What is the model of the Tiggo 3 headlight s1?
3 Answers
Tiggo 3 headlight models are: low beam model H7, high beam model H1. Car headlights, also known as car front lights, car LED daytime running lights. Tiggo 3 headlight replacement method: 1. Unplug the power connector of the bulb. 2. After unplugging the power connector, remove the waterproof cover behind the bulb. 3. Remove the bulb from the reflector. The bulb is usually fixed by a wire clip, and some models of bulbs also have a plastic base. 4. Place the new bulb into the reflector, align it with the fixing position, pinch the wire clips on both sides and push them inward to secure the new bulb in the reflector. 5. Reattach the waterproof cover, plug in the bulb power, and the replacement operation is completed.
I previously helped a friend with headlight issues on their Tiggo 3. The S1 model is relatively uncommon, as Tiggo 3 typically uses H-series bulbs. The low beams are mostly H7 (55W), high beams use H1 (60W), and fog lights take H8 (35W). To confirm the exact model, it's best to open the engine compartment and check the label on the headlight base, or remove the bulb to see the engraving on the metal base. Note that 2014 and 2018 models may use different bulb types - wrong ones won't fit. When helping a neighbor replace bulbs last time, I found the lighting specifications table in Chapter 3 of the factory manual to be most accurate. Remember to wear gloves and avoid touching the bulb glass during installation.
Having researched the lighting configurations of Chery vehicle models. The 'S1' marking on the Tiggo 3 might be a misunderstanding - it actually uses standard halogen bulb models with clear distinctions: H7 for low beam, H1 for high beam, and PY21W for both front and rear turn signals. If upgrading to LED, make sure to select bulbs with matching base types. Last year when my headlight burnt out, field tests showed Philips 12342H7XL lasted six months longer than generic brands. Remember to unplug the connector gently during replacement - just rotate the bulb holder 45 degrees for removal. The whole process takes about 15 minutes, no need for a repair shop.
