What is the maximum speed limit for urban road driving?

1 Answers
VanLillian
07/29/25 11:35pm
For roads without a central dividing line, the speed limit is 30 kilometers per hour in urban areas and 40 kilometers per hour on highways. For roads with only one lane in each direction, the speed limit is 50 kilometers per hour in urban areas and 70 kilometers per hour on highways. Below is relevant information about urban road speed limits: 1. Introduction One: The speed limit for urban roads is generally between 40 to 60 kilometers per hour, though this may vary in some cities. Drivers entering an unfamiliar city must drive slowly and pay attention to speed limit signs to avoid being caught speeding by traffic cameras. 2. Introduction Two: Urban roads include both regular city roads and expressways. Regular urban roads typically have speed limits ranging from 40 to 60 kilometers per hour, while expressways may have a maximum speed limit of 80 kilometers per hour. Drivers should always refer to the posted speed limit signs for accurate information.
Was this review help?
2
4
Share
More Forum Discussions

What is the RPM for a manual transmission at 120 km/h?

Manual transmission at 120 km/h generally has an RPM around 3000. Hazards of excessively low RPM: Under normal circumstances, a car's RPM needs to be above 2000 to demonstrate its advantages, and the 2000-4000 RPM range is referred to as the healthy RPM range. If the RPM is too low, fuel cannot fully combust in the cylinders, leading to carbon buildup in the engine. Over time, this can affect the engine's performance and cause significant damage. Hazards of RPM exceeding the normal range: If the RPM is higher than the normal range, it can easily lead to burning engine oil, damaging the transmission, and may also indicate poor engine performance. Generally, small-displacement turbocharged engines have relatively higher output power because the turbo provides additional assistance, allowing more oxygen to be drawn in during operation.
1
2
Share

Can a Manual Transmission Be Converted to an Automatic Transmission?

Manual transmission can be converted to automatic transmission. There are two ways to convert to automatic transmission: adding an automatic clutch to the vehicle, which eliminates the need to press the clutch pedal when shifting gears, allowing direct gear changes by increasing or decreasing the gear. Alternatively, the vehicle's transmission can be directly replaced. Precautions for Driving a Manual Transmission Vehicle: When shifting gears in a manual transmission vehicle, the clutch pedal must be pressed, and the gear should be changed based on the vehicle's RPM. If the RPM exceeds 2,000, the gear should be shifted to avoid affecting power output. Otherwise, the vehicle's RPM will increase, leading to louder engine noise and potentially affecting driving performance. How to Shift Gears in a Manual Transmission: Simply press the clutch pedal. Each gear shift in a manual transmission vehicle is equivalent to starting the vehicle. If the operation is careless during shifting, the vehicle may stall. Driving a manual transmission vehicle requires practicing gear shifting frequently to ensure smooth driving and prevent accidents.
20
0
Share

How Much More Fuel-Efficient is a Manual Transmission Compared to an Automatic?

Generally, manual transmissions are 1-2 percentage points more fuel-efficient per 100 kilometers than automatic transmissions. Here are some fuel-saving tips: Control the throttle when going uphill: Avoid accelerating if possible. When a vehicle is climbing a slope, the engine load increases. If you press the accelerator to speed up, the instantaneous fuel consumption will rise easily. Coast in gear on flat roads: When coasting in gear on flat roads with good conditions, the engine reduces fuel injection due to the engine braking effect, leading to a decrease in instantaneous fuel consumption and stabilizing at a certain value. Most modern engines use electronically controlled fuel injection systems, and coasting in neutral has been proven not to save fuel. Moreover, coasting in neutral is a dangerous driving behavior explicitly prohibited by traffic regulations. Accelerate gently when starting: There's no need to pursue the push-back feeling during acceleration. A smooth and linear start is more practical and comfortable for passengers. For manual transmission vehicles, maintaining a steady start can effectively reduce instantaneous fuel consumption.
12
4
Share

Can a Manual Transmission Start from 2nd Gear?

Manual transmission vehicles can start from 2nd gear. However, this starting method is not recommended. While it is technically possible to start in 2nd, 3rd, or even 5th gear, it is not advisable. Manual transmissions consist of gears and shafts that produce varying speed and torque through different gear combinations. Lower gears provide greater power output and higher gear ratios, meaning 1st gear delivers the most power, which is necessary to start a stationary vehicle. Higher gears provide less power output. Hazards of frequently starting in 2nd gear: Frequently starting in 2nd gear can damage the clutch. Starting in 2nd gear may result in insufficient RPM, causing increased wear on the clutch plate. The higher the gear used for starting, the greater the clutch wear. Therefore, from a vehicle maintenance perspective, it is best to start in 1st gear. Consider using 2nd gear for push-starting: Some drivers believe that on downhill slopes or during rainy days, when less power is needed to start the vehicle, 2nd gear can be considered. Starting in 1st gear under these conditions might cause the car to lurch forward unsafely. Some also argue that diesel vehicles, with their greater horsepower, can handle starting in 2nd gear.
17
4
Share

Can motorcycle and car driver's licenses be held separately?

A single individual cannot hold separate motorcycle and car driver's licenses. When applying for an additional license category while already holding a driver's license, the original license must be surrendered upon receiving the new one. The two licenses are then combined into a single document that records both permitted vehicle types, such as C1E. Introduction: The full name of a driver's license is a motor vehicle driver's license, also known as a "driving license," which is a certificate required by law for individuals to operate motor vehicles. Important Notes: Operating a motor vehicle requires certain driving skills. Individuals lacking these skills may cause traffic accidents if they drive without proper training. Generally, driving without a license is prohibited.
3
2
Share

What is the general ground clearance of a sedan?

Sedan ground clearance typically ranges between 110-150mm. Below is relevant information about sedan ground clearance: 1. Generally, greater ground clearance correlates with relatively better performance. 2. Higher ground clearance in sedans results in reduced stability when driving at excessive speeds. 3. If the ground clearance is less than 110mm, the vehicle will exhibit more stable handling on highways. 4. Nevertheless, vehicles with lower ground clearance demonstrate noticeably poorer passing capability. 5. Some modern vehicles are equipped with air suspension systems, making ground clearance adjustment flexible. Drivers can automatically adjust ground clearance as needed, perfectly balancing the dual requirements of stability and passing performance.
6
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.