What is the ground clearance of the Chery Fengyun 2?

What are the reasons for the lack of power in Reiz acceleration?

There are two main aspects to consider for the lack of power in Reiz acceleration. First, fuel supply issues: it is necessary to check whether the gasoline filter has been replaced regularly, whether there is insufficient fuel pressure (fuel pump, fuel pressure regulator sealing ring), whether the fuel pump speed regulator is overheating, or if the fuel injectors are clogged. Second, electronic throttle failure: you need to visit a repair shop to use IT-II to check the data flow during the fault to identify the problem point. Below is an introduction to the Reiz brand: Reiz (REIZ) is the domestic name for the Japanese Toyota MARK-X model. It was produced in October 2005 at Tianjin FAW Toyota Plant No. 2, sharing the production line and chassis with the Crown, and equipped with the same six-speed automatic transmission as the Crown. Production was discontinued in September 2017, with a total of 528,188 units produced.

2

5

Share

What are the symptoms of a damaged 4WD coupler in the Tiguan?

The symptoms of a damaged 4WD coupler in the Volkswagen Tiguan include poor acceleration, jerking during gear shifts, and hesitation when accelerating. Solutions for a damaged 4WD coupler: When the 4WD coupler is damaged, the issue can often be resolved by replacing the coupler oil twice. Function of the automotive coupler: The main function of the coupler in a microwave system is to divide a single microwave power signal into multiple paths proportionally, primarily for power distribution. The coupler needs to be used in conjunction with a power divider to achieve the goal of evenly distributing the signal source's transmission power across all antenna ports in the indoor distribution system, ensuring each antenna port has roughly the same transmission power.

2

0

Share

What is the reason for the non-moving dashboard needle in the Excelle?

The dashboard needle of the Excelle not moving is due to the loss of gear signal display or low battery power. You can visit a 4S store for maintenance by after-sales personnel. Different car models have varying dashboard designs, but conventional car dashboards typically include a speedometer, tachometer, oil pressure gauge, water temperature gauge, fuel gauge, and charging gauge. Relevant information about car dashboards is as follows: 1. Introduction: The dashboard (instrument-panel) is a rigid plate or structural component used to install instruments and related devices. It can be categorized into screen-type, frame-type, passage-type, and cabinet-type dashboards based on design. 2. Function: The dashboard can feature external lighting and may include an attached control panel. Available in various forms and specifications, it can be equipped with different instruments as needed or combined into an integrated unit.

16

1

Share

What are the solutions for frost on the windshield?

The solutions for frost on the windshield are: 1. Turn on the heater, direct the airflow upwards towards the windshield to increase its temperature, and press the front windshield defrost button; 2. Clean the inside of the windshield thoroughly, apply a car-specific anti-fog spray, and wipe it with a towel after the spray dries; 3. Dilute dishwashing liquid with water in a 1:6 ratio, use a towel soaked in the solution to wipe the glass, and then wipe it again with a dry towel after the solution dries. The types of front windshields include laminated glass, tempered glass, regional tempered glass, laminated tempered glass, and laminated regional tempered glass. The function of the front windshield is to block ultraviolet rays and enhance the driver's field of vision.

13

1

Share

Should You Press the Brake When Shifting Gears in an Automatic Transmission?

When shifting gears in an automatic transmission, you should press the brake. Precautions for using an automatic transmission car: 1. Keep the car in D gear when parking for a long time; 2. Shift to N gear when coasting at high speed or downhill; 3. Start the engine in gears other than P or N; 4. Push-start the engine; 5. Increase throttle to shift to a higher gear. An automatic transmission does not require the driver to manually shift gears; the vehicle will automatically select the appropriate gear based on the driving speed and traffic conditions. The gear positions in an automatic transmission car, from top to bottom, are: 1. P (Park); 2. R (Reverse); 3. N (Neutral); 4. D (Drive); 5. S (Sport mode); 6. L (Low gear).

1

4

Share

Under which automotive company is the DS brand?

DS is a brand under Citroën Automobile Company. The models under the DS brand include DS7, DS6, DS3, DS4, DS9, etc. Taking the 2021 DS7 as an example, it belongs to the compact SUV category, with body dimensions of: length 4605mm, width 1891mm, height 1626mm, a wheelbase of 2740mm, a fuel tank capacity of 60l, and a curb weight of 1580kg. The 2021 DS7 features a MacPherson strut front suspension and a multi-link independent rear suspension. It is equipped with a 1.6l turbocharged engine, delivering a maximum horsepower of 180PS, a maximum power of 133kW, and a maximum torque of 250Nm, paired with an 8-speed automatic transmission.

9

1

Share

What is the ground clearance of the Chery Fengyun 2?

What are the reasons for the lack of power in Reiz acceleration?

What are the symptoms of a damaged 4WD coupler in the Tiguan?

What is the reason for the non-moving dashboard needle in the Excelle?

What are the solutions for frost on the windshield?

Should You Press the Brake When Shifting Gears in an Automatic Transmission?

Under which automotive company is the DS brand?

How to Check the Vehicle's Emission Standard?

What is the material of Tesla's 4680 battery?

Why Does the Battery Get Hot While Charging?

Will the Battery Drain If the Car Is Turned Off but Not Locked?