···
Log in / Register

What is the normal tire pressure for the Haval F7?

4 Answers
SerenityFitz
08/30/25 3:58am
The normal tire pressure range for the Haval F7 is 2.4-2.5 bar. Due to seasonal factors, the tire pressure can be appropriately increased by 0.2 bar in winter and decreased by 0.1 bar in summer. The Great Wall Haval F7 is equipped with a tire pressure monitoring system that can monitor tire pressure and temperature in real-time and immediately alert the driver when abnormalities are detected, suggesting effective measures to prevent safety accidents. The tire pressure can be viewed directly on the dashboard. If the tire pressure monitoring indicator light comes on (a yellow symbol, an irregular circle with no seal on top and four small spikes at the bottom, containing an exclamation mark), there are generally three possible reasons: Abnormal tire pressure. Typically, an alert is triggered if the pressure is below 1.8 bar or above 3.0 bar. In this case, the tires should be checked and the pressure adjusted. The tire pressure monitoring system has not been reset. After inflating the tires, if the tire pressure is not reset promptly, the system may still record the previous data, causing the indicator light to come on. Simply reset the tire pressure to resolve this issue. Damaged tire pressure sensor. The tire pressure sensor, which monitors tire pressure, is installed inside the tire and connected to the tire inflation valve. If the sensor is damaged due to impact while driving, the tire pressure fault light will also come on. In case of sensor damage, the only solution is to replace it with a new part.
Was this review help?
13
2
Share
MiguelLynn
09/11/25 8:01am
I've driven quite a few cars and know that tire pressure is not something to be taken lightly. The normal tire pressure for a Haval F7 typically ranges between 2.3 to 2.5 bar, which is equivalent to 33 to 36 psi, with the exact values marked on the door frame or in the user manual. This is based on the vehicle's design weight and tire type, with SUVs like the F7 having slightly higher tire pressure to adapt to various road conditions. Too low tire pressure can accelerate tire wear, increase fuel consumption, and even raise the risk of a blowout; too high, and the ride becomes bumpy, affecting handling comfort. It's recommended to check the tire pressure with a gauge once a month, especially adjusting it during seasonal changes—slightly higher by 0.1 bar in winter for stability and slightly lower in summer to avoid overheating. Remember to measure when the tires are cold, meaning after the car has been parked for several hours. Developing this habit can significantly extend tire life and save on fuel and costs.
Was this review help?
1
2
Share
Expand All
Pearl
10/26/25 2:04am
I've been driving the F7 for almost two years now, and tire pressure settings are something I pay close attention to. The standard value is around 2.3 bar, with little difference between front and rear wheels. Based on my experience, 2.2 to 2.4 bar feels most comfortable when unloaded, while increasing to 2.5 bar is better when fully loaded or carrying heavy items on long trips. Once I got lazy and didn't check, the pressure dropped to 2.0 bar, and I felt the steering wheel shaking on the highway. Fortunately, I noticed it in time and went to a repair shop to inflate the tires. I recommend buying a digital tire pressure gauge to keep in the car—just plug it into the tire valve for an instant reading, simple and practical. Don't wait for the dashboard warning light; it sometimes has a delay. Tire pressure also relates to road conditions: slightly lower pressure provides better shock absorption on city roads, while higher pressure helps resist punctures on rural roads. Overall, keeping it within the recommended range makes driving more stable and safer.
Was this review help?
10
3
Share
Expand All
StSimon
12/09/25 2:24am
Tire pressure is crucial for safe driving, especially in SUVs like the F7. Under normal conditions, it should be maintained between 2.2 and 2.5 bar. If it's too low, the tires can deform and overheat, increasing the risk of a blowout; if it's too high, the tread's grip decreases, making the vehicle more prone to skidding on wet roads. I recommend referring to the label inside the car or the manual, rather than relying solely on experience. If you don't have tools, the self-service air pumps at gas stations often offer free pressure checks. Proper tire pressure also protects the suspension system, preventing abnormal wear and tear on the vehicle, and can save about 10% on fuel. In short, don't overlook this small detail—a quick check before each trip can prevent major issues.
Was this review help?
9
2
Share
Expand All
More Forum Discussions

Which brand of tires is best for Volkswagen Tiguan?

For Volkswagen Tiguan, it is recommended to replace the tires with Michelin tires or tires from well-known brands. Below is an introduction to relevant information about car tires: Functions of tires: Support the entire weight of the vehicle, bear the load of the car, transmit traction and braking torque, ensure the adhesion between the wheels and the road; reduce and absorb the vibrations and impacts during driving, prevent severe vibrations and early damage to car components, adapt to the high-speed performance of the vehicle and reduce driving noise, ensuring driving safety, handling stability, comfort, and fuel economy. Precautions for tire use: Increase awareness of tire safety, inspect tires frequently, and conduct thorough and detailed checks before driving on highways; in addition to tire pressure, observe whether there are cracks on the tire sidewalls and the wear condition of the tread, and eliminate potential hazards promptly; regularly correct wheel balance if it exceeds the standard.
17
5
Share

Which transmission is used in the Toyota Corolla?

