What is the installation method for the rear camera of a dash cam?
3 Answers
The installation method for the rear camera of a dash cam is: 1. The wiring inside the car is the same for both - route the power cable along the gap between the windshield and the roof liner, between the passenger side body panel and the roof liner, and between the rear seats and the roof liner, tucking it along the edges; 2. For the rear installation, one method is to mount the rear camera at the top center of the rear windshield, while the other involves routing the cable through the trunk, along the trunk edge, and then mounting it on the license plate light cover, adjusting the angle as needed. A dash cam is a device that records images, sounds, and related information during vehicle operation. After installation, it can record the entire driving process in video and audio, providing evidence for traffic accidents.
As a seasoned driver with over a decade of experience, I've gained some insights on installing rear cameras. First, find a spot at the top of the rear windshield, clean the surface thoroughly, and firmly attach the camera. Then, use wiring tools to tuck the cable along the roof lining seam all the way to the front dashboard for connection to the main unit. Be careful not to let the wiring press against airbags or wire harnesses, as it could compromise driving safety. During testing, use a mobile app to calibrate the angle, ensuring the view covers the entire lane. I once didn't plan the wiring properly, leaving it exposed—wind and rain damaged it, so I recommend using waterproof tape to wrap the wiring path and extend the equipment's lifespan. Always check for stability before driving to avoid mid-trip loosening and blurry footage, which would render the installation pointless.
I was quite nervous when I first got my dash cam, especially about installing the rear camera, but I figured it out through trial and error. After reading the manual, I chose a high spot on the inside of the rear windshield, cleaned it, and stuck the camera firmly. When routing the cable, I carefully tucked it into the rubber seal gap along the roof, following the seam step by step toward the front main unit. After connecting, I powered it on to test and checked if the image alignment was correct—no deviation meant it was good to go. Don’t rush or pull the cable too hard; beginners might accidentally snap the connector. My first attempt failed because the rear view range was misaligned, so I had to reattach it, wasting some time, but I still saved on installation fees. Remember to route the wiring away from electronic interference sources, like near the audio system, to avoid screen distortion when playing music. A few more tries, and you’ll get the hang of it.
