What is the installation method for a motorcycle throttle cable?

[VanAlaina]

The installation method for a motorcycle throttle cable is as follows: 1. Pass the throttle cable through the carburetor upper cover, place the spring over the throttle cable, then extend the throttle cable through the throttle valve hole, pull it out from the adjacent slot and wind it all the way to the bottom, finally placing the head of the throttle cable into the groove at the bottom of the throttle valve; 2. When installing the throttle valve into the carburetor, ensure that the small beveled side of the throttle valve faces the idle screw, and the long groove aligns with the protruding point inside the carburetor before tightening the cover. Both cables on the motorcycle lead to the throttle grip on the right side of the handlebar. The top one is the throttle cable, responsible for controlling the throttle valve and needle valve, while the adjacent one is the accelerator pump cable, which allows the carburetor to inject a burst of fuel into the venturi during rapid throttle opening to enhance acceleration performance.