What is the maximum speed for fourth gear?

What are the symptoms of chassis abnormal noise?

The symptoms of chassis abnormal noise are as follows: Universal joint failure of the drive shaft: It may be caused by a broken dust cover or oil leakage that was not repaired in time. The solution is to replace the new universal joint of the drive shaft. Interference between components: It may be caused by collision or the installation of other equipment, which causes mutual influence between two components. The solution is to repair or replace the relevant components to eliminate interference. Loose bolts or nuts: It may be caused by long-term driving on roads with poor conditions, natural loosening of bolts, improper disassembly and installation that damages the bolts, insufficient tightening torque, or incorrect bolt specifications. The solution is to tighten or replace the bolts and nuts.

18

4

Share

What does it mean that parking is not allowed in Subject 2 test?

From the beginning to the end of the Subject 2 test, parking is not allowed on the way, and points will be deducted for violation if parking occurs. Before the car is completely parked in reverse parking, the direction can be adjusted to regulate the size on both sides. Here is the relevant information: Precautions for reverse parking: When the car is driven to the starting position, the distance between the car body and the line, the car body should press the white line on the right front of the garage, but not exceed it. When reversing, pay attention to the line point, turn the steering wheel to the end, and watch the garage point from the rearview mirror. After the car enters the garage, it must be straightened and the steering wheel must be returned to the center, do not turn left or right. Do not reverse too much after entering the garage, stop immediately after entering. Precautions for parallel parking: When the car is driven to the test position, the car body must not exceed the white line. The distance between the car body and the edge of the garage, and the distance between the car body and the garage should be adjusted properly, not too close to the garage, at least the rear wheel of the car should exceed the edge line of the garage. Pay attention to the line when turning the steering wheel.

11

1

Share

What is the passenger limit for sedans?

Sedans are generally designed to seat 5 people, including the driver. Exceeding 5 people including the driver is considered overloading. Penalties for sedan overloading: For example, if the vehicle is overloaded with passengers, penalties are imposed as follows: exceeding the approved passenger capacity by less than 20% results in a fine, exceeding by 20% to less than 50% results in a fine, and exceeding by 50% or more results in a fine. Sedan overloading standards: Sedans can generally accommodate five passengers, and carrying six would constitute overloading. If the overload reaches 20%, or if cargo is carried in violation of regulations when exceeding the approved passenger capacity by 20%, corresponding fines will be imposed.

3

4

Share

How Many Pieces Are There in the Rear Brake Pads?

A set of foot brake rear brake pads consists of 4 pieces, while the hand brake has a separate set of 2 pieces. Function of Brake Pads: Brake pads, as the name suggests, are used for braking. In a car's braking system, brake pads are the most critical safety components. The effectiveness of all braking actions is decisively determined by the brake pads. Good quality brake pads act as protectors for both the driver and the vehicle. Structure of Brake Pads: Brake pads are generally composed of a steel plate, an adhesive heat insulation layer, and a friction block. The steel plate is coated to prevent rust, and the coating process is monitored using an SMT-4 oven temperature tracker to ensure the temperature distribution during coating meets quality standards. The heat insulation layer is made of non-heat-conductive materials, designed to insulate heat.

8

3

Share

What Causes Car Window Rattling Noises?

Car window rattling noises can be caused by the following reasons: 1. Aging of the window glass sealing rubber strip. Aging rubber strips are the most likely cause of window glass rattling noises. If the noise occurs in a new car, there is no need to immediately replace the rubber strip. Simply purchase a lubricant online, apply it evenly on the rubber strip, and then repeatedly raise and lower the window a few times to see if the noise diminishes. If the rubber strip is severely aged, it is best to replace it directly. 2. Debris in the window glass guide rail. The gaps in the sealing strips of the window slot can easily allow dust and particles to enter during the window raising and lowering process, which can cause rattling noises due to window glass vibration. If dust and particles accumulate over time, they can damage the lifting motor, leading to rattling noises and even affecting the window's raising and lowering function. 3. Loose screws or clips. When driving on bumpy roads, rattling noises from the car window may be caused by loose internal fastening screws or clips of the window glass, including glass fixing screws, lifting guide rail fixing screws, door trim clips, and other internal screws of the door trim.

4

5

Share

Do motorcycles need to follow directional markings?

Motorcycles are classified as motor vehicles and must follow directional markings. Motorcycle traffic regulations: Motorcycles must always keep to the right side of the road under any circumstances, as all motor vehicles are required to drive on the right side. Failing to do so would violate fundamental traffic laws. However, this right-side driving rule refers to vehicle direction and lane regulations, not permission to drive arbitrarily in the right lane. Reasons for motorcycles keeping right: Lane guidance: Urban roads typically have multiple lanes, with vehicles in the right lane generally moving at slower speeds. This arrangement enhances motorcycle safety to some extent and avoids disrupting normal traffic flow for other vehicles. Traffic flow management: Without rules, there would be chaos. Random lane usage would cause congestion, while keeping right improves traffic efficiency and strengthens management.

11

3

Share

What is the maximum speed for fourth gear?

What are the symptoms of chassis abnormal noise?

What does it mean that parking is not allowed in Subject 2 test?

What is the passenger limit for sedans?

How Many Pieces Are There in the Rear Brake Pads?

What Causes Car Window Rattling Noises?

Do motorcycles need to follow directional markings?

Is the Temporary License Plate Number the Same as the Official License Plate Number?

What are the conditions for an engine to start?

What is the method for changing brake fluid?

What Causes a Modified One-Button Start to Fail to Ignite?