulty relay can cause the car to stall at low speeds, which is quite dangerous. Regularly inspect and clean the fuse box to prevent rust and extend its lifespan, avoiding the hassle of roadside breakdowns and needing a tow truck.
Was this review help?
20
1
Share
Expand All
More Forum Discussions

How to Check the Engine Oil Level of Huasong 7

Pull the oil dipstick out of the dipstick tube; wipe the oil dipstick clean; insert the oil dipstick back into the tube until it reaches the stop position, then remove it; the oil level should be between the lower and upper marks. This can be done using the multifunction buttons on the left side of the steering wheel. Turn on the ignition switch. Repeatedly press the system selection button, which is the left and right buttons. The vehicle should be parked on level ground; if the engine is at normal operating temperature, turn it off for at least 5 minutes.
19
1
Share

Is it acceptable to not move the steering wheel while driving straight?

It is acceptable to not move the steering wheel while driving straight. Here is relevant information: 1. Throttle control: Flexible throttle control is required during straight-line driving to avoid sudden speed changes that may affect normal operation. Inconsistent speed control may also cause steering deviation. 2. Posture adjustment: Incorrect sitting posture may affect visual judgment. For trainees with poor vehicle sensitivity, deviation is likely to occur. During straight-line driving, it's necessary to look farther ahead - from the road center in front of the cab to the distant view - and make timely adjustments when detecting vehicle deviation.
4
2
Share

How to Replace the Battery in a Ford Fiesta Key?

The car owner needs to prepare the replacement battery in advance. When purchasing the battery, make sure to buy the same model as the original battery. Then, pop out the mechanical key, locate the fastener on the key casing, and remove the outer shell of the key. After opening the key casing, remove the old coin cell battery and replace it with a new one that meets the specifications. When installing the new battery, pay attention to the positive and negative poles. Do not reverse the battery's polarity, otherwise the key will not function even after replacement.
3
0
Share

How to reset the maintenance light on the Zotye Seek 5?

With the engine turned off, press and hold the trip odometer reset button located below the tachometer; Turn the ignition switch to the ON position, then release the trip odometer reset button. The display will show the "SERVICE" indicator; Pull out the minute button on the clock and turn it to the right. The odometer reading will appear on the display; Turn off the engine to reset the reminder message; Turn the ignition switch to the ON position again, and the "SERVICE" indicator will disappear.
8
0
Share

How to Perform Vehicle Inspection on 12123?

Open the Traffic Management 12123 App, click on 'More', and select 'Apply for Inspection Exemption Mark'. Navigate to your vehicle, then click 'Expand More'. Before applying for the inspection mark, you need to handle any outstanding traffic violations for the vehicle. Click 'Continue to Process', confirm the information, and then click 'Next'. Upload the compulsory traffic insurance certificate and the vehicle and vessel tax photos, click 'Next', enter the verification code, and then submit the application. Once the application is successfully submitted, click 'View Progress' to check the online processing status in real-time. Users can take a screenshot to save for offline use.
10
3
Share

What to Do About Abnormal Noise in Ford Kuga's Steering Gear?

Vehicle steering wheel abnormal noise should be determined based on the specific location from which the sound originates. If the sound occurs only after activating the turn signal and then turning the steering wheel, it is likely the sound from the return spring of the turn signal auto-return mechanism. Whether stationary or moving, if turning the steering wheel produces sound coming from below the steering wheel, the steering column dust cover should be inspected. If the sound seems to come from below the steering wheel when turning it, it may be due to the universal joint in the steering column.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.