What is the maximum wading depth of the Audi A4L?

1 Answers
ArcherLynn
07/30/25 2:09am
The maximum wading depth of the Audi A4L is 320mm. The wading depth of the Audi A4L is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally speaking, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake of the Audi A4L is below the water level when wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause serious damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth should not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, be sure to turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in the water, which could cause severe engine damage due to water intake. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the paths taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. For roads prone to water accumulation, observe warning water level markers, trees, or reference points such as the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not proceed and choose an alternative route instead.
Was this review help?
6
3
Share
More Forum Discussions

What are the precautions when inflating car tires?

Precautions when inflating car tires include: 1. Pay attention to safety during inflation and always use a pressure gauge to check the air pressure to avoid tire bursting due to over-inflation; 2. After stopping the vehicle, wait for the tires to cool down before inflating, as tire temperature rises during driving, which affects air pressure; 3. Check the valve stem. If the valve stem and valve core do not fit smoothly, with protrusions, depressions, or other defects, it will be inconvenient for inflation and pressure measurement; 4. Ensure cleanliness during inflation. The air being pumped in should not contain moisture or oil to prevent deterioration and damage to the inner tube rubber; 5. Do not exceed the standard air pressure excessively and then deflate, nor should you over-inflate due to prolonged inability to inflate while traveling. Excessive over-inflation can cause excessive stretching of the cord, leading to a reduction in its strength.
7
5
Share

What are the reasons for the Cruze's lack of power when climbing slopes?

Faults that cause lack of power when climbing slopes include: engine faults (carbon deposits), engine intake system faults, and engine fuel system faults. Below are detailed explanations: 1. Carbon deposits in the engine: The most common is spark plug carbon deposits, which affect the stability of the ignition system, leading to incomplete fuel combustion, increased fuel consumption, and other issues, thereby causing the car's power to weaken and lack strength when climbing slopes. 2. Blockage in the car's intake or exhaust system: This could be due to a clogged air filter or a blocked three-way catalytic converter in the exhaust pipe, affecting the car's exhaust flow, which in turn prevents the engine from working properly, reducing the car's power. 3. Engine fuel system fault: Possible causes include clogged fuel injectors, fuel leaks, aging fuel pumps affecting the engine's power reduction, or a clogged engine oil filter, preventing the engine from functioning properly and causing abnormal vehicle power.
18
4
Share

What is the general height of a car?

The height of a car is generally between 1400mm and 1600mm, with lengths ranging from 3800mm to 4300mm and widths between 1600mm and 1800mm. The length, width, and height of a car refer to the outermost dimensions of the vehicle. The front and rear lengths include the length of the bumpers, the width does not include the dimensions of the side mirrors (if the manufacturer provides multiple width measurements, the one excluding the side mirrors is added; if only one measurement is provided, that data is used), and the height includes the roof rack but not the antenna. Specific meanings of car dimensions: Car length refers to the distance between two vertical planes perpendicular to the vehicle's longitudinal symmetry plane, touching the outermost protruding parts at the front and rear of the car. Car width refers to the distance between two planes parallel to the vehicle's longitudinal symmetry plane, touching the fixed protruding parts on both sides of the vehicle (excluding side mirrors, marker lights, position lights, turn signals, flexible mudguards, folding steps, anti-skid chains, and the part of the tire in contact with the ground). Car height refers to the distance between the vehicle's supporting plane and the horizontal plane touching the highest protruding part of the vehicle. Practical significance of car height: The height of the car body determines its center of gravity and interior space. Most small cars are below 1.5 meters in height, which is much lower than the natural sitting height of a person, sacrificing a lot of headroom for passengers. This is mainly to lower the vehicle's center of gravity, ensuring stability during high-speed turns to prevent rollover. MPVs and small trucks, designed for spacious headroom and cargo space, typically have a height above 1.6 meters. However, this raises the vehicle's center of gravity, making it more prone to rollover during high-speed turns—a significant drawback of taller vehicles. Additionally, most indoor parking lots have height restrictions, usually around 1.6 meters, which imposes certain limitations on taller vehicles.
10
0
Share

How to Schedule a Car Maintenance Appointment?

Scheduling a car maintenance appointment can be done through the following methods: 1. Phone Appointment: You can call a brand's after-sales service hotline to schedule an appointment. Alternatively, you can directly contact a familiar after-sales service representative. 2. Online Appointment: You can schedule an appointment via a mini-program or app. Below are the benefits of regular car maintenance: 1. Improved Efficiency: Effectively enhances vehicle efficiency, reduces fuel consumption, and minimizes wear on parts and tires. For instance, regular engine maintenance prevents increased fuel consumption and ensures smoother operation. 2. Enhanced Driving Safety: Maintenance helps avoid sudden issues during driving, thereby ensuring personal safety.
12
0
Share

What type of engine oil is suitable for the Verna?

The Verna uses 5W20 grade engine oil. The number before the 'W' indicates cold temperature performance, with a smaller number representing better cold resistance. In northern winters, it is recommended to use 0W or 5W oil. The number after the 'W' represents the oil's viscosity; a higher number indicates higher viscosity and better protective performance for the engine. The Verna is a model jointly designed and developed by Beijing Hyundai, Hyundai North America, and the European Design Center. It is a sedan. In terms of body dimensions, the Verna measures 4340mm in length, 1700mm in width, and 1460mm in height, with a wheelbase of 2570mm.
12
4
Share

What is the original tire brand of the Envision?

The original tire brand of the Envision is Bridgestone. Below is relevant information: Positioning: The Buick Envision is positioned as a midsize SUV with a relatively large body size and spacious interior. This vehicle has a powerful yet stylish appearance, making it an ideal choice for young drivers. Exterior: The 2020 Buick Envision features a more rugged and bold design. The new wing-shaped chrome trim runs through the LED wing-shaped headlights, enhancing the horizontal visual effect. The dynamic front bumper styling and three-dimensional silver lower guard create a full and powerful front end. The rear also adopts a three-dimensional wing-shaped design, with chrome trim connected to the taillights, paired with integrated dual exhaust pipes to enhance the sporty feel.
16
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.