What is the method to reset the service light on the Everest?
4 Answers
The method to reset the service light on the Everest is: 1. Turn on the ignition switch; 2. With the engine off, press and hold the short-distance counter reset button below the tachometer; 3. Turn the ignition switch to the 'on' position, release the short-distance counter reset button, and the 'service' indicator will appear on the display; 4. Press the minute button on the clock, turn the minute button to the right, and the mileage will appear on the display; 5. Turn off the engine, and a reset reminder message will appear, then proceed with the reset. Taking the 2020 Everest as an example, it is a mid-size SUV with body dimensions of: length 4892mm, width 1862mm, height 1837mm, and a wheelbase of 2850mm.
Regarding the maintenance light reset issue for the Everest, I recently helped a friend with a similar problem and found that the reset operation is actually quite simple, but the steps vary by model. Typically, you first turn off the ignition switch and ensure the vehicle is completely shut down. Then, press and hold the reset button on the dashboard, such as the ODO button, without releasing it. Next, turn the ignition switch to the power-on position without starting the engine. At this point, the maintenance light on the dashboard will begin to flash—keep holding the button until the light goes off before releasing it. Finally, turn off the key, and you're done. It's worth noting that some model years may have additional settings. If unsuccessful, it's advisable to refer to the owner's manual or visit a professional shop for adjustments. After all, the light may be reminding you to change the oil or perform other maintenance promptly. Although the vehicle can still be driven without resetting the light, it may mislead the next maintenance schedule. In short, ensure safety before attempting any DIY steps, operate in a shutdown state, and avoid incorrect procedures that could damage the circuit.
I've handled resetting the maintenance light on quite a few vehicles, and the key for the Everest lies in the button sequence. First, turn off the engine and park safely, then locate the small button on the dashboard—usually the trip reset button. Press and hold it, then turn the key to the ON position without starting the engine. When you see the light flash, it means the system is resetting. Keep holding for a few seconds until the light goes off, then release the button and turn off the ignition. In practice, I recommend trying a few times, as insufficient pressure or too short a duration can easily lead to failure. If you can't find the button, don't panic—check the manual or online forums for plenty of tutorials. Resetting this light clears the maintenance record and starts the count for the next oil change cycle. Never ignore its reminder value, as timely maintenance can extend engine life. For complex situations, I recommend taking it directly to a repair shop to avoid causing more trouble by tampering yourself.
I've personally operated the maintenance light reset on the Everest, and the method is quite straightforward: After turning off the engine, hold down the instrument reset button without releasing, turn the key to the power-on position without starting the engine, wait for the light to flash and automatically go off, then release the button and turn off the key. Note that if the light doesn't go off, it might be due to poor contact or a system malfunction, so it's best to first check the fuses and connecting wires. After resetting, it no longer interferes with driving but reminds you to perform routine maintenance, which is crucial for vehicle health. Avoid common mistakes such as forgetting to turn off the lights or operating while driving, and ensure timely reset after each maintenance to maintain accurate records.
