What is the normal tire pressure for a Jetta car?

Can the front seat belts of the Kia Stonic be adjusted for height?

The front seat belts of the Kia Stonic can be adjusted for height. By moving the adjuster up and down, the seat belt can be adapted to drivers of different heights. Introduction to the seat belt height adjuster: The seat belt height adjuster is a component of the car's seat belt system, primarily made up of materials such as guide rails and sliders. It features a height adjustment mechanism paired with a suspension ring assembly. The seat belt height adjuster is a vehicle safety accessory with a relatively simple structure, designed to adjust the height of the seat belt. It generally consists of components such as guide rails, sliders, and decorative covers. The assembly is paired with a suspension ring component to adjust the height settings. Location of the height adjuster: Seat belts designed with a height adjuster can have their height adjusted. The adjuster is located on the decorative panel of the center pillar, which is also where the upper part of the seat belt retracts.

11

0

Share

What Causes Poor Acceleration in Small Cars?

The reasons for poor acceleration in small cars are as follows: 1. Dirty air filter: The air filter is designed to protect the engine and reduce wear. It is generally replaced every 10,000 kilometers. If not replaced in time, insufficient air intake can cause low idle speed, leading to engine shaking. Simply replacing the filter element can solve the problem. 2. High-voltage line break: A high-voltage line break refers to the breakage of the wire core in the high-voltage line, which can affect ignition and cause engine shaking. Use a multimeter to measure the resistance and replace the one with significantly higher resistance. 3. Spark plug lifespan: Spark plugs have a limited lifespan. After 30,000 to 40,000 kilometers, their ignition efficiency noticeably decreases, which can affect ignition. This is the most common issue, and replacing all the spark plugs can resolve it.

9

3

Share

What does the P0700 fault code mean?

P0700 indicates that the transmission has requested the malfunction indicator lamp to illuminate. This fault code simply informs that there is a malfunction in the transmission and the fault light is on. If it persists and is accompanied by transmission shudder, it is necessary to analyze the data stream, which is usually caused by a transmission sensor. Below is the relevant information: 1. Malfunction Indicator Lamp: The Malfunction Indicator Lamp (MIL), also known as the Check Engine Light, is designed to illuminate a yellow or red engine symbol on the dashboard when the control module detects a fault. This fault code indicates that the powertrain system (ECU) has received a request from the transmission control system (TCU) to illuminate the malfunction indicator lamp. 2. Precautions: After troubleshooting the vehicle, it is generally necessary to clear the fault codes. When clearing fault codes, it is essential to follow the specific method prescribed for the corresponding vehicle model. Under no circumstances should the negative battery cable be disconnected solely to clear the fault codes.

10

2

Share

What Type of Oil is Used in Turbocharged Engines?

Fully synthetic oil is currently the most suitable oil for turbocharged engines. The following are the functions of engine oil: 1. Lubrication: There is rapid relative sliding between the piston and cylinder, as well as between the main shaft and bearing shells. To prevent excessive wear of parts, an oil film needs to be established between the two sliding surfaces. A sufficiently thick oil film separates the surfaces of the relatively sliding parts, thereby achieving the goal of reducing wear. 2. Auxiliary Cooling: Engine oil has a relatively low specific heat value and, being inside the engine, does not inherently have a cooling effect. However, during engine operation, the heat energy generated by fuel combustion can be carried back to the oil tank by the oil and then dissipated into the air, assisting the radiator in cooling the engine. The actual cooling effect is provided by the water (or antifreeze liquid) outside the engine casing. 3. Cleaning: High-quality engine oil can carry carbon deposits, sludge, and worn metal particles from engine parts back to the oil tank through circulation. The flow of the lubricating oil washes away the dirt generated on the working surfaces of the parts.

9

5

Share

Why does the car fan keep running?

If you notice the radiator fan running immediately after turning off the engine, you can wait for a while. This is because the water temperature in the radiator decreases slowly, and the cooling fan may continue to operate for some time before stopping when the engine is just turned off and the water temperature hasn't dropped yet. However, if the fan keeps running even after the car has completely cooled down, it might indicate a fault in the cooling fan assembly or its wiring. More information about the car's electric fan is as follows: 1. Working principle: The car's electric fan is controlled by a thermostat. When the water temperature rises to the upper limit, the thermostat activates the power supply, and the fan starts working. Once the water temperature drops to the lower limit, the thermostat cuts off the power, and the fan stops. 2. Working requirements: The electric fan motor draws a high current during operation, which demands higher specifications for the wiring used.

2

4

Share

What is the wheelbase of the Civic?

The dimensions of the tenth-generation Civic are 4649mm in length, 1800mm in width, and 1416mm in height, with a wheelbase of 2700mm. Introduction to Wheelbase: Wheelbase is the distance between the centers of the front and rear axles of a vehicle, measured along the longitudinal symmetry plane. Simply put, it is the distance from the center of the front axle to the center of the rear axle. Classification of Wheelbase: Wheelbase in locomotives or other vehicles can be divided into rigid wheelbase and total wheelbase. Total wheelbase refers to the distance from the foremost axle to the rearmost axle, which is a key parameter affecting the "turntable length" of a train. Rigid wheelbase, on the other hand, is the distance between the foremost and rearmost axles that remain parallel during operation. If the rigid wheelbase is too long, it increases pressure on the tracks during turns and may even lead to derailment.

18

2

Share

What is the normal tire pressure for a Jetta car?

Can the front seat belts of the Kia Stonic be adjusted for height?

What Causes Poor Acceleration in Small Cars?

What does the P0700 fault code mean?

What Type of Oil is Used in Turbocharged Engines?

Why does the car fan keep running?

What is the wheelbase of the Civic?

Is there a place to store glasses in the new Sagitar?

Does the Wildlander have bumpers?

Why can't the Volkswagen Lavida's doors be locked from the inside?

Where is the reset button on the Audi A6?