What is the maximum wading depth of the Discovery 4?

2 Answers
StJonathan
08/26/25 5:42am
According to official specifications, the maximum wading depth of the Discovery 4 is 670mm. Common tire specifications include 285/40R22, 255/55R20, and 275/45R21. The vehicle height is 1888mm, and it is a 5-door, 7-seat SUV. Maximum wading depth refers to the deepest water level a vehicle can safely pass through. Generally, sedans have a maximum wading depth of no more than 300mm, while SUVs can handle deeper water, though it's best not to exceed 500mm. Among common models, the GAC Trumpchi GS8 has a maximum wading depth of 700mm, the Audi A4 has 320mm, the Volkswagen Sagitar has 700mm, the Land Rover Range Rover has 900mm, the Jeep Compass has 800mm, and the Toyota Highlander has 455mm. SUVs generally have higher wading depths than sedans. Generally, when driving through water, vehicle owners should take different measures depending on the water depth and the vehicle's characteristics, as follows: When the water depth reaches the exhaust pipe height, it is still safe. Even if water enters the exhaust pipe, the pressure inside can expel it. As long as the engine is not turned off in the water, water will not flow back into the vehicle. When the water depth reaches the door frame height, it becomes more dangerous. The vehicle's circuits, electronic components, and sensors are mostly located at the bottom, which could lead to short circuits and damage critical electrical components, preventing the car from starting normally. When the water depth reaches the air intake height, it is extremely dangerous. Driving directly into such water could cause the engine to stall immediately, leading to permanent damage or rendering the engine unusable.
Was this review help?
19
1
Share
DiMaria
09/08/25 8:01am
When off-roading in the Discovery 4, I love its wading capability the most. The official specification states a maximum depth of 700mm, which is about calf-deep in water. I once drove it along a rain-swollen creek with around 60cm of water depth, and it passed through steadily without the engine stalling. This is thanks to the vehicle's sealed design and the position of the air intake, preventing water from flooding in. When wading, maintain a slow and steady speed—don't rush to avoid waves submerging the hood, and steer clear of deeper areas to prevent electrical damage. After wading, I always check the air filter and wheel arches, removing any mud to maintain the vehicle and prolong its lifespan. Honestly, 700mm is more than enough for most off-road scenarios.
Was this review help?
11
1
Share
Expand All
More Forum Discussions

What to Do When the Compulsory Traffic Insurance for a Used Car Expires?

The owner only needs to go to the insurance company to renew the policy before it expires. You can cancel the compulsory traffic insurance. The new owner can apply for a new compulsory traffic insurance in the place of registration and then cancel the original policy at the insurance company where the previous owner had it. The traffic management department of the public security authority has the right to detain the vehicle and notify the owner or manager to comply with the insurance requirements. Additionally, a fine of twice the premium for the minimum liability coverage will be imposed.
5
3
Share

Where is the hood switch of the Volkswagen Lavida?

The engine hood switch of the Volkswagen Lavida is located in the lower left corner of the driver's seat. You can lift the handle along the arrow to open the engine hood, then remove the hood support rod from its fixed bracket, and finally hang the hood support rod into the groove of the engine hood. When closing the engine hood: hang the hood support rod into the opening at the indicated position, press it into its fixed bracket, then slowly close the engine hood to a lower position, and finally release your hand to let the engine hood fall into the locking device. If the engine hood is not completely closed, reopen it and follow the above steps to close it properly.
6
3
Share

What to Do When the Radiator Symbol Lights Up?

The driver needs to place the hazard warning sign at a distance of more than 150 meters from the vehicle to alert following cars. Then open the front hood of the car and check the condition of the fan. If the coolant level in the coolant reservoir is low, it is necessary to add coolant. To check if the radiator is low on water, distilled water or purified water can be used to replenish it. If the radiator symbol appears repeatedly, there may be a leak in the radiator, and further inspection at a repair shop is required.
3
5
Share

What Causes a Manual Gear Shift Lever to Detach?

If the self-locking mechanism is damaged, it is highly likely to cause the transmission to slip out of gear. When the synchronizer sleeve lock ring or sliders are severely worn, the synchronizer may overcome the locking force of the self-locking mechanism and slide out of the engagement gear ring. If the shift lever or shift fork is severely worn, the shift fork may fail to move the synchronizer to the engagement position, preventing the synchronizer from perfectly meshing with the sleeve. Due to high-speed rotation, the synchronizer is highly likely to slide out of the sleeve, causing the transmission to slip out of gear.
6
5
Share

How many kilometers should the Ford Kuga's spark plugs be replaced?

Ford Kuga's spark plugs should be replaced approximately every 45,000 kilometers. The working principle of spark plugs is: under the control of the engine, they introduce the high-voltage electricity generated by the ignition coil into the engine cylinder, creating a spark between the spark plug electrode gaps to ignite the mixed gas, ensuring the engine operates normally. Here is more information about this vehicle: 1. Taking the 2019 Ford Kuga as an example, it is a compact SUV. 2. The body dimensions are: length 4524mm, width 1838mm, height 1685mm, wheelbase 2690mm, front track 1563mm, rear track 1565mm, fuel tank capacity 60 liters, and body weight 1592kg.
13
4
Share

How to Use the Clutch in Traffic Jams and When Following Cars

This refers to the semi-engaged state of the clutch. In a manual transmission, power is rigidly transmitted. When the clutch is depressed, the power is disconnected, and when the clutch is fully released, the power is connected. During traffic jams, speeds are very slow. To avoid going too fast, you can choose to use the semi-engaged clutch. If you follow the car in front too closely, it can easily lead to a rear-end collision. Even if it doesn't cause significant damage, it can worsen traffic congestion and waste everyone's time. For automatic transmission cars in traffic jams, just mastering the brake is sufficient. However, for manual transmission cars, frequent starts and stops are common, and the semi-engaged state is mostly used.
14
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.