What is the measured minimum ground clearance of the Haval H9?

1 Answers
CharlesAnn
07/29/25 9:23pm
Haval H9 has a minimum ground clearance of 206mm, an approach angle of 32 degrees, and a departure angle of 28 degrees. Concept of ground clearance: Ground clearance refers to the distance between the ground and the rigid parts underneath the vehicle. The ground clearance of a vehicle varies depending on whether it is unloaded or loaded. Ground clearance is categorized into unloaded and loaded conditions. The ground clearance under loaded conditions is also known as the minimum ground clearance, which refers to the shortest distance between the lowest protruding point of the vehicle's chassis and the ground when the vehicle is parked on a level surface under its rated maximum load. Characteristics of ground clearance: Ground clearance is related to the vehicle's load—the heavier the load, the smaller the ground clearance. Vehicles with smaller ground clearance have a lower center of gravity but poorer off-road capability. Vehicles with larger ground clearance have better off-road capability. Higher ground clearance not only improves performance on gravel and mountain roads but also helps prevent water from entering the exhaust pipe when driving through flooded areas and makes it easier to park on curbs or parking spaces with height differences.
Was this review help?
10
5
Share
More Forum Discussions

What are the maintenance items for the Highlander at 40,000 kilometers?

The main maintenance items for the Highlander at 40,000 kilometers include replacing the engine oil, three filters, and all vehicle fluids, as well as some necessary routine inspections. For example, replacing the brake fluid, transmission fluid, power steering fluid, and coolant. Replacing the engine oil and oil filter is a mandatory item. Below is an introduction to the replacement of the oil filter and spark plugs: 1. The oil filter is used to prevent impurities from mixing into the engine oil, causing oxidation and producing gums and sludge that can clog the oil passages. Both the engine oil and the oil filter should be replaced simultaneously. 2. The air filter should be replaced every 10,000 to 15,000 kilometers. 3. If the spark plugs have never been replaced before, they must be replaced during the 40,000-kilometer maintenance. 4. Analysis of the spark plugs shows that they may not have completely failed at 40,000 kilometers, but the ignition performance of the spark plugs has significantly decreased, directly affecting the engine's power, performance, and fuel consumption.
16
2
Share

Are Citroën and Peugeot the same company?

Citroën and Peugeot are not the same company; they are two distinct automobile manufacturers, both being French brands. Dongfeng Citroën is the domestically produced version of Citroën, with models under the Citroën brand including the C5, C6, C4, Elysee, C3-XR, and C4 C-Quatre. Peugeot's brand lineup includes models such as the 301, 308, 408, 508, 3008, 4008, and 5008. Taking the Dongfeng Citroën Tianyi C5 as an example, it is positioned as a premium SUV, with body dimensions of 4510mm in length, 1860mm in width, and 1670mm in height, and a wheelbase of 2730mm. The Dongfeng Peugeot 308 is an entry-level compact car, with body dimensions of 4590mm in length, 1820mm in width, and 1488mm in height, and a wheelbase of 2675mm.
12
0
Share

At what temperature does the BMW X5's fan start working?

Generally, the engine radiator cooling fan starts working at around 90 degrees Celsius. When the temperature reaches approximately 105 degrees, the fan begins to operate at high speed. For domestic vehicles, the fan typically activates between 93 to 95 degrees. The radiator fan will automatically turn on only after the vehicle engine has been running for a certain period and the coolant temperature rises. Fan operation: The car's electric fan is controlled by a thermostat. When the coolant temperature rises to the upper limit, the thermostat connects the power supply and the fan starts working. When the temperature drops to the lower limit, the thermostat cuts off the power and the fan stops. Methods to determine fan condition: Visually inspect the fan motor's ventilation port to check if there are any signs of burnt coil discoloration. If burnt marks are present, it indicates the fan motor coil is damaged and unusable. Smell the fan motor for any odor of burnt coils or melted plastic - if detected, the fan is no longer functional.
18
3
Share

Where is the original Mercedes-Benz amplifier located?

Mercedes-Benz original amplifier is located in the trunk, under the right rear cover. Working principle of the amplifier: The amplifier is the most fundamental device in a car audio system. Its task is to amplify weak electrical signals from the car's head unit to drive the speakers and produce sound. Due to considerations of power, impedance, distortion, dynamics, different usage ranges, and control adjustment functions, different amplifiers vary in internal signal processing, circuit design, and production processes. Classification of amplifiers: Car amplifiers are categorized by circuit type into Class A amplifiers, Class AB amplifiers, Class B amplifiers, and Class D amplifiers (digital amplifiers).
14
1
Share

Can You Still Drive When the Engine Oil Light Is On?

It is best not to drive when the engine oil light is on. Here are detailed explanations: 1. If you see the engine oil pressure indicator light up after starting the car, you should not continue driving. The first thing to do is to check the oil dipstick to see if the oil level is normal, and top up the oil if necessary. If you cannot identify the issue, take the car to the nearest repair shop for inspection. 2. If the engine oil warning light comes on while driving, find a safe place to pull over and check, but this should only be limited to checking the oil level. If the car drives normally, you can continue to the nearest 4S shop for inspection, but remember to slow down and drive carefully. 3. If the engine oil warning light on the dashboard comes on and the car can still be driven normally but exhibits symptoms such as shaking or lack of acceleration, continuing to drive may worsen engine wear and could even threaten life and property safety. In such cases, it is best to call for a tow truck.
7
2
Share

Why can't the rear brake be used for motorcycles?

The front brake configuration of motorcycles is generally higher than that of the rear brake. Small-displacement motorcycles usually adopt a front disc brake and rear drum brake. Here are the relevant introductions: Rear brake: When the speed is relatively slow, it is generally sufficient to use only the rear brake. When the speed is fast, both the front and rear brakes should be used simultaneously, and the braking force ratio between the front and rear should be reasonably matched. This force ratio needs to be adjusted flexibly according to the situation, and sufficient practice is required to fully master the performance of the motorcycle. Front brake: When the speed is fast, due to the forward shift of the center of gravity during high-speed driving, the front brake plays a more significant role. High-speed braking is relatively dangerous, so it should be gradually adapted from slow to fast. Do not depress the clutch or downshift when braking, as this can fully utilize the engine's braking performance to shorten the braking distance and more reliably ensure that the braking does not lose control. When braking and reducing the speed to a sufficiently low level, then depress the clutch and downshift to the appropriate gear.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.