What is the horsepower of the Borgward BX7's engine?

What is the minimum ground clearance of the Corolla Cross?

The minimum ground clearance of the Corolla Cross is 145mm, with a front MacPherson strut independent suspension and a rear torsion beam non-independent suspension. Advantages and disadvantages of high ground clearance in vehicles: The advantage is that higher ground clearance provides better off-road capability. Additionally, vehicles with higher ground clearance generally offer drivers a better field of vision and improved visibility. The disadvantage is that increased ground clearance raises the vehicle's center of gravity, resulting in reduced stability during high-speed driving. Advantages and disadvantages of low ground clearance in vehicles: The advantage is that lower ground clearance naturally lowers the vehicle's center of gravity, making it relatively safer and more stable on the road, especially when driving on highways, where safety is enhanced. The disadvantage is reduced off-road capability, making the vehicle more prone to scraping the undercarriage. The choice depends on the vehicle's intended use and road conditions. Generally, for urban driving with good road surfaces, vehicles with lower ground clearance are preferred for increased stability and comfort. For long-distance travel or driving in areas with poor road conditions, vehicles with higher ground clearance are recommended to enhance off-road performance and avoid undercarriage damage. Specific choices can be made based on individual needs.

12

4

Share

What Are the Effects of Leaving a Diesel Vehicle Idling Overnight?

Leaving a diesel vehicle idling overnight can lead to carbon buildup, oil leakage, and engine damage. Below is more detailed information: 1. Vehicle Idle Speed: Vehicle idle speed refers to an operating condition. When the engine runs without load, it is called idling, meaning the vehicle is in neutral gear. The engine speed during idling is referred to as idle speed. The idle speed can be adjusted by altering the throttle opening size, among other methods. Idling essentially means the engine is "running without doing work." When the engine is operating, if the accelerator pedal is fully released, the engine enters an idle state. Adjusting the idle speed should avoid sudden increases or decreases in RPM, as this can cause premature engine wear. It is best to have this adjustment performed by an automotive repair service. 2. Normal Idle Speed: When the vehicle is parked and the engine is started, the minimum stable operating speed of the engine is called parking idle speed (the process of the engine transitioning from a cold idle state to reaching the idle speed at normal operating temperature is called warming up or heating up). 3. Driving Idle Speed: When the vehicle is in gear, without pressing the accelerator pedal or releasing it while driving, maintaining the minimum throttle opening, the engine speed matches the parking idle speed. This state is referred to as driving idle speed.

17

5

Share

Where is the Camshaft Position Sensor Installed in a Car?

The camshaft phase sensor needs to face the signal wheel to collect signals, so the camshaft phase sensor is generally installed at the front end of the camshaft cover, facing the front end of the intake and exhaust camshafts. The camshaft position sensor is a sensing device, also known as a synchronization signal sensor. It is a cylinder identification and positioning device that inputs camshaft position signals to the ECU and serves as the main control signal for ignition. Camshaft Position Sensor Removal Method: First, it is recommended to disconnect the negative terminal of the battery before removing the sensor. Then, release the camshaft position sensor (CMP) connector from the bracket and disconnect the connector. Next, release the camshaft position sensor (CMR) wiring harness from the clip. Finally, unscrew the bolt securing the camshaft position sensor (CMP) and remove the sensor. Camshaft Position Sensor Installation Method: First, clean the camshaft position sensor and the mating surface. Then, secure the camshaft position sensor (CMP) by installing the bolt and tightening it to 10N.m. Next, connect the camshaft position sensor (CMP) connector and secure it to the bracket. Finally, reconnect the battery's ground terminal to complete the installation.

19

2

Share

What Driver's License is Required to Drive a Medium-sized Passenger Vehicle?

Medium-sized ordinary passenger vehicles require a B1 or higher-level driver's license to operate. The standard for medium-sized passenger vehicles is that they do not exceed 6 meters in length and have a rated passenger capacity of 10 (inclusive) to 19 (inclusive) people. The requirements for obtaining a B1 driver's license are: the applicant must be between 21 and 50 years old; must have held a C1 driver's license for more than three years; and must not have any record of accumulating 12 penalty points in the current scoring cycle or the most recent scoring cycle before applying for the B1 license upgrade. Regulations stipulate that the application for upgrading to a B1 driver's license can only be processed at the local vehicle management office in the driver's registered residence, not in other locations. Holders of a B1-level driver's license are permitted to drive not only the corresponding vehicle types but also C1 and M vehicle types. B1 license holders are required by regulation to undergo an annual review, which mainly involves education and a physical examination. However, if no penalty points are accumulated during the scoring cycle, the annual review for that year can be waived.

15

5

Share

How to Connect Audi CarPlay?

In the settings of your iPhone, locate the access permissions, enter the interface, and enable the CarPlay function. Enter CarPlay, then you will enter the connection interface, use a USB cable to connect your phone and the car's system. On your phone, click to allow "MyLink", then enable Siri at the same time, after which CarPlay will be connected.

3

5

Share

What number should I call for one-touch vehicle moving service?

Call 114 for vehicle moving (limited to service-enabled areas and vehicle owners): Simply dial 114, provide the license plate number and location of the vehicle that needs to be moved to the operator, and the call will be directly transferred to the owner's mobile phone without revealing their number. Dial 114 information service hotline: 114 cannot directly provide the owner's phone number. After providing the license plate number and location to the operator, the call will be transferred to the owner's phone without disclosing their number. Upon dialing 114 and stating the license plate number, 114 will transfer the call to the owner. To better protect the owner's privacy, the phone number is only transferred, not disclosed. However, this service requires the owner to register their mobile number and license plate number with China Unicom in advance. If not registered, 114 cannot assist. Call 122 to contact traffic police: Dial the 122 emergency hotline, provide the license plate number of the obstructing vehicle, and the traffic police will contact the owner to request moving the vehicle. As a traffic accident emergency number, 122 also offers this public service function. Upon receiving reports of blocked vehicles, 122 will dispatch traffic police from the relevant jurisdiction to contact the obstructing vehicle owner.

2

5

Share

What is the horsepower of the Borgward BX7's engine?

What is the minimum ground clearance of the Corolla Cross?

What Are the Effects of Leaving a Diesel Vehicle Idling Overnight?

Where is the Camshaft Position Sensor Installed in a Car?

What Driver's License is Required to Drive a Medium-sized Passenger Vehicle?

How to Connect Audi CarPlay?

What number should I call for one-touch vehicle moving service?

How to Read the Date on Japanese Imported Car Glass?

Can I Check My Vehicle's Compulsory Traffic Insurance Myself?

Do I have to repair my car at a designated repair shop when filing an insurance claim?

Is Modifying the Front Grille Illegal?