What is the method for removing the center console armrest of the BYD F3?
4 Answers
The BYD F3 is equipped with a 1.5L inline 4-cylinder naturally aspirated engine across all models, paired with either a 5-speed manual or a 6-speed dual-clutch transmission. Below are the steps for removing the center console armrest of the BYD F3: 1. First, open the armrest of the BYD F3; 2. Then, remove the screws inside the armrest; 3. Next, shift the car's gear to the N (neutral) position, grip the gear shift handle firmly, and pull it upwards to release the fixing clip of the gear lever; 4. Use a pry tool to separate the storage box panel and the armrest joint; 5. Pry open the clips on both sides of the car's armrest; 6. Lift the armrest upwards; 7. Finally, the armrest of the BYD F3 is successfully removed.
Last time I took apart the BYD F3's center armrest, it went pretty smoothly. The process isn't too complicated but requires attention to detail. The armrest is located in the middle-front position of the rear seats. You'll first need to locate its mounting points, usually with one or two screws hidden at the bottom. Use a Phillips screwdriver to remove them, then gently pull the armrest upward or sideways as there are plastic clips securing it to the body—avoid using excessive force to prevent breakage. If it feels stuck, carefully pry open the gap with a plastic trim tool or an old bank card to release the clips. After removal, check if there are any connected wires inside, such as cigarette lighter or USB port connectors, and disconnect them carefully to avoid damage. It's best to perform this on level ground while wearing thin gloves to protect your hands and the interior. Once removed, you can thoroughly clean or install additional storage compartments. When reassembling, align the clip positions and ensure screws are tightened to prevent looseness. Don't rush—taking it slow helps avoid rework.
As someone who frequently maintains cars, I believe removing the center console requires preparing tools like a Phillips screwdriver and plastic pry tools. The BYD F3's center console is usually secured by several screws, mostly located under the base or inner lining. After unscrewing them, gently lift upwards to release the clips. If the clips feel tight, avoid forcing them as they may break—use a pry tool to gently separate them from the edges. Inside, you'll often find the cigarette lighter wiring; unplug it before fully removing the console. Ensure a safe working environment—choose a well-lit area and avoid rainy days to prevent slipping. Stay patient throughout the process, and take photos before and after disassembly for easier reassembly. Once removed, take the opportunity to clean accumulated dust inside or modify the storage space, but ensure there's enough room—avoid overstuffing to prevent reinstallation issues.
Last time I disassembled the BYD F3 armrest box, the steps were quite simple. First, look for screws underneath or inside the armrest box and unscrew them with a screwdriver. Then release the clips and gently pull or pry it open. Be mindful of the internal cables; disconnect the plugs before removing. The entire process can be done with basic tools, and avoid forcing it open.
