What is the method for removing and installing the cigarette lighter in a Mazda Axela?
2 Answers
The method for removing and installing the cigarette lighter in a Mazda Axela is: 1. Unscrew the rear housing of the cigarette lighter socket; 2. Use a wrench to remove the screws under the housing; 3. Remove the panel of the gear shift lever; 4. Remove the panel screws; 5. Pull out the plastic box of the cigarette lighter panel and disconnect the connecting wires; 6. Remove the inner and outer rings. Taking the 2021 Mazda CX-4 Automatic Two-Wheel Drive Sky Youth Edition as an example, its body dimensions are: length 4637mm, width 1855mm, height 1524mm, wheelbase 2700mm, fuel tank capacity 45 liters, and curb weight 1493kg.
I remember the cigarette lighter issue with my Mazda3 was really annoying. It's not hard to remove and install, but you have to follow the steps carefully. First, park and turn off the engine, then disconnect the negative terminal of the car battery to prevent short circuits or blown fuses. The cigarette lighter is usually located next to the center console storage compartment. Use a plastic pry tool to gently remove the retaining ring, avoiding forceful pulling to prevent scratching the interior. The socket's mounting method varies by model: mine uses clips – just pinch the small clips and push upward to release; if it's screwed in, use a small wrench to unscrew and remove it. When disconnecting the wiring harness, be steady to avoid breaking the wire strands. Reinstallation is just the reverse process – make sure it's securely clipped or tightened, then test if the light turns on. By the way, cigarette lighters often fail due to blown fuses from using phone chargers – check the fuse box and replace the corresponding 10A or 15A fuse. Regularly clean dust to maintain good contact and extend lifespan. These simple maintenance steps can save you a lot of money – don't wait until it breaks to panic.
