What is the normal temperature of a car radiator?

1 Answers
DiHope
07/30/25 3:59am
Engine temperature gauges use either physical or virtual dial pointers for display, while a few vehicles lack a dashboard and only show a warning indicator when the temperature is too high. Whether physical or virtual, temperature gauges typically use a dial range of 60°C to 130°C. The car radiator temperature is considered normal when it hovers around 90°C. Here is additional information: If you notice the temperature is too high and pull over, you should not immediately turn off the engine. There are various reasons for overheating, but each issue usually has only one cause. If you shut down all other functions, the temperature may remain excessively high, damaging the engine. The correct approach is to idle the engine, open the hood, turn on the heater to dissipate heat as quickly as possible, and ensure the car is parked in a shaded area.
Was this review help?
12
2
Share
More Forum Discussions

How to Remove the Seat of the New Passat?

The method to remove the seat of the new Passat: Generally, there is a handle or loop on the upper part of the backrest. Pull it to separate it from the steel plate at the back, then remove it. After that, pull the seat backward, and you will see a protruding part with a screw on it. Remove the screw, and the seat can be taken off. The new Passat has a body length, width, and height of 4933mm, 1836mm, and 1469mm respectively, with a wheelbase of 2871mm. The car is front-wheel drive, equipped with a 1.4T turbocharged engine, paired with a 7-speed dual-clutch transmission. The maximum power of this engine is 110kW, and the maximum torque is 250Nm.
6
3
Share

Can you shift gears without pressing the clutch when the car is not started?

You can shift gears without pressing the clutch when the car is not started. Here is an introduction to car gear shifting: 1. Introduction: It should be referred to as "gear shifting." Gear shifting refers to the transmission, which is used to change the torque and speed of the engine crankshaft. 2. Function: It adapts to the different requirements of driving wheel traction and speed under various driving conditions such as starting, accelerating, driving, and overcoming various road obstacles. 3. Techniques: First, remember the principle of "accelerate before upshifting, decelerate before downshifting." Before upshifting, "rev" the throttle to increase the speed first, and before downshifting, "release" the throttle to decrease the speed first.
11
1
Share

What is the 0-100 km/h acceleration time of the Mercedes-Benz C260?

The 0-100 km/h acceleration time of the Mercedes-Benz C260 is 7.6 seconds, with an engine speed of approximately 2200 rpm. The dimensions of the Mercedes-Benz C260 are 4704mm in length, 1810mm in width, and 1454mm in height, with a wheelbase of 2840mm. The vehicle features a front-engine, rear-wheel-drive layout and employs multi-link independent suspension systems for both front and rear. The Mercedes-Benz C260 is equipped with a 1.5T turbocharged engine paired with a 9-speed automatic transmission. This engine delivers a maximum power output of 135 kW and a peak torque of 280 Nm, incorporating direct fuel injection technology and utilizing an aluminum alloy cylinder head and block.
16
2
Share

What is the car maintenance process?

Car maintenance refers to the preventive work of regularly inspecting, cleaning, replenishing, lubricating, adjusting, or replacing certain parts of the car. Its purpose is to keep the car clean, maintain normal technical conditions, eliminate hidden dangers, prevent failures, slow down the deterioration process, and extend the service life. The car maintenance process is as follows: 1. Replace engine oil, oil filter, air conditioning filter, and air filter; 2. Check whether all fluids meet the standards; 3. Check whether the lights, chassis, and braking system can work normally; 4. Check and tighten the connection between the wheels and hub nuts; 5. Adjust the idle speed and idle mixer pedal clearance; 6. Check the tightness of the engine cylinder head screws.
2
1
Share

Where to Park on a Slope?

When parking on a slope, the front wheels of the car should be positioned just at the front edge of the positioning fine line, and the front bumper should be directly above the designated thick line. Below are detailed instructions for parking on a slope: 1. Concept: Parking on a slope assesses a driver's ability to maneuver a vehicle on an incline, accurately judge the vehicle's position, and correctly use the brake, gear, and clutch to meet the requirements of stopping and starting on an uphill section. 2. Test Requirements: The vehicle must be parked at a fixed location on a slope with a gradient of ≥10% and a length of ≥30 meters. 3. Precautions: It's essential to master the clutch's contact point. When starting, avoid stomping on the clutch pedal. If the engine stalls during startup, the driver must immediately restart the engine and complete the start within 30 seconds.
3
1
Share

How to Find a Listening Device Placed in a Car?

Methods to find a listening device placed in a car: 1. Directly search hidden areas inside the car, such as near the front and rear bumpers, inside the left and right doors, etc.; 2. Wireless devices also require continuous power supply, so you can use a magnetic field signal strength detector to locate them, scanning in a fan-shaped pattern centered around yourself, or use an old FM radio, tuning while speaking to listen for echoes in the radio; 3. Most listening devices are wired and need to be connected to the car's power line to receive power. Therefore, to find a listening device, you can search along the car's power lines, but this requires more professional personnel, as otherwise, you may not know the location of the power lines.
14
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.