What is the maximum speed of the Lavida Plus on the highway?

2 Answers
KingstonDella
07/25/25 1:27pm
The Lavida Plus can reach a maximum speed of 200 km/h on the highway. Here are some precautions to take before driving the Lavida Plus on the highway: 1. Engine start: The main reason for difficulty in cold engine starts is that the engine temperature is too low. To avoid this, keep the engine warm by preventing cold wind from directly blowing into the engine compartment. Therefore, when parking in winter, pay attention to the direction of the car's front. It's best to face the front towards a building to block the wind and prevent the engine from getting too cold. 2. Night parking: When parking at night, you can face the front of the car towards the direction of the rising sun, allowing the first rays of morning sunlight to warm the engine, making it easier to start the car. Additionally, regularly visit designated service stations for inspections and adjustments. 3. Engine stalling during gear shifts.
Was this review help?
2
4
Share
McJaxon
08/11/25 8:45pm
I often drive the Lavida Plus on the highway, and the top speed of this car mainly depends on the engine configuration. If it's the 1.5L naturally aspirated version, the nominal top speed is about 190 km/h; with the 1.4T turbocharged engine, it can easily reach around 210 km/h. I've personally tried the 1.4T model, and when flooring the accelerator on a straight stretch, it can indeed reach that speed, but the car tends to shake a bit, and the wind noise is loud. Driving on the highway isn't racing—safety comes first. I usually stick to the 120 km/h speed limit, which saves fuel and prevents accidents. Regular maintenance of tires and brakes is crucial; otherwise, the risk of losing control at high speeds increases. Remember, speeding is illegal and raises the chance of accidents, so don't take unnecessary risks for speed. Driving steadily is the smarter choice.
Was this review help?
18
0
Share
Expand All
More Forum Discussions

What Causes Steering Wheel Vibration in BMW 3 Series?

BMW 3 Series steering wheel vibration may be caused by the following reasons: Poor tire dynamic balance: During driving, if a tire experiences a strong local impact, it may cause the balance weights to fall off or become damaged, thereby affecting the tire's dynamic balance. When driving at high speeds, the vehicle body and steering wheel will exhibit noticeable vibration, which becomes more pronounced as the speed increases. Significant differences in tire pressure among the four tires: When there is a large difference in tire pressure among the four tires, especially between the left and right tires, the vehicle body will experience noticeable bumps and the steering wheel will vibrate significantly during high-speed driving. Poor four-wheel alignment: When the four-wheel alignment has significant deviation angles, the vehicle body may drift and vibrate during high-speed driving. Additionally, this can lead to uneven tire wear, accelerating tire deterioration and shortening their lifespan.
18
0
Share

What are the reasons for the Mercedes-Benz S600 air conditioning not cooling?

Mercedes-Benz S600 air conditioning not cooling reasons are as follows: Insufficient or too little refrigerant: A common reason for car air conditioning not cooling is insufficient or too little refrigerant, which may be caused by minor leaks, requiring a refrigerant refill. Excessive refrigerant: Too much refrigerant can also cause the air conditioning not to cool. There is a required proportion of refrigerant volume in the air conditioning system. If the proportion is too high, it can affect heat dissipation. You can slowly release some refrigerant from the low-pressure side maintenance port. Loose drive belt: If the drive belt is loose, the compressor may slip during operation, leading to reduced transmission efficiency, lower compressor speed, decreased refrigerant compression delivery, and consequently, the car air conditioning not cooling. If the compressor drive belt is too loose, it should be tightened.
18
2
Share

Where is the horn fuse of the Bestune X40?

Bestune X40's horn fuse is located in the fuse box next to the engine. Method for replacing the fuse: Identify the damaged fuse by the blown filament, remove the blown fuse with a fuse puller (the fuse puller is located inside the engine compartment fuse box cover), determine the cause of the fuse blowing and rectify the fault. Precautions for replacing the fuse: Note: It is prohibited to use conductive tools to remove the blown fuse; the fuse puller must be used. Using a fuse substitute or a fuse with incorrect specifications and ratings may damage the electrical system or cause a fire.
16
5
Share

What are the symptoms of a faulty BMW fuse box?

BMW fuse box failure may exhibit the following symptoms: Vehicle fails to start: When the battery has power but the vehicle won't start, this symptom likely indicates a blown fuse responsible for the starter motor. Note that when discovering the vehicle won't start, avoid continuous ignition attempts as this will cause continuous battery discharge leading to complete power loss. Speedometer displays zero: While driving, if the tachometer shows normal readings but the speedometer displays zero with the ABS warning light illuminated, this indicates a blown fuse related to the ABS system. Some unscrupulous dealers may remove ABS control fuses during vehicle transportation to prevent mileage accumulation, but this creates significant safety hazards as vehicles without ABS become extremely dangerous in emergency situations.
2
2
Share

What is the minimum ground clearance of the New Transit?

The minimum ground clearance of the New Transit is 30mm. Interior: Luxurious and aesthetically pleasing with harmonious color matching. The integrated center console features clearly divided zones including audio control area, air conditioning operation area, and clock display for intuitive operation. Large circular tachometer and odometer are clearly visible with dynamic styling. Matte faux wood grain trim panels add texture and elevate the sense of premium quality. Features: High-quality surround sound system delivers an auditory feast. Pull-out cup holders and document clip on the dashboard demonstrate thoughtful humanized design for driver convenience. Dual oversized storage compartments on the right side offer both open and enclosed options for practical utility. The control area on front door panels perfectly complements considerate details like document pockets.
5
2
Share

What Causes the Teana to Stall Immediately After Starting?

Teana stalls immediately after starting due to the following reasons: Fuel supply system malfunction: Issues such as insufficient fuel pump pressure, pressure regulator leakage, clogged fuel filter and injectors, or injector dripping can all cause the engine to stall right after starting. Ignition system malfunction: The role of the ignition system is to convert the low-voltage electricity from the car's power supply into high-voltage electricity, and then distribute it accurately and timely to each cylinder's spark plug according to the engine's working sequence and ignition timing requirements, generating an electric spark at the gap to ignite the combustible mixture in the cylinder. Among these, the spark plug is the most critical component in the ignition system. If the spark plug electrodes are eroded, the gap is too large, or there is carbon buildup, the spark may scatter during ignition, reducing the ignition energy, which will inevitably affect the engine's starting performance, making it difficult to start.
13
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.