What is the method to reset the maintenance light on the JAC Shuailing T6?

[MadisonMarie]

The method to reset the maintenance light on the JAC Shuailing T6 is: 1. Turn off the ignition switch and simultaneously press and hold the two arrow buttons; 2. Turn on the ignition switch, release the two arrow buttons after 3 seconds, and the maintenance menu will ask if you want to reset; 3. Press and hold the set button for more than 3 seconds, press the mode button, and then turn off the ignition switch to complete the reset. Taking the 2020 JAC Shuailing T6 as an example, it belongs to the pickup truck category, with body dimensions of: length 5315mm, width 1830mm, height 1815mm, wheelbase of 3090mm, and a fuel tank capacity of 75l. The 2020 JAC Shuailing T6 is equipped with a 2.0L naturally aspirated engine, with a maximum horsepower of 144ps, maximum power of 106kw, maximum torque of 200nm, and is paired with a 5-speed manual transmission.

[ClaireMarie]

I found that resetting the maintenance light is actually quite simple. After turning off the engine, hold down the ODO button on the dashboard, then turn the key to the ON position without starting the engine. Wait patiently for about ten seconds, and the light will turn off by itself. The whole process takes no more than a minute, and you'll understand it after trying once. I often do this for my friends' cars to save them the unnecessary expense of going to the dealership. When the maintenance light comes on, it indicates that things like the oil filter and tires need to be checked. Resetting it promptly reminds you of the next maintenance time, otherwise, neglecting it could lead to serious problems, shortening the car's lifespan and increasing fuel consumption. Remember, operating in the engine-off state is the safest, and it's fine to try a few times.

[VanWeston]

As a daily driver, I'm used to a simple procedure: with the engine off, press and hold the ODO button, turn the key to the ON position without starting the engine, hold for about 10 seconds until the light goes off. After starting, just confirm it's gone. This method is super quick, requires no special tools, and is foolproof. The maintenance light reminds you to change oil or get a check-up. After resetting, note the mileage for next service scheduling. Don't overlook it - DIY saves time and hassle.

[Bentley]

From a technical perspective, resetting involves resetting the counter. After turning off the engine, hold the ODO button to enter setup mode, turn the key to ON without starting, and wait for 10 seconds until the light flashes and goes off. Ensure the button is pressed firmly throughout to avoid failure. After the maintenance light is reset, the system starts counting from zero. Remember to check the vehicle regularly to prevent minor issues from escalating.

[LeHazel]

Safety first! The maintenance light reset method is very simple: turn off the engine and hold the ODO button, turn the key to the ON position but do not start the engine, wait for 10 seconds until the light goes off, and you're done. If the reset is not done in time and the light reminder is ignored, it may lead to missing important maintenance, resulting in engine wear or brake failure. It is recommended to record the maintenance date after each DIY operation.