···
Log in / Register

What is the minimum ground clearance of Honda CR-V?

1 Answers
VanHaven
07/24/25 3:59am
Honda CR-V has a minimum ground clearance of 135mm when fully loaded and 185mm when unloaded. Here are some relevant details: 1. Minimum ground clearance refers to the distance between the lowest point of the car (excluding the wheels) and the road surface when the car is fully loaded. It indicates the car's ability to overcome obstacles (such as rocks). The smaller the ground clearance, the worse the ability to overcome obstacles. 2. The larger the minimum ground clearance, the stronger the vehicle's ability to pass over obstacles or uneven ground, but the higher the center of gravity, which reduces stability; the smaller the minimum ground clearance, the weaker the vehicle's ability to pass over obstacles or uneven ground, but the lower the center of gravity, which can increase stability.
Was this review help?
9
5
Share
More Forum Discussions

Are Jeeps Front-Wheel Drive or Rear-Wheel Drive?

Jeeps are rear-wheel drive vehicles. Jeep is an American automobile brand, owned by the world's second-largest automaker, Daimler-Chrysler Corporation. Models: Jeep's lineup includes the Grand Cherokee, Wrangler, Compass, Cherokee, Renegade, and Commander. Among these, the Compass is an SUV equipped with an on-demand four-wheel-drive system, while the Wrangler is an off-road vehicle featuring a part-time four-wheel-drive system. Positioning: Jeep falls into the mid-range vehicle category in terms of price—neither too low nor excessively high. Driving a Jeep is considered understated, offering strong value for money with excellent handling and stability. However, the models are relatively large, which may make them more selective in terms of the age demographic of drivers.
2
5
Share

What is the solution for slight steering wheel vibration when touched?

The solution for slight steering wheel vibration when touched is: 1. Check whether the front wheel alignment angles and toe-in meet the requirements. If they are out of specification, adjust them. Lift the front axle and test the wheel rotation to check the static balance of the wheels and whether the tires are excessively deformed. If deformed, replace them; 2. Replace the brake discs and brake pads; 3. Send to a professional repair shop for inspection and replace damaged components. The steering wheel is a wheel-shaped device used to control the direction of cars, ships, airplanes, etc. Its function is to convert the force applied by the driver to the edge of the steering wheel into torque and transmit it to the steering shaft. The gear system introduced between the driver and the wheels by the steering wheel operates flexibly, effectively isolating severe vibrations from the road.
7
3
Share

Where is the antifreeze reservoir located on a BMW 525?

The coolant filler cap for the BMW 5 Series is located to the left of a black reservoir on the left side of the engine. How to choose antifreeze: The basic indicators of antifreeze are its freezing point and boiling point. Antifreeze available on the market comes in several specifications with freezing points of -15°C, -25°C, -30°C, -40°C, etc. Generally, it's advisable to choose one with a freezing point at least 10°C lower than the lowest temperature in your region. Methods to determine if antifreeze is low: Check the antifreeze warning light on the dashboard. If it lights up, it's likely due to low antifreeze levels, though it could also be caused by excessively high engine temperatures. Inspect the antifreeze reservoir. If the fluid level is below the minimum mark (MIN), do not continue driving and promptly add antifreeze. Check the fluid level marks on the antifreeze reservoir. The normal antifreeze level should be between the maximum and minimum marks. To determine if antifreeze is low, observe the marks; if the antifreeze is below the minimum mark, it indicates a shortage.
15
2
Share

Does ECU Tuning Affect Engine Lifespan?

ECU tuning will affect the engine's lifespan. After tuning, the engine's power will increase, but its service life will inevitably shorten. ECU tuning improves performance at the cost of sacrificing the engine's reliability, durability, and overall longevity. The factory engine programming is optimally balanced, as it takes into account fuel economy, power output, and reliability/durability. Only turbocharged engines can gain power through ECU tuning; naturally aspirated engines cannot increase power this way. Turbocharged engines can boost power by adjusting turbo pressure and fuel injection volume. Higher turbo pressure allows more air into the combustion chamber, and when combined with increased fuel injection, power output is enhanced.
15
1
Share

Is the first maintenance at 5,000 kilometers or 3,000 kilometers?

For a car's first maintenance, you can service it at 3,000 kilometers, but it must be done by 5,000 kilometers. Details are as follows: Meaning of car maintenance: Car maintenance refers to the preventive work of regularly inspecting, cleaning, supplying, lubricating, adjusting, or replacing certain parts of the car's related components, also known as car upkeep. Currently, car maintenance mainly includes the maintenance scope of the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. Purpose of car maintenance: The goal of car maintenance is to keep the vehicle clean and in normal technical condition, eliminate hidden dangers, prevent faults, slow down the deterioration process, and extend the service life.
8
2
Share

Why Does a Manual Transmission Car Jerk When Accelerating?

Reasons for jerking when accelerating in a manual transmission car: 1. If the throttle and clutch are not properly coordinated during gear shifting, the vehicle may experience noticeable sudden deceleration followed by sudden acceleration, which is a clear jerking sensation and is considered normal; 2. If the jerking sensation is strong during acceleration, pressing the throttle abruptly will cause jerking, and the deeper the throttle is pressed, the stronger the jerking sensation. In this case, the issue lies with the spark plug wires, and replacing them should resolve the problem; 3. Problems in any part of the ignition system, intake system, or fuel system can potentially cause jerking during acceleration. It is recommended to promptly visit a 4S shop or auto repair shop for a professional technician to inspect and diagnose the issue before proceeding with the appropriate repairs.
18
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.