What is the Honda Lingpai Navigation System Installation and Removal Tutorial?
3 Answers
Honda Lingpai Navigation System Installation and Removal Tutorial: 1. Remove the button panel and air vents on the center console; 2. After removing the panel, disconnect all connecting wires, loosen the screws, and remove the single-disc CD player by disconnecting its connections; 3. Install the new navigation device in the original center console position using screws and clips; 4. Reassemble by following the removal steps in reverse. The Honda Lingpai is a strategic mid-size sedan under GAC Honda, with dimensions of 4664mm in length, 1750mm in width, and 1505mm in height. The Honda Lingpai is equipped with a 1.0T turbocharged engine, delivering a maximum power of 90 kW and a maximum torque of 173 Nm, paired with either a CVT continuously variable transmission or a 6-speed manual transmission.
I remember disassembling the Honda Lingpai's navigation system—I've done it a few times myself. From a safety perspective, here's what to note: First, always disconnect the vehicle's power supply—remove the negative terminal of the battery to prevent short circuits and electrical damage. Next, the navigation unit is usually located in the center console. Carefully pry open the plastic panel using a plastic pry tool, working slowly from the edges to avoid damaging the interior trim. Then, locate the mounting screws—typically removed with a Phillips screwdriver—and keep them safe. Behind the navigation unit, you'll find power and data connectors; gently unplug them, noting their order for reassembly. After removal, clean out dust or upgrade to a new unit. It's best to wear gloves throughout the process to prevent static electricity. If you're unsure, consult a professional shop, as the Lingpai's center console is quite compact, and mistakes could trigger error codes or damage the screen. The whole process takes about 30-60 minutes. After reconnecting the battery, test all functions to ensure everything works. Safety first—don't rush into it.
As a DIY car owner, I'd like to share my experience with removing and installing the Lingpai navigation system: Prepare tools like screwdrivers and plastic pry tools, and disconnect the negative battery terminal first to prevent accidents. When removing the center console panel, start prying from the bottom and proceed slowly without using excessive force, otherwise the clips may break. The screws are hidden in the interior gaps; after locating and removing them, the head unit will be exposed. Unplug the power and GPS connectors at the back. When installing the new navigation system, reverse the process, making sure each connector is properly seated and not mixed up. Beginners are advised to watch online videos or refer to manuals, as Lingpai models vary—older and newer versions have different interface locations. Stay patient throughout the process; it takes about half an hour, but remember to start the engine afterward to test if the navigation works properly. Don’t force it if you lack the right tools, as this may scratch the panel or cause small parts to go missing.
