What is the model of the Buick Envision fog light bulb?

1 Answers
LaParker
07/30/25 2:03am
The model of the Buick Envision fog light bulb is H3. Below is relevant information about fog lights: 1. The power of the Buick Envision fog light is 55W. Car fog lights are installed at the front and rear of the vehicle, primarily used for road illumination and safety warnings during rainy or foggy weather, improving visibility for the driver and other traffic participants. 2. Fog lights are divided into front fog lights and rear fog lights. Front fog lights are typically bright yellow, while rear fog lights are red. The symbol for the rear fog light differs slightly from that of the front fog light—the front fog light symbol has downward light lines, whereas the rear fog light symbol has parallel lines, usually located on the vehicle's dashboard. Due to their high brightness and strong penetration, fog lights do not scatter light due to fog, making their correct use effective in preventing accidents. In foggy conditions, both front and rear fog lights are usually used together. 3. According to traffic regulations, when visibility is between 100–200 meters, fog lights, low beams, width indicator lights, and tail lights must be turned on, with speed not exceeding 60 km/h and maintaining a distance of more than 100 meters from the vehicle ahead. When visibility is between 50–100 meters, fog lights, low beams, width indicator lights, and tail lights should be turned on, with speed not exceeding 40 km/h and maintaining a distance of more than 50 meters from the vehicle ahead. In good visibility conditions, the use of fog lights is strictly prohibited because the red light from fog lights, unobstructed by fog, rain, or snow, can directly harm human eyes when shone into them.
Was this review help?
12
2
Share
More Forum Discussions

Will spraying 84 disinfectant on the car have any impact?

Spraying diluted 84 disinfectant on a car generally won't significantly affect the vehicle's paint. Below are relevant details about vehicle painting: Reasons: Rainwater typically contains acidity, and acid rain can cause considerable damage to car paint, easily leading to oxidation of the paint surface and loss of gloss. Consequences: The increased humidity after rain can somewhat slow down the drying speed of newly painted surfaces, but the reduced dust levels in the moist air post-rain are beneficial for painting. Precautions: (1) If the car has been recently painted, avoid exposing the newly painted areas to water and dust; (2) It's best not to drive the car out in rainy weather as the fresh paint is still delicate - rainwater contact may leave marks that are difficult to remove, sometimes even through polishing. Parking in a garage overnight is recommended.
17
5
Share

Where is the anti-theft screw of the new BMW X1 located?

BMW X1 anti-theft screws are generally placed under the trunk floor panel, which can be seen by lifting the trunk floor panel. Here is a related introduction to the BMW X1: 1. Power: The new BMW X1 is equipped with 1.5T and 2.0T engines, balancing powerful performance and fuel efficiency. The 1.5T model has a maximum power of 103 kW (140 hp) and a maximum torque of 220 Nm. The 2.0T model has a maximum power of 141 kW (192 hp) and a maximum torque of 280 Nm. 2. Interior: The interior retains the style of the current model, with changes mainly in details, such as the use of a new electronic gear shift lever, further enhancing the luxury feel inside the car. The new BMW X1 comes standard with LED headlights, front sport seats, an electronic gear shift lever, six-color ambient lighting, and a driver-side welcome logo.
18
4
Share

What type of engine oil is used in the Tiguan L?

The Tiguan L uses 5W40 engine oil or 0W40 fully synthetic engine oil. If you wish to change the oil during later maintenance, you can choose from three different types of oil: 5W-30 Castrol fully synthetic, 5W-40 OEM fully synthetic, or 5W-40 OEM mineral oil. The viscosity of engine oil changes with temperature, so special attention must be paid to its performance under both low and high temperatures. For example, in 5W-30, the first number indicates low-temperature fluidity—5W means it can withstand temperatures as low as -30°C. The smaller this number, the better the low-temperature fluidity, ensuring smoother cold starts for the vehicle. The second number represents the oil's kinematic viscosity at 100°C. A higher value means the oil can maintain its viscosity index better at high temperatures, which can also be understood as providing superior lubrication performance under high-temperature conditions. The method for changing the oil in the Tiguan L is as follows: Wait for the engine temperature to cool down, allowing the oil to flow back into the oil pan. Use a wrench to loosen the drain plug and place an oil pan underneath to catch the old oil until it stops flowing. Start the engine and let it run for 30 seconds to allow the oil in the main oil passages to drain out. Use a specialized wrench to remove the oil filter. Apply a thin layer of oil to the gasket of the new oil filter and hand-tighten it clockwise. Add the new oil through the filler cap on the engine valve cover. Typically, fill about three-quarters of a standard oil container. Start the engine and let it run for 5 minutes, checking for any leaks around the drain plug and oil filter. If leaks are found, perform necessary repairs. After stopping the engine, remove the dipstick and check that the oil level is within the standard range.
7
4
Share

Will smoking while driving on the highway be penalized if caught on camera?

Smoking while driving can result in fines and penalty points if caught on camera. Smoking while driving is considered a behavior that hinders safe driving and will be subject to corresponding fines and a deduction of 2 points. Additional information: The following behaviors are prohibited while operating a motor vehicle: driving when the doors or compartments are not properly closed. Hanging or placing items within the front or rear windows of the motor vehicle that obstruct the driver's view. Making or receiving handheld phone calls, watching TV, or other behaviors that hinder safe driving. Turning off the engine or coasting in neutral when going downhill. Throwing items onto the road. Riding a motorcycle with hands off the handlebars or hanging items on the handlebars. Driving continuously for more than 4 hours without stopping to rest or resting for less than 20 minutes. Honking the horn in areas or sections where honking is prohibited.
18
4
Share

Where does the wind noise from the corners of high-speed car windows come from?

High-speed wind noise from car window corners is generated by gaps at the edges of the windows. Additional information: Causes of wind leakage at high speeds: This phenomenon is mainly related to door sealing strips, and secondly, check whether the areas where wiring harnesses pass through have poor sealing; The sound of closing the door may be related to improper adjustment of the door lock and lock post. Improper adjustment of the door lock block position can lead to abnormal door closing sounds or difficulty in opening and closing. Solutions: Solution one: Wind leakage is somewhat related to door sealing strips. You can go to an auto parts market to install additional sealing strips. Solution two: Lower the window glass and press down on the upper right corner of the sealing strip near the door frame, revealing a small hole where the wind enters, causing the wind noise. Roll 3M double-sided tape into pieces the size of xylitol and stuff them into the hole until it is completely filled. This can reduce the wind noise.
11
2
Share

Is it allowed to change lanes over a long solid line on the highway?

No, lane changing is not allowed. Additional information: Lane changing is permitted over dashed lines, but crossing solid white lines to enter the main lane is prohibited. You may only cross the white dashed line ahead to change lanes when it is safe to do so. At some highway exits, there are solid white lines, and you must not cross them to change lanes onto the auxiliary road to exit the highway. You should change lanes at the white dashed line in advance to exit the highway. The function of lane dividing lines: They are traffic markings that separate traffic flows in the same direction, usually consisting of white or yellow dashed or solid lines. White dashed lines separate lanes in the same direction, allowing lane changes or overtaking when safe. White solid lines: Separate lanes in the same direction but do not allow lane changes. Yellow solid lines: Separate traffic moving in opposite directions or sometimes lanes in the same direction, serving as dividing lines or center lines, and do not allow lane changes. Yellow dashed lines: Can serve as dividing lines or center lines, allowing lane changes when used as dividing lines.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.