What is the introduction to automatic transmission gears in cars?

1 Answers
MatthewMarie
07/29/25 7:58pm
Automobile automatic transmission gears are introduced as follows: 1. P gear is the parking gear, used for long-term parking of the vehicle; 2. R gear is the reverse gear, engaged when the vehicle needs to move backward; 3. N gear is the neutral gear, engaged when the vehicle is parked for a short time without turning off the engine; 4. D gear is the drive gear, when the gear lever is placed in D gear, the vehicle will automatically switch gears based on throttle opening and speed data; 5. S gear is the sport mode, making the vehicle drive more sporty; 6. M gear refers to the manual mode, when the gear lever is engaged in M gear, gear shifting is completed manually by the driver; 7. L gear is the low-speed gear.
Was this review help?
5
3
Share
More Forum Discussions

Will a Spare Tire Lose Air Over Time?

Spare tires can lose air over time. Here are some precautions for using a spare tire: 1. Replace an unused spare tire promptly: Tires are rubber products, and prolonged storage can lead to aging. Typically, the aging period for tires is about 4 years, so spare tires should be replaced after this period. 2. Regularly inspect the spare tire: Inspection mainly involves checking tire pressure, wear, and cracks. Replace the tire before the tread wears down to the wear indicator line. If there are fine cracks on the tire sidewall, avoid using it for long-distance or high-speed driving, as the sidewall is thinner and more prone to blowouts at high speeds.
7
1
Share

What Causes Severe Wear on the Inner Side of Front Wheels?

Severe wear on the inner side of a car's front wheels is caused by incorrect wheel alignment or long-term lack of tire rotation. Among these, improper front wheel camber angle and toe-in can lead to uneven wear on the front wheels. When such wear occurs, it is essential to promptly perform wheel balancing or four-wheel alignment and inspect the relevant wheel hubs and bearings. Severe wear on the inner side of front wheels can manifest in the following situations: 1. Wear on the center of the tire tread. 2. Wear on both shoulders of the tire tread. 3. Wear on the inner or outer side of the tire tread. 4. Sawtooth-like wear on the tire tread. 5. Wave-like or disc-like wear on the tire tread. 6. Localized wear on the tire tread.
15
2
Share

Why Can Gasoline Make a Car Run?

Gasoline combustion converts chemical energy into internal energy, which is then transformed into mechanical energy to propel the vehicle. Here is a detailed explanation: 1. Introduction One: A gasoline engine is an engine that uses gasoline as fuel to convert internal energy into kinetic energy. 2. Introduction Two: Due to gasoline's low viscosity and fast evaporation, a fuel injection system can spray gasoline into the cylinder. After compression reaches a certain temperature and pressure, the spark plug ignites it, causing the gas to expand and perform work. 3. Introduction Three: Gasoline engines are characterized by high rotational speed, simple structure, lightweight, low cost, smooth operation, and ease of maintenance and repair.
19
3
Share

Is there a regulation on the distance between front and rear parking?

There is no explicit regulation on the distance between front and rear parking. When stopping at a red light, you should maintain a distance from the vehicle in front that allows you to steer out if needed. During the process of slowing down and stopping, observe the situation behind you through the rearview mirror. If you notice a vehicle behind that cannot stop in time, you can immediately move away from the danger zone. During traffic jams or slow-moving traffic, large vehicles often leave a gap in front due to their slow acceleration. Small vehicles should avoid getting too close or squeezing into this gap, as the blind spot in front of large vehicles may lead to accidents. Below is a detailed introduction about it: 1. Introduction one: According to the laws of mechanics, a vehicle will continue to move forward for a certain distance during the time it takes to come to a complete stop from motion. 2. Introduction two: If the distance between the vehicle and the one in front is too close, it is very easy to collide with the front vehicle, causing a rear-end accident.
11
1
Share

Can the damage to the front windshield be covered by insurance?

According to the exclusions stipulated in the auto damage insurance clauses, insurance companies are not liable for compensation in cases of glass breakage alone, body scratches without obvious collision marks, or separate damage to the sunroof and rearview mirrors. However, if you have purchased separate glass breakage insurance, compensation can be provided for standalone glass breakage. The separate glass breakage insurance covers situations where only the windshield and window glass (excluding headlights and mirror glass) of the insured vehicle are damaged, and the insurance company is responsible for compensation. Below are detailed explanations regarding this: 1. Explanation one: Non-sunroof glass damage. Many modern cars come with sunroofs, but damage to the sunroof is not included in the separate glass breakage insurance. 2. Explanation two: Non-glass film damage. Many car owners like to apply window films to their car windows, but the separate glass breakage insurance specifically covers only the car window glass and does not include the film.
17
2
Share

What are the effects of having different front and rear tires?

Having different front and rear tire sizes can affect the vehicle because varying tire specifications between the front and rear axles can lead to differences in grip or cause variations in the outer diameter of the tires, resulting in handling or mechanical issues, especially in four-wheel-drive vehicles. Here is a detailed introduction about it: 1. Introduction one: The purchased tire specifications must be consistent with the original tires equipped on the vehicle. If there is a need to change the tire specifications, it is essential to go to a professional modification shop for tire upgrades or consult the automobile manufacturer. 2. Introduction two: Generally, it is recommended to check the tire pressure at least once a month for most cars, and pay attention to adjusting the tire pressure with each change of season. The ideal times for adjustment are in November and May. By November, winter has basically set in, and tire pressure usually decreases, so slight adjustments should be made.
7
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.