What is the ignition sequence of the Xiali 7101?

[Cinna]

The ignition sequence of the Xiali 7101 is 1-2-3, and the distributor rotates clockwise. Adjustment method without a timing light: First, adjust the distributor contact gap to the appropriate level as required. Locate the top dead center position of the first cylinder's compression stroke. Remove the high-voltage wire of the first cylinder. Use a spark plug socket to remove the first cylinder's spark plug, then block the spark plug hole with your thumb or a cloth. Turn the engine crankshaft until you feel resistance in the cylinder. Slowly rotate the crankshaft while observing to align the timing marks. Adjust the distributor until the contacts close. Once all the above steps are completed, turn on the ignition switch, loosen the distributor housing fixing screw, and rotate the distributor housing to close the breaker contacts. Timing light adjustment method: Start the engine and warm it up to normal operating temperature. Connect the two black clips of the timing light to the positive and negative terminals of the battery, and attach the sensor to the high-voltage wire of the first cylinder. Adjust the engine speed to normal idle, then use the timing light to illuminate the timing belt pulley and check if the mark on the pulley matches the manufacturer's specified angle (usually 6-10 degrees). If adjustment is needed, loosen the distributor screw, align the timing light with the timing belt pulley, then rotate the distributor (left or right) until the mark reaches the specified value. Finally, tighten the distributor screw.