What is the method to reset the maintenance light on the Edge?

[DeEmiliano]

Ford Edge oil maintenance light can be reset by following these steps: 1. First, press the one-touch start button to power on the vehicle, otherwise the maintenance indicator cannot be reset. 2. Then, click the SET button on the left side of the multifunction steering wheel to enter the menu settings. 3. Next, press the - button on the right side of the multifunction steering wheel to clear the items displayed on the dashboard. 4. Click the OK button on the left side of the multifunction steering wheel to confirm the operation. 5. Observe the LCD dashboard to see that the maintenance light has been reset.

[CooperDella]

As a seasoned driver with ten years of experience behind the wheel of a Ford Edge, I've mastered the maintenance light reset procedure. First, turn off the engine and make sure the vehicle is stationary. Then locate the OK button in front of the steering wheel and press and hold it firmly. Next, turn the ignition key to the ACC position (where the dashboard lights up but the engine doesn't start). Wait patiently for about ten seconds until you see the maintenance light blink and go off, then release the button. The first attempt might not succeed—I had to try several times before getting it right, so don't get frustrated. Remember to reset it regularly, as the maintenance light serves as a reminder for timely oil changes and inspections. Neglecting this could lead to minor issues and compromise safety. Also, button locations may vary in newer models, so I always recommend checking the owner's manual to confirm—it's a good habit to develop.

[LeHector]

This is a common task in repair shops, and resetting the maintenance light on the Edge is straightforward and efficient. Here are the steps: Turn off the engine, hold down the OK button, then turn the key to the ACC position, hold for eight seconds until the light goes off, and release. Stay calm and follow the sequence carefully—failure may occur if the key isn’t turned to the correct position. After resetting, the system will remember the reset to ensure accurate reminders. If the light doesn’t respond, check the manual or visit a professional shop first—don’t tamper blindly and risk damaging the wiring. Resetting the maintenance light is crucial for monitoring your vehicle’s condition, as it helps detect potential issues early, extends the car’s lifespan, and ensures peace of mind while driving.

[ZaneFitz]

When I was in my twenties learning to drive, I picked up this trick. Resetting the Edge's maintenance light is quite simple: After turning off the car, hold down the OK button. Then turn the key to the ACC position, keep holding the button, and wait for about ten seconds until the light goes off. Try it a few times and you'll get the hang of it—Ford designed it to be user-friendly, so even beginners can quickly master it. After the operation, remember to check the light status to avoid it flashing again at the next startup. Timely reset helps prevent distracted driving and ensures a safe journey.