Browse

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Pet Supplies Sporting Goods Ticket Toys Games Transportation Others

Used Cars New Cars Others

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

What is the normal value of the Wuling Hongguang water temperature gauge?

1 Answers

MacJasmine

07/29/25 3:29pm

Wuling Hongguang water temperature gauge 90 degrees is normal. Extended information is as follows: 1. Introduction: The inside of the car water temperature sensor is the car water temperature sensor. The lower the temperature, the greater the resistance; conversely, the smaller the resistance. It is installed on the water jacket of the engine block or cylinder head and is in direct contact with the cooling water, thereby measuring the temperature of the engine cooling water. 2. Principle: The electronic control unit measures the temperature of the engine cooling water based on this change. The lower the temperature, the greater the resistance; conversely, the smaller the resistance. The electronic control unit measures the temperature of the engine cooling water based on this change, which serves as a correction signal for fuel injection and ignition timing. Simply put, the engine water temperature can be used to understand the operating state of the car, whether it is stopped or moving, or how long it has been moving, etc.

Was this review help?

9

2

Share

More Forum Discussions

What Causes the Mercedes-Benz AC to Not Cool When Turned On?

Insufficient refrigerant, leaks in the pipeline, or a damaged refrigerant pressure sensor can all cause the Mercedes-Benz AC to not cool when the AC is turned on. The specific reasons are as follows: 1. Damaged air conditioning flap. Damage to the air conditioning flap is relatively rare. It is located in the middle-lower part of the dashboard. If it is damaged, it can only be replaced, though replacement is very complicated. 2. Dirty condenser. When the condenser is dirty, the AC's heat dissipation becomes poor, leading to reduced cooling efficiency. Therefore, regular cleaning is necessary. 3. Damaged AC compressor, throttle valve, or expansion valve. The AC compressor is not easily damaged, but malfunctions in the throttle valve or expansion valve can cause poor AC performance. Diagnosing this issue is very troublesome and requires a visit to a 4S shop for repair. 4. Aged or loose compressor drive belt. The refrigerant relies on the moving parts driven by the AC compressor. A loose drive belt can cause the compressor to slip, so when the AC is not working properly, the engine belt should be checked.

Should You Use Recirculation or Fresh Air Mode When Turning on the AC?

When turning on the AC, it is generally recommended to use the recirculation mode. Here is a detailed introduction to the car's recirculation and fresh air modes: 1. Fresh Air Mode: This mode draws air from outside the vehicle, directs it to the air conditioning system for heating or cooling, and then blows it out through the vents. The fresh air mode essentially replenishes the cabin with fresh air, improving the air quality inside. It is particularly useful for defrosting in winter or defogging in summer, as the air drawn from outside has higher oxygen content and is drier, making it more effective for these purposes. 2. Recirculation Mode: This mode draws air from inside the vehicle, creating a circulation of air within the cabin. The primary function of the recirculation mode is to effectively block external dust and harmful gases from entering the car. It helps warm up the car faster in winter, cool down more quickly when the AC is on in summer, and can also be used during smoggy conditions. Essentially, the recirculation mode maintains the cabin temperature more efficiently by circulating the existing air inside the car.

What is the normal power generation output of a car alternator?

The normal power generation output of a car alternator is 13.5V-14.5V. Here is some relevant information about alternators: 1. Classification of alternators: Automotive alternators can be divided into DC generators and AC alternators. Since AC alternators outperform DC generators in many aspects, DC generators have been phased out. 2. Symptoms of alternator failure: Dimming of headlights or dashboard lights; Damage to the battery or accumulator. If the battery is undercharged or dead, the vehicle will continue to run, but after a short time, the lights will dim again, indicating an issue with the charging system; The car alternator belt, if it does not rotate freely, excessive friction will cause the belt to heat up, producing a burning rubber smell. If you detect a smell similar to an electrical fire, this may indicate that the alternator pulley is slipping on the belt, resulting in poor alternator output.

Can I make a U-turn at the highway toll station entrance?

U-turns are not allowed in front of highway toll stations. Not only is making a U-turn prohibited on the main lanes of highways, but it is also strictly forbidden on ramps and within the toll station plaza. Making a U-turn at any section of the highway will result in a 12-point penalty. Below is relevant information about U-turns on highways: 1. For moving vehicles: Vehicles driving normally are unlikely to anticipate a car reversing, which can lead to rear-end collisions or even chain-reaction accidents. 2. Traffic regulations: Highways are designed for one-way traffic only. 3. Precautions: Making a U-turn disrupts the normal flow of traffic, endangers highway driving order, and occupies other lanes. It is advisable to plan your route in advance, memorize highway exits and junctions, and pay attention to highway signage. 4. Correct procedure: If you realize you've taken the wrong route, you should continue to the next exit to leave the highway and then return, rather than reversing or driving against traffic.

How often should the spark plugs of Nissan Tiida be replaced?

Nissan Tiida spark plugs should be replaced every 100,000 kilometers. However, the replacement interval can be adjusted flexibly based on different driving habits and road conditions. For those who frequently drive in congested urban traffic, replacement can be considered at 50,000 to 60,000 kilometers. For those who often drive on highways or in suburban areas, it is recommended to replace them at 80,000 to 100,000 kilometers. Spark plugs are a crucial component of a gasoline engine's ignition system, responsible for introducing high voltage electricity into the combustion chamber and generating sparks by jumping the electrode gap, thereby igniting the combustible mixture in the cylinder. The Nissan Tiida is a vehicle produced by Dongfeng Nissan Passenger Vehicle Company, with body dimensions of 4250mm in length, 1695mm in width, and 1535mm in height. In terms of exterior design, the car features more curved lines, giving it a rounder and more stylish appearance. The triangular headlights and front grille lend the Tiida a somewhat aggressive front face, while the wavy waistline on the side adds tension and dynamism.

Should You Shift Gear or Release the Handbrake First in a Manual Car?

In a manual transmission car, you should shift into gear first and then release the handbrake. Here are some related tips for starting the car: 1. Precautions for starting: Get in the car, fasten your seatbelt, and adjust the seat. Quickly press the clutch pedal all the way down and shift into first gear. Turn on the left turn signal, check the surroundings (both side mirrors), and release the handbrake. Quickly lift the clutch pedal to the semi-engaged position and pause slightly, then slowly release the clutch while gently pressing the accelerator pedal to ensure a smooth start. 2. Driving precautions: Avoid keeping the clutch in the semi-engaged state for extended periods. Some drivers have the habit of keeping their left foot on the clutch pedal while driving, thinking it provides better control over the vehicle. However, this practice can cause significant damage to the clutch plate. Especially when driving at high speeds, prolonged semi-engagement can lead to rapid wear of the clutch plate.

Trending Ranking

Do I pay the vehicle purchase tax myself when buying a car at a 4S store?

Can You Continue Driving If the Car's Temperature Gauge Doesn't Move?

What are the reasons for no sound when connected to the car's Bluetooth?

When will the China IV standard for diesel engines be implemented?

When Will Shanghai Implement China VI Emission Standards?

What are the differences between Volkswagen Lavida and Bora?

Why Does the Car Fuel Tank Generate Gas?

What does driving mode switching mean?

What does the one-button start in a car mean?

How Long After Jump-Starting Can You Turn Off the Engine?

More Forum Discussions

What is the percentage of passing all driving tests on the first attempt?

Which cars do not use asphalt damping sheets?

How Fast Are Go-Karts?

What does the boss button mean?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.