What is the ground clearance of the Honda CRV?

1 Answers
WestonAnn
07/29/25 11:37pm
Honda CRV's minimum ground clearance when fully loaded is 135mm, and the ground clearance when unloaded is 185mm. Here is some relevant information: 1. Minimum ground clearance refers to the distance between the lowest point of the car (excluding the wheels) and the road surface when the car is fully loaded. It indicates the car's ability to overcome obstacles (such as stones, etc.). The smaller the ground clearance, the worse the ability to overcome obstacles. 2. The larger the minimum ground clearance, the stronger the vehicle's ability to pass over obstacles or uneven ground, but the higher the center of gravity, which reduces stability; the smaller the minimum ground clearance, the weaker the vehicle's ability to pass over obstacles or uneven ground, but the lower the center of gravity, which can increase stability.
Was this review help?
3
5
Share
More Forum Discussions

How often should the spark plugs of the Vision X6 be replaced?

The spark plugs of the Vision X6 should be replaced every 20,000 kilometers. Under normal maintenance conditions, car spark plugs are typically replaced after traveling 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so it is recommended to follow the user manual. The following standards can be referred to for maintenance and replacement: platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Steps for replacing spark plugs: Open the engine hood, lift the plastic cover of the engine, and remove the high-voltage distributor wires. Mark the position of each cylinder to avoid confusion. Use a spark plug socket to remove the spark plugs one by one. While removing them, check for any external debris like leaves or dust and ensure they are thoroughly cleaned. Place the new spark plug into the spark plug hole, hand-tighten it a few turns, and then use the socket to tighten it further. Reinstall the removed high-voltage distributor wires according to the ignition sequence and secure the cover plate.
14
5
Share

How many liters of engine oil does the BMW X1 require?

The BMW X1 requires 4.5 liters of engine oil. The original factory oil brand for the BMW X1 is Shell. If you wish to change the oil during later maintenance, you can choose brands such as Shell, Mobil, Castrol, or Total. The official BMW X1 manual recommends using engine oil with the specification 5W-30. Any oil model that meets this specification parameter can be used. The viscosity of engine oil changes with temperature, so special attention should be paid to its performance under both low and high temperatures. For example, in 5W-30, the first number indicates low-temperature fluidity. 5W means it can withstand temperatures as low as -30°C. The smaller this number, the better the low-temperature fluidity, resulting in smoother cold starts for the car. The latter number represents the kinematic viscosity of the oil at 100°C. The higher the value, the better it maintains viscosity under high temperatures, which can also be understood as better lubrication performance under high-temperature conditions. The method for changing the engine oil in a BMW X1 is as follows: Wait for the engine temperature to drop, allowing the oil to flow back into the oil pan. Use a wrench to loosen the oil drain plug and place an oil pan underneath to catch the old oil until it stops flowing. Start the engine and let it run for 30 seconds to allow the oil in the main oil passage to drain out. Use a special wrench to remove the oil filter. Apply some oil to the oil seal of the new oil filter and tighten it clockwise by hand. Add the new engine oil through the oil filler cap on the engine valve cover. Generally, fill up to three-quarters of a standard oil container. Start the engine and let it run for 5 minutes, then check for any leaks around the oil drain plug and oil filter. If there are leaks, perform necessary repairs. After stopping the engine, pull out the oil dipstick to check if the engine oil level is within the standard range.
5
3
Share

How to adjust the rearview mirror on the Geely Boyue?

Geely Boyue rearview mirror adjustment method is as follows: 1. When the ignition switch is in the ACC or ON position, rotate the rearview mirror adjustment switch to L (left) or R (right) to select the mirror to be adjusted. 2. Push the rearview mirror adjustment switch left, right, up, or down to adjust the mirror. 3. After adjustment, turn the left and right rearview mirror adjustment switch to the 0 (middle) position. 4. Additional information: When the ignition switch is in the OFF, ACC, or ON position, rotate the outer rearview mirror adjustment switch knob to the upper left corner position to simultaneously fold both left and right outer rearview mirrors.
2
1
Share

Is the Haval F7x compliant with China VI emission standards?

The Haval F7x meets the China VI emission standards. Below are the relevant details: 1. Exterior: In terms of body dimensions, the length, width, and wheelbase remain consistent with the F7, measuring 4620mm in length, 1846mm in width, and 1660mm in height, with a wheelbase of 2725mm. The height is reduced by 30mm, further accentuating the coupe SUV design for a more dynamic appearance. The front fascia design is identical to the F7. 2. Interior: The Haval F7x draws inspiration from spacecraft cockpits, enhancing operational convenience while creating a highly technological cabin. 3. Powertrain: The Haval F7x will offer both 2.0T and 1.5T engine variants, paired with a 7DCT dual-clutch transmission. It delivers a maximum power of 124kW and a peak torque of 285N·m, with a combined fuel consumption as low as 6.6L per 100km.
13
4
Share

What is the tire specification of the Hyundai Elantra?

Taking the 2017 Hyundai Elantra 1.6L as an example, the 2017 Hyundai Elantra 1.6L uses Nexen Npriz AH8 series tires with a specification of 205/55/R16. The following is relevant information about tire pressure: 1. Both overinflation and underinflation of tires will affect their service life. Winter tire pressure can be slightly higher than summer tire pressure. The recommended summer tire pressure is between 2.2-2.5 bar, while winter tire pressure should not exceed 2.8 bar. Adjust the tire pressure appropriately based on the load conditions. 2. Insufficient tire inflation pressure can lead to excessive tire wear, poor vehicle control, reduced fuel economy, and may also cause wheel deformation. Therefore, tire inflation pressure should be maintained within the specified range. 3. Excessive tire inflation pressure will result in uncomfortable rides, excessive wear in the center of the tire tread, and increase the possibility of tire damage on hazardous road surfaces.
4
4
Share

How many seats does the BMW i8 have?

BMW i8 is a two-door, two-seater sports car. Here are some details about the BMW i8: The BMW i8 is a hybrid sports car equipped with a 1.5-liter turbocharged three-cylinder engine, delivering 231 horsepower and a maximum torque of 320 Nm. The engine reaches its peak torque at 3,700 rpm and its maximum power at 5,800 rpm. 2. The BMW i8 is a single-motor model, with the electric motor installed at the front. 3. The dimensions of the BMW i8 are 4,689 mm in length, 1,942 mm in width, and 1,282 mm in height, with a wheelbase of 2,800 mm.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.