What is the installation method for the Jetta rear axle sleeve?
1 Answers
The installation method for the Jetta rear axle sleeve is: 1. Use a wrench to secure the rear axle. The brake oil pipe is connected to the rear axle, and the pipe has a fixed clip. Use a hammer to slightly bend the clip for easier screw tightening, being careful not to break the oil pipe; 2. Hammer the outer iron ring of the sleeve inward until flat, carefully observing that a small part of the iron ring protrudes from the sleeve and rear axle; 3. While hammering, be cautious not to pile up the iron ring, as it may get stuck on the rear axle and be difficult to remove. If the iron ring piles up, use an angle grinder to flatten it, then remove the sleeve. Repeat the above steps for installation. Taking the Jetta VA3 as an example, this car is a compact model under FAW, with body dimensions of 4501mm in length, 1704mm in width, and 1469mm in height, and a wheelbase of 2604mm.