What is the introduction about Volkswagen?

What is the timing alignment method for Jinbei CG14?

Before adjusting the ignition timing, the contact gap must be adjusted to a range of 0.35 to 0.40 millimeters. Slowly rotate the crankshaft. When a hissing sound is heard, it indicates that the first cylinder is in the compression stroke. Open the inspection hole cover on the flywheel housing and then slowly rotate the crankshaft again. Loosen the fixing screw of the distributor housing. Rotate the housing along the direction of the distributor shaft until it is in the closed position. Turn on the ignition switch until sparks stop. Reinstall the distributor rotor. Insert the high-voltage wire of the first cylinder into the wire hole on the distributor cap aligned with the conductive piece of the distributor rotor. Insert the high-voltage wires of the other cylinders in a clockwise direction. Start the engine and let it run until it reaches normal operating temperature. Suddenly accelerate. If the engine emits a brief and slight knocking sound and it immediately disappears, the ignition timing is appropriate.

17

0

Share

When Can a Beginner Drive Alone?

Beginners can drive alone immediately after obtaining their driver's license, but they are not allowed to drive on highways alone during the probationary period. They must have a driver with a corresponding or higher-level license in the passenger seat to guide them. Below are specific details about the driver's license: Probationary Period: The probationary period for a C1 driver's license is one year. After this period, there is no need to review or renew the license at the vehicle management office; the license can continue to be used. License Validity Period: The initial driver's license is valid for six years. Ninety days before the six-year validity period expires, the license must be renewed at the vehicle management office. License Points: A driver's license has a total of 12 points. If caught violating traffic rules, points will be deducted based on the severity of the violation. The points reset every 12 months from the date the license was issued. License Revocation: If a driver accumulates 12 points within a single point cycle, their license will be revoked, and they must reapply and retake the subject four exam.

12

0

Share

Can a car with modified body kit pass the annual inspection?

Modifying the body kit of a car will prevent it from passing the annual inspection. Here are the relevant details: 1. The new "Road Traffic Safety Law" clearly stipulates that no unit or individual may assemble a motor vehicle or alter the structure, construction, or characteristics of a motor vehicle without authorization. The structure of a vehicle includes the body color, length, width, height (four rigid standards), and the relevant technical parameters of the engine. 2. Before modifying a licensed car, the owner must register and declare the modification to the vehicle management office. The modification can only proceed after the technical report is reviewed and approved by the vehicle management office. After the modification is completed, the owner must also complete the modification change procedures at the vehicle management office. 3. Whether a vehicle modification is legal depends on whether the vehicle matches the photo on the driving license and whether it complies with the factory technical parameters. If it does not match, the vehicle will not pass the annual inspection.

20

2

Share

What Does the Flashing Light on a Vehicle Mean?

The double flash is the vehicle's hazard warning light. Traffic regulations state that in the event of a breakdown or accident on the highway, the hazard warning flashers should be activated, and at night, the width indicator lights and tail lights should also be turned on. When the light switch is turned to the first position, the small lights that illuminate both front and rear are the width indicator lights. These indicate the width of the vehicle to alert oncoming and following vehicles. The double flash lights are emergency lights. Once activated, the small lights on both sides will flash simultaneously to alert passing vehicles to pay attention to safety. While driving on the road, if you see a slowly moving S-shaped vehicle with double flash lights, it means the vehicle requires assistance or help. Therefore, if you frequently drive on the road, you should pay more attention to such situations. In other words, the double flashing lights serve as a four-way alarm signal. It indicates that the vehicle has a minor driving issue, cannot accelerate or speed up normally, and alerts the following vehicles to drive safely and yield appropriately. It also reminds traffic police on the road not to treat it as a traffic violation, as the vehicle is experiencing a minor malfunction and is driving at a reduced speed.

7

3

Share

Can the Kawasaki H2 be registered for license plates?

The Kawasaki H2 is divided into a track version and a street version. The track version cannot be registered for license plates in China, while the street version can be registered domestically. To register for a license plate, you need to bring your ID card, vehicle certificate, the triplicate car purchase invoice issued by the 4S store, the positive and negative tax book obtained after paying the vehicle purchase tax, insurance policy, compulsory insurance policy, and temporary residence permit for non-local residents. The registration of a new vehicle must be processed by the vehicle management office. After submitting the required documents and materials, pay the fees, and drive the vehicle to the vehicle management office for an inspection. Some vehicles are exempt from inspection and can be directly examined. Generally, the external inspection involves checking the engine number and chassis number. After the inspection, you can select a license plate in the vehicle management office lobby. The main function of a license plate is to identify the vehicle's location area, and it can also be used to look up the vehicle's owner and registration information based on the license plate.

2

1

Share

What causes the steering wheel noise in Audi A6?

Audi A6L steering wheel noise when turning may be caused by: aging of the tie rod end ball joint; leaking of the steering gear dust cover; or contaminated power steering fluid. Below is relevant information about power steering systems: 1. Mechanical hydraulic power steering system: The mechanical hydraulic power steering system consists of a hydraulic pump, pipelines, and oil cylinder. To maintain pressure, the system always remains operational whether steering assistance is needed or not, resulting in higher energy consumption, which is one reason for resource consumption. This system is commonly used in economy cars. 2. Electro-hydraulic power steering system: The electro-hydraulic power steering system overcomes the shortcomings of traditional hydraulic power steering systems. Its hydraulic pump is no longer directly driven by the engine belt but uses an electric pump instead. All its working conditions are calculated by the electronic control unit based on signals such as vehicle speed and steering angle to achieve the optimal state.

12

4

Share

What is the introduction about Volkswagen?

What is the timing alignment method for Jinbei CG14?

When Can a Beginner Drive Alone?

Can a car with modified body kit pass the annual inspection?

What Does the Flashing Light on a Vehicle Mean?

Can the Kawasaki H2 be registered for license plates?

What causes the steering wheel noise in Audi A6?

What is the reason why the Kia K3 air conditioner sometimes cools and sometimes does not?

What to Do When the Automatic P Gear Won't Move?

Which MINI model is a convertible?

What Causes the Smell of Gasoline When Starting a Car?