What is the method for replacing the Geely Emgrand rearview mirror assembly?

[LaAlessandra]

The method for replacing the Geely Emgrand rearview mirror assembly is: 1. Pry open the inner door panel with a screwdriver; 2. Remove the two screws on the plastic cover; 3. Detach the plastic panels on both sides and the bottom; 4. Remove the screws on both left and right sides. Taking the 2021 Geely Emgrand as an example, it is a compact car with body dimensions of: length 4632mm, width 1789mm, height 1470mm, wheelbase 2650mm, and curb weight 1255kg. The 2021 Geely Emgrand features a MacPherson strut front suspension and a torsion beam rear suspension. It is equipped with a 1.5L naturally aspirated engine producing maximum horsepower of 109PS, maximum torque of 142Nm, and maximum power of 80kW, paired with a 5-speed manual transmission.

[WalkerLynn]

I’ve got solid experience replacing the rearview mirror assembly on my Emgrand. Step one: gather tools like a T20 screwdriver, plastic pry bar, and electrical tape to avoid scratching door trim. Disconnect the battery’s negative terminal as a safety precaution against short circuits—though not strictly necessary. Carefully pry open the door panel edges to locate the mirror’s mounting screws (usually inside the door), then remove all three. When detaching the old assembly, note the wire connectors’ color coding—Emgrand uses standardized wiring—and unplug them gently. Install the new unit securely, tighten screws, and test mirror adjustment. The job takes ~30 mins; pick clear weather to avoid rain/snow interference. Don’t cheap out on tools—a decent ¥50 set suffices. If mirrors don’t move after reassembly, calmly recheck wiring. Post-replacement, I felt way safer driving, but first-timers should watch video tutorials for technique.

[SanRichard]

The method for replacing the Geely Emgrand rearview mirror assembly is actually quite straightforward. First, gather the necessary tools: a Phillips screwdriver, a plastic pry tool, and a multimeter to prevent electric leakage. Before starting, turn off the engine to avoid electric shock. Carefully pry open the door panel with the pry tool to avoid scratches, then locate and remove the screws securing the mirror. Pay attention to the color markings on the wiring connectors—don’t mix up the black and red wires, or the mirror won’t adjust properly. Remove the old assembly and install the new one, and don’t forget to spray some lubricant on the moving parts during testing. The whole process takes less than 20 minutes, with patience being key—don’t yank the wiring harness. Common issues include loose screws or moisture seeping into the sealing ring, causing rust. Regular checks can prevent major repairs. A money-saving tip is to buy the parts online for just a few dozen bucks, but if you’re not confident, it’s safer to visit a repair shop for peace of mind.

[DeSophia]

Replacing the side mirror assembly requires careful handling. Tools needed include a screwdriver and a pry bar. Disconnect the door panel clips, remove the screws, and match the wire connectors by color when installing the new mirror. Avoid scratching the door paint during the process. After installation, test the mirror adjustment. If you're inexperienced, it's advisable to have someone knowledgeable assist you to prevent wiring mistakes that could blow a fuse. For safety, it's best to have it done professionally at a shop—spending a little money can save you a lot of trouble.