What is the maximum speed limit for motor vehicles when passing through sharp curves?

At what tire pressure level should a car be inflated?

During summer, tires should be inflated when the pressure falls below 2.0 bar, while in winter, inflation is necessary when the pressure drops below 2.2 bar. Hazards of overinflated tires: Reduced tire friction and adhesion, affecting braking performance; causes steering wheel vibration and misalignment, diminishing driving comfort; accelerates uneven wear on the central tread pattern, shortening tire lifespan; increases vehicle vibration, indirectly impacting the longevity of other components; overstretches tire cords, reducing elasticity and increasing driving load; decreases puncture resistance. When encountering sharp objects like nails or glass on the road, the tire is more prone to punctures, and impacts may cause internal cracks or blowouts, leading to tire failure. Hazards of underinflated tires: Increases friction coefficient with the road surface, raising fuel consumption; makes steering heavier and prone to misalignment, compromising driving safety; increases movement in various tire sections, causing abnormal heat due to excessive compression; degrades cord and rubber functionality, leading to delamination or cord breakage and excessive friction with the wheel rim, damaging the bead area and causing abnormal wear; multiplies friction between the tire and ground, sharply increasing tire temperature and softening the tire, drastically reducing strength. High-speed driving may result in blowouts; increases tire body deformation, making sidewalls prone to cracks and generating flexing motion, leading to excessive heat, rubber aging, cord fatigue, and breakage, while also enlarging the tire's contact area and accelerating shoulder wear.

1

4

Share

Where is the BMW Spare Tire?

Older BMW 5 Series models come with a spare tire, which is located beneath the floor in the trunk. However, newer models do not include one. The reason newer BMW models across the lineup do not come with a spare tire is because they are equipped with run-flat tires. The advantage of run-flat tires is that they enhance driving feel and handling. Below is relevant information about the classification of spare tires: 1. Full-size spare tire: A full-size spare tire has the exact same specifications as the other four tires on the vehicle and can replace any tire that is temporarily or permanently unusable. 2. Compact spare tire: This type of spare tire has a slightly smaller diameter and width compared to the other four tires, making it suitable only for temporary use. It should only be used on non-driving wheels and must not exceed a speed of 80 km/h. 3. Run-flat tire: Also known as a safety tire (run-flat tire), commonly referred to as a 'bulletproof tire,' the industry directly translates it as 'tire that can run when flat.' Compared to regular tires, run-flat tires do not leak air or leak very slowly when punctured, maintaining the driving profile. The tire bead also remains securely fixed to the rim, allowing the car to drive for an extended period or temporarily stable to a service station.

19

4

Share

What are the speed limits for the four lanes on a highway?

Highway four-lane speed limits are as follows: 1. The first lane from left to right: 100-120 km/h. Generally reserved for passenger cars. 2. The second lane: 80-100 km/h. 3. The third lane: 60-100 km/h. 4. The fourth lane: Emergency lane. Some highways may have different regulations, so always follow the marked speed limits on the road. When driving on a highway, pay attention to the following: 1. Always adhere to the speed limit. The maximum speed limit on Chinese highways is 120 km/h, and different lanes may have varying speed limits, which are indicated by roadside signs. Speeding is a major cause of accidents, so avoid it at all costs. At the same time, avoid driving too slowly, as this can disrupt normal traffic flow. 2. When entering the main lane from an on-ramp, use the acceleration lane to reach an appropriate speed before merging. Do not obstruct vehicles already in the main lane. 3. Clearly distinguish the purpose of each lane and drive accordingly. Generally, stay in the main lane and only use the overtaking lane when necessary to ensure smooth traffic flow. 4. Follow speed limit regulations. Speeding can lead to accidents, while driving too slowly can hinder other vehicles. Reduce speed during rainy conditions. 5. Always watch for roadside and overhead signs and markings. Stay slightly to the right to avoid crossing the right lane divider, giving overtaking vehicles sufficient side clearance.

1

5

Share

How often should the Mazda 3 transmission fluid be changed?

Mazda 3 transmission fluid should be changed every 60,000 kilometers. Failure to replace the automatic transmission fluid in a timely manner will directly affect the vehicle's performance, fuel consumption, and even the service life of the automatic transmission. The following points should be noted when changing the transmission fluid: 1. Fluid Replacement Methods: There are generally two methods for changing the fluid—manual replacement or transmission fluid exchange. Although manual replacement saves time, it has a drawback: the fluid is not completely replaced. Typically, manual replacement can only drain part of the old fluid from the tank and cannot thoroughly remove all the old fluid. On the other hand, a transmission fluid exchange, though more time-consuming, can remove at least 85% of the old fluid. 2. Replacement Precautions: When changing the fluid, owners should note that, regardless of the method, the operation must be performed with the engine running. Since automatic transmission fluid replacement needs to be done when the vehicle is warm, the car should be running for at least 20 minutes before the replacement. During the fluid change, start the engine and shift through all gears from P to N, D, L1, L2, etc., back and forth before beginning the fluid replacement. 3. Replacement Interval: Many owners often wait until the transmission fluid deteriorates before considering a replacement, and some even neglect the type and quality of the fluid during the change. These practices can cause damage to the transmission and even shorten its lifespan. If the vehicle manual does not specify a replacement interval, it is recommended to change the fluid every 40,000 kilometers. The maximum interval should not exceed 60,000 kilometers.

