What is the ground clearance of the Outlander?

2 Answers
SanLena
07/25/25 3:18pm
The ground clearance of the Outlander is 215mm. It is equipped with a 2.0T inline 4-cylinder turbocharged engine, delivering a maximum horsepower of 166ps and a maximum torque of 201Nm. The maximum power output is 122kW, with the maximum power achieved at 5000 to 6000rpm, and the maximum torque available between 1500 to 4200rpm. It is paired with a 6-speed continuously variable transmission (CVT) and features front-wheel drive. The Outlander measures 4705mm in length, 1810mm in width, and 1710mm in height, with a wheelbase of 2670mm and a curb weight of 1485kg.
Was this review help?
13
4
Share
RyleeAnn
08/11/25 9:24pm
I previously researched the Outlander's specifications in detail. The vehicle's ground clearance varies across different trims and driving modes. The standard version has an official unladen ground clearance of around 190mm, which is sufficient for most urban road curbs and ordinary country paths. If you opt for the all-wheel-drive high-end version with its multi-link suspension setup, the measured height remains above 180mm even when fully loaded. I also noticed that when activating snow mode or off-road mode, the onboard computer adjusts the AWD system to optimize passability. While it can't match professional off-road vehicles, this height design is well-balanced for an urban SUV, ensuring both handling stability and meeting occasional off-road adventure needs.
Was this review help?
18
4
Share
Expand All
More Forum Discussions

What are the precautions and details for the uphill stopping point in Subject 2 driving test?

Subject 2 driving test uphill stopping point precautions and details are as follows: Main deduction points: This item has a high failure rate, with main deduction points including the 30cm side line, 50cm stopping point, rolling back, and stalling. Pay attention to the stopping point: When entering the slope, adjust the direction and observe the highest point of the wiper to maintain a 30cm distance from the side line. While adjusting the 30cm distance, be mindful of the stopping point, as some candidates tend to get distracted during the test, focusing only on adjusting the 30cm distance and neglecting the stopping point. Pay attention to the clutch: When starting the car, slowly release the clutch. When the car shows obvious shaking, keep the clutch steady and release the brake to complete the starting operation. If the car stalls during startup, quickly press the clutch and brake firmly, because once the car stalls, poor control of the clutch and brake will inevitably cause the car to roll back.
19
1
Share

What are the reasons for the insufficient brightness of the JETOUR X70 Plus headlights?

The insufficient brightness of the JETOUR X70 Plus headlights may be due to low brightness or bulb damage. Below is a detailed introduction about JETOUR vehicles: 1. Overview: "JETOUR" is a vehicle product series launched by Chery Holding Group on January 22, 2018. It adheres to the Travel+ strategy and the concept of the Travel+ market. The name "JETOUR" is derived from "career success" in "Xunzi," meaning smooth and successful career, symbolizing users' achievement of a wonderful and happy life. 2. Vehicle Features: JETOUR has successively launched models such as the JETOUR X70, JETOUR X70S, JETOUR X90, JETOUR X70 SEV, and JETOUR X95. It places more emphasis on Travel+, with high aesthetics, spacious interiors, enhanced intelligence, and superior quality as the original intentions of product development.
4
3
Share

Is Subject 2 Difficult to Pass?

It's not difficult to pass. When taking the driving test, it depends on your mindset. If you maintain a good attitude and stay relaxed during the test, it will be very easy to pass. Don't get nervous during the test, as tension can lead to a lack of focus and result in failure. Below are the introduction to Subject 2 and some important notes: Test items for cars C1 and C2: Includes reversing into a garage, parallel parking, stopping and starting on a slope, turning at a right angle, and driving on a curved road. These five items are mandatory. Important notes for the Subject 2 test: If there is no time limit after starting the car, make sure to close the door after getting in and check whether the door light is off. This is crucial.
20
0
Share

How long does it take to complete the required hours for Subject 2?

Subject 2 requires 16 hours to complete. Below is relevant information about Subject 2: Basic Introduction: Also known as the small road test, it is part of the motor vehicle driver's license examination, referred to as the field driving skills test. The full score is 100 points, with evaluation criteria set for failing, deducting 20 points, deducting 10 points, and deducting 5 points. Meeting the requirements means passing the test; Test Content: For small cars, small automatic transmission passenger vehicles for the disabled, and low-speed trucks, the test includes reversing into a garage, stopping and starting on a slope, parallel parking, curve driving, and turning at a right angle. For small automatic transmission cars, the test includes reversing into a garage, parallel parking, curve driving, and turning at a right angle.
5
5
Share

What is the fuel consumption of the 2014 Tiggo 5?

14-year Tiggo 5 fuel consumption: The real-world comprehensive road condition crowd-tested fuel consumption is 9.22L/100KM, with a crowd-tested mileage of 14,231,537KM. The low fuel consumption is 8.14L/100KM, and the high fuel consumption is 10.31L/100KM. Here is some extended information about the Chery Tiggo: 1. Tiggo launch time: Since its launch in 2005, the Chery Tiggo has been sold to more than 80 countries, earning the trust and praise of over 400,000 users worldwide. With its excellent quality, it has become the only designated official vehicle for multiple international events. 2. Tiggo versions: The Tiggo has formed a family lineup including the Classic Edition, Elite Edition, and DR European Edition. While reshaping the high-end quality image of China's self-owned brands, it has also become a self-owned brand model recognized domestically and internationally as meeting international standards.
5
5
Share

What are the differences between the first and second sessions of Subject 3?

Two exam attempts under one appointment. Here are the specific details: Exam content for both attempts: If the first attempt is failed, an immediate retake is allowed. During the first attempt, candidates must complete the vehicle inspection walk-around and nighttime light simulation. If the first attempt is failed, these steps can be skipped during the second retake, and the exam can begin directly after preparation. If the first attempt is failed, the exam items in the parking area will start after completing the route walk-around. The starting point of the exam can be at any location along the exam route, and candidates must complete all 16 exam items before submitting their results. Key exam challenges: Mismatch between speed and gear, such as high gear at low speed or low gear at high speed, requires attention during the exam. Before shifting gears, ensure the speed is adjusted to match the intended gear. Glancing at the speedometer every eight seconds during the drive can help prevent errors.
9
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.