The Corolla uses a 4AT transmission. The functions and working principles of the transmission are as follows: Functions of the transmission: Change the transmission ratio to expand the range of torque and speed variation of the drive wheels; enable the vehicle to reverse while maintaining the same engine rotation direction; it is a mechanism used to alter the speed and torque from the engine, capable of fixing or changing the transmission ratio between the output and input shafts in steps. Working principle of the transmission: Speed and torque variation are achieved through hydraulic transmission and gear combination. The torque converter is located at the front end of the hydraulic automatic transmission and is mounted on the engine's flywheel. Its function is similar to the clutch in a car, and it can automatically and continuously change the transmission ratio and torque ratio within a certain range according to changes in the vehicle's driving resistance, providing a certain degree of speed reduction and torque increase.
3
2
Share

Where is the transmission oil filler port located on the Changan Oushang A800?

Changan Oushang A800's transmission oil filler port is located on the left side of the transmission tail, while the drain port is situated on the oil pan at the bottom of the transmission. Below is an introduction to related information about transmission oil: Color of transmission oil: Automatic transmission oil comes in various colors, with the most common being a light red translucent liquid. Other colors include green, yellow, blue, kiwi, and blue. Users should select the appropriate ATF oil as required by the car manufacturer. The different colors are also intended to prevent users from mixing different types. Transmission oil replacement interval: If the transmission can consistently maintain an operating temperature of 80 degrees Celsius while driving, the transmission oil's lifespan can reach 150,000 kilometers. However, if the temperature rises higher, the service life of the transmission oil will decrease. It is generally recommended to replace the transmission oil every 80,000 kilometers.
17
0
Share

Does Windshield Washer Fluid Damage Car Paint?

High-quality windshield washer fluid does not damage car paint, but inferior quality fluid can cause harm. The effects of high-quality and inferior-quality windshield washer fluids on car paint are as follows: High-quality windshield washer fluid: Premium windshield washer fluid does not corrode car paint. It is made from deionized water with various environmentally friendly additives, providing functions such as dirt removal, antifreeze, anti-static, and anti-corrosion. Some higher-quality fluids also offer features like rapid snow and ice melting, anti-glare, and anti-fog properties, significantly enhancing driving safety. Inferior-quality windshield washer fluid: In contrast, inferior-quality windshield washer fluid is often diluted with water and alcohol, which can not only reduce the gloss of car paint and the hardness of rubber seals but also cause color differences, swelling, or dissolution in rubber or plastic parts in severe cases.
1
2
Share

How to Remove the Golf Air Filter?

Method for removing the Golf air conditioning filter: Open the engine compartment hood. The air conditioning filter is located inside the air filter box at the front of the engine. Use a screwdriver to loosen the screws on the edge, lift the cover, and then remove the upper cover plate to take out the air filter. Below is an introduction to the functions of the air conditioning filter: 1. It can absorb moisture, soot, ozone, odors, carbon oxides, SO2, CO2, etc., from the air. 2. It has strong and lasting moisture absorption capabilities, preventing the car windows from fogging up, ensuring clear visibility for drivers and passengers, and enhancing driving safety. 3. It provides fresh air to the cabin, preventing occupants from inhaling harmful gases and ensuring driving safety. 4. It effectively sterilizes and deodorizes, maintaining clean cabin air and preventing bacterial growth, thus creating a healthy environment. 5. It effectively separates solid impurities such as dust, powder, and grinding particles from the air.
20
1
Share

Why does Volkswagen have only one reverse light on?

Volkswagen vehicles have only one reverse light illuminated because a single light makes it easier for drivers to identify. Below are the reasons for having only one reverse light and an introduction to the installation position of reverse lights: Reasons for having only one reverse light: Since 2001, China's traffic laws have been revised to require each vehicle to be equipped with at least one fog light and one reverse light. Vehicles under 6 meters in length are mandated to have one reverse light installed, with the other being optional. In practice, a single illuminated reverse light is more noticeable to drivers. Symmetrical lighting on both sides might cause drivers to become desensitized, potentially mistaking the vehicle ahead for one driving in the wrong direction. A single light is easier to recognize. Installation position of reverse lights: The position of reverse lights is also regulated by national standards. Reverse lights are generally installed on the right side of the vehicle's rear. Since China follows left-hand drive, placing the reverse light on the right side allows drivers to conveniently reverse and park on the right side of the road at night. This arrangement not only complies with national regulations but also reduces production costs.
7
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.