16

0

Share

What are the reasons for insufficient coolant flow P00B7?

Reasons for insufficient coolant flow include engine system leakage, thermal expansion and contraction, failure to dissipate heat in time, water pump replacement, and impurities in the engine. The following are detailed explanations: Engine leakage: Leakage in the engine cooling system causes the coolant to drain completely. In this case, it is necessary to check whether there is any leakage point in the cooling cycle from the radiator to the cooling water circulation pump, to the engine water inlet, to the water outlet, to the coolant pipe, and to the cooling row. Thermal expansion and contraction: Due to thermal expansion and contraction. When the engine is cold, the coolant level is below the minimum line. After the engine runs for a while, it returns to the middle of F/L. It is recommended to check before starting the engine. Air in the cooling system: There are areas in the cooling system where air is retained. After a period of circulation, the air is expelled, causing the coolant level to drop. Water pump replacement: Possible reasons: After replacing the water pump, the temperature regulating actuator - N493 - was not matched; there is air in the coolant system; the engine cooling system is dirty with excessive impurities; improper use of sealant when installing the water pump; do not use high-quality frozen antifreeze. Impurities in the engine: Scale, rust, sludge, and other impurities in the engine cooling pipes may stably adhere and accumulate in the corners when not disassembled. After draining and filling with coolant, they come out one after another through the disassembly and assembly of the water pump, and can be clearly seen on the inner walls of the disassembled old parts. On one hand, these scale and impurities cause the electronic thermostat rotary valve to jam, triggering an engine fault code, and on the other hand, they cause the new water pump to overheat.

10

5

Share

What is the tire size of the Tiggo 5x?

The tire size of the Tiggo 5x is 215/60R17. The first number, 215, represents the tire width of 215MM. The number 60 indicates that the aspect ratio of the tire section is 60%, meaning the section height is 60% of the width. The number 17 represents the rim diameter of 17 inches, and the letter "R" in the middle stands for radial tire. The Tiggo 5x tires feature a five-spoke cyclone-style black, silver, and red wheel design. The tire brand is Maxxis BRAVO-HPM3, and the spare tire specification is non-full size. If you want to replace the tires yourself, you can follow the steps below: Take out the spare tire and jack, place the jack under the frame of the tire to be replaced, ensuring the jack touches the metal part of the frame; Raise the jack until it supports the car. The jack should be positioned under the vehicle, and check to ensure the jack is at a right angle to the ground; Remove the hubcap and loosen the nuts counterclockwise. Do not completely loosen the nuts; just enough to eliminate resistance. When loosening the nuts for the first time, keeping the tire on the ground ensures that the nuts turn instead of the tire; Turn the nuts counterclockwise until they come off. Repeat this step for all lug nuts and completely remove the nuts; Place the new tire on the hub, carefully aligning the tire rim with the wheel bolts. Install the lug nuts and tighten them by hand until all nuts are concealed. At this point, the tire replacement is complete. In addition to the model, the following common data is also marked on the tire: Tire cord material: Indicated by Chinese pinyin, such as M-cotton cord, R-rayon cord, N-nylon cord, G-steel cord, ZG-steel radial cord tire. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under specified conditions. Letters A to Z represent the certified speed ratings of tires from 4.8km/h to 300km/h. Commonly used speed ratings include: Q: 160km/h; H: 210km/h; V: 240km/h; W: 270km/h; Y: 300km/h; Rim specification: Indicates the rim specification compatible with the tire for practical use, such as "Standard rim 5.00F".

16

3

Share

What is the maximum speed limit for motor vehicles when passing through sharp curves?

At what tire pressure level should a car be inflated?

Where is the BMW Spare Tire?

What are the speed limits for the four lanes on a highway?

How often should the Mazda 3 transmission fluid be changed?

What are the reasons for insufficient coolant flow P00B7?

What is the tire size of the Tiggo 5x?

Is SAE5w40 a Fully Synthetic Engine Oil?

What Does It Mean When the Airbag Light in Santa Fe Is On?

What to Do When You Run Out of Gas While Driving on the Road?

How to Exit Navigation in Tiguan?