What is the installation method for the Baojun 530 footrest?

1 Answers
LaRiver
07/30/25 3:45am
The installation method for the Baojun 530 footrest is: 1. Locate the mounting bracket holes on the vehicle chassis; 2. Secure the bracket with screws; 3. After fixing the bracket, loosen the nuts on the back of the footrest; 4. Place the footrest on the bracket, align the studs on the footrest with the holes on the bracket, and adjust the position of the footrest; 5. After adjusting the footrest, tighten all the screws. The 2020 Baojun 530 has dimensions of 4695mm in length, 1835mm in width, and 1750mm in height, with a wheelbase of 2750mm. The overall design continues the rugged and bold style, featuring a new dot-matrix star grille and a continuous LED 'Future Eye' daytime running light that appears dynamic and futuristic. It is equipped with a 1.5T turbocharged engine with a maximum power output of 108kW.
Was this review help?
4
0
Share
More Forum Discussions

Does driving at low speed consume more fuel than high speed?

For the same distance, driving at low speeds consumes more fuel compared to driving at high speeds. This is because the vehicle's speed affects the fuel combustion rate; lower speeds result in lower combustion efficiency, leading to higher fuel consumption. When driving at high speeds, fuel burns more completely in the engine, ensuring sufficient power for high-speed travel. Typically, highways are flat and obstacle-free, allowing for steady-speed driving, which naturally reduces fuel consumption. In contrast, low-speed roads are often complex, congested, or involve frequent stops and starts, with many intersections and the need to yield to non-motorized vehicles or pedestrians. These conditions require frequent deceleration and acceleration, inevitably increasing fuel consumption. Vehicle fuel consumption is directly influenced by five major factors: driving habits, the vehicle itself, road conditions, natural wind, and environmental temperature. Specific factors that increase fuel consumption include: Driving habits: Aggressive driving behaviors such as sudden acceleration, frequent overtaking, and not easing off the throttle before a red light can raise fuel consumption. The vehicle itself: Vehicles with larger engine displacements generally consume more fuel because they require more power and thus more fuel combustion. Heavier vehicles also have higher fuel consumption due to the greater driving torque needed. Road conditions: Driving on unpaved roads, muddy surfaces, soft terrain, or mountainous areas increases resistance and fuel consumption. Natural wind: Headwinds or driving on windy days increase vehicle resistance, leading to higher fuel consumption. Low environmental temperatures: Cold engine blocks make it harder for fuel to atomize during startup, requiring more fuel for combustion and increasing consumption. Additionally, the engine control unit may command higher idle speeds to warm up the engine in cold weather, further raising fuel usage.
8
0
Share

What does the crossed-out bulb light on the Audi dashboard mean?

Audi's exhaust temperature is too high, and excessively high exhaust temperature can easily cause damage to the three-way catalytic converter. Below is an introduction to the car dashboard: 1. Car dashboard: The car dashboard is a device that reflects the working conditions of various vehicle systems. Common indicators include the fuel indicator, washer fluid indicator, electronic throttle indicator, front and rear fog light indicators, and warning lights. 2. Tachometer: The tachometer is generally located on the instrument panel, placed symmetrically with the speedometer. The tachometer operates based on magnetic principles, receiving pulse signals generated when the primary current in the ignition coil is interrupted. This signal is then converted into a displayable RPM value. The faster the engine speed, the more pulses the ignition coil generates, and the higher the RPM value displayed on the gauge.
15
1
Share

Is It Safe to Drive While Wearing Headphones to Listen to Music?

It is acceptable to drive while wearing headphones to listen to music, but it is important to choose the appropriate situations. There are certain scenarios where listening to music is not advisable, such as during rain, snow, fog, or when visibility is poor, as it may impair the driver's senses, induce impatience, and compromise road safety. Below are some illegal actions to avoid while driving: 1. Navigation Route: If navigation is required for your trip, plan the route in advance. If you need to change the route suddenly while driving, pull over to a safe spot or parking space that does not obstruct traffic, plan the new route, and then continue driving. 2. Phone Calls: For important calls, use the hands-free function or a Bluetooth car headset to answer or make calls. This ensures safety and avoids penalties from traffic police. 3. Avoid Using Regular Headphones: Using standard over-ear or in-ear headphones for phone calls or listening to broadcasts is also illegal and can result in fines from traffic police.
17
2
Share

What are the reasons for oil burning in the Q7?

Here are the specific reasons for oil burning in the Q7: 1. Worn valve seals: The valves are designed to prevent oil from leaking into the combustion chamber, but over time, they can wear out or age. Severe wear can affect the sealing performance of the valves, making oil burning more likely. 2. Excessive piston clearance: With prolonged use of the vehicle, carbon deposits from incomplete combustion can accumulate on the piston rings. If not cleaned for a long time, this can widen the gap between the piston rings and the cylinder block, allowing oil to enter the combustion chamber and cause oil burning. In severe cases, it may even lead to engine seizure. 3. Driving habits: Frequent rapid acceleration and prolonged high-speed driving can easily damage the lubricating oil film, leading to poor engine lubrication and wear on certain components, which also increases the likelihood of oil burning. 4. Excessive oil level: If the oil level is too high and exceeds the maximum mark, the excess oil can easily enter the combustion chamber (due to excessive internal pressure) and form gummy carbon deposits.
16
2
Share

Can a Diesel Engine Still Be Used After Water Intake?

Diesel engines cannot continue to be used after water intake. Below are the specific impacts of water entering a diesel engine: 1. Cylinder Block Damage: Since water cannot be compressed like gas, the engine's piston movement during operation can cause the connecting rods to bend or break. If the air filter is severely flooded, the broken connecting rod may be ejected and pierce the cylinder block, damaging the vehicle. 2. Explosion Risk: If water accidentally enters the car engine, it increases intake resistance and fills the combustion chamber, preventing the spark plugs from igniting. Attempting to restart the engine under these conditions can easily lead to cylinder explosion.
14
1
Share

Can I get my license plate on the same day I pick up my car at the 4S store?

You can get your license plate on the same day you pick up your car at the 4S store. Here is some information about vehicle license plates: 1. Introduction: License plates, commonly known as car plates, are panels hung on the front and rear of the vehicle. They are usually made of aluminum, iron, plastic, or paper, and display the vehicle's registration number, registration area, or other relevant information. 2. Function: License plates serve as a numbering and information registration system for vehicles. Their main purpose is to identify the region to which the vehicle belongs and to trace the vehicle's owner and registration details through the plate number. 3. Temporary License Plates: Temporary license plates are issued by the vehicle management department of the public security bureau when a car has not yet been officially registered due to pending procedures. Temporary plates have time and regional restrictions.
5
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.