What is the method to reset the maintenance light on the 2019 Lavida Plus?
2 Answers
The method to reset the maintenance light on the 2019 Lavida Plus is as follows: 1. Put the gear in P position, pull up the handbrake, do not step on the brake, and press the ignition switch to turn on the first gear; 2. Then press and hold the left handle button for more than ten seconds, press the ignition switch again to turn on the second gear, wait for about five seconds, the maintenance prompt wrench will disappear, and then release the left handle. The following is a related introduction to the Lavida Plus: 1. Dimensions: The length, width, and height of the 2019 Lavida Plus are 4670mm, 1806mm, and 1474mm respectively, with a wheelbase of 2688mm. 2. Appearance: The Lavida Plus features a horizontal grille connected to the headlights, with a chrome strip running across the top of the grille. The headlights are more refined, and the high-end models are equipped with LED low and high beams, complemented by LED strip daytime running lights.
I remember feeling like I was unlocking a new skill the first time I performed maintenance light reset on my Lavida Plus. Get in the car, don't start the engine, just turn the key to the ON position to illuminate the dashboard. Then focus on the center of the instrument cluster, locate that tiny "OK" button, press and hold it without releasing - usually for about five to eight seconds until the maintenance reminder light goes off. I had to try a few extra times to succeed because my hands were too quick initially. Why do this? If you don't reset after maintenance, the light keeps flashing like it's urging you, which can be distracting while driving. Also, it's recommended to perform this operation in a parked state without running the engine. The Lavida is quite a common model, and Volkswagen series operations are basically consistent, but if unsure, checking the manual is reliable.
