What is the general seat height for 165cm?

Are there any national regulations on stock vehicles?

There are no legal regulations on the duration of stock vehicles, which generally refer to vehicles that have not been sold within 6 months after leaving the factory. Related information: 1. Outdoor stock vehicles: Exposure to sunlight accelerates the aging of the vehicle's paint and rubber seals, rain may cause electronic components to become damp, and dust can clog the vehicle's cooling system and drainage holes. 2. Indoor stock vehicles: Prolonged storage leads to battery discharge, aging of various fluids, and components such as tires becoming out-of-round due to prolonged fixed contact with the ground. 3. Long-term parking causes engine risks: The engine contains various lubrication oil passages, which can develop oil film scabs due to prolonged inactivity, potentially leading to clogged passages and severe damage to critical engine components such as piston pins and valves, resulting in significant losses for users.

19

1

Share

How to Unscrew the Coolant Cap?

To open the coolant cap, follow these steps: 1. Open the hood and locate the coolant reservoir. Turn the coolant cap counterclockwise to open it. Always ensure the vehicle is turned off and cooled down before adding coolant. Open the cap slowly to prevent steam from spraying out under high temperature, which poses a burn risk. 2. Coolant has certain corrosive properties, so avoid contact with skin and other rubber components. In case of spills, rinse immediately with clean water. Do not overfill or underfill the coolant. Typically, the coolant reservoir has level markings—fill it between the MAX and MIN marks.

3

1

Share

What is the difference between 4H and 4L?

The differences between 4H and 4L are: 1. Different modes: 4H is the four-wheel drive high-speed mode; 4L is the four-wheel drive low-speed mode. 2. Different usage scenarios: 4H is suitable for driving on snow or slippery roads, as it can prevent excessive driving force from causing wheel slip; 4L is suitable for climbing or off-road conditions, as it can better utilize the vehicle's power. The drive mode refers to the arrangement of the car's engine and the number and position of the drive wheels. Most passenger vehicles have two rows of wheels, front and rear, with the wheels directly driven by the engine to push (or pull) the car forward being the drive wheels. The basic classification standard for drive modes is based on the number of drive wheels, which can be divided into two-wheel drive and four-wheel drive.

14

4

Share

Will the seat belt camera capture the passenger seat?

Yes. The following are the penalties for not wearing a seat belt: 1. Driver not wearing a seat belt: (1) When driving on a highway, if the driver does not use the seat belt as required, a fine will be imposed and 2 points will be deducted. (2) When driving on an urban expressway, if the driver does not use the seat belt as required, a fine will be imposed and 2 points will be deducted. 2. Passenger not wearing a seat belt: According to the Road Traffic Safety Law, when a motor vehicle is in motion, the passenger in the front seat should also use a seat belt. The requirement for the passenger to wear a seat belt has been clearly stipulated in the old traffic regulations. If the passenger does not wear a seat belt, the on-duty traffic police can impose a fine on the passenger.

20

3

Share

At what mileage should piston rings be replaced in a car?

Under normal circumstances, piston rings do not need to be replaced as long as regular maintenance is performed, including frequent checks of engine oil and coolant levels in the radiator. Insufficient oil or coolant can lead to overheating and cylinder scoring, which would then necessitate piston replacement. Additional details are as follows:1. Replacement Principle: During an engine overhaul, if replacement (inspection) is required, it is recommended to use original equipment manufacturer (OEM) piston rings. According to older standards, piston rings should be replaced at 100,000 km, but modern car designs often allow them to last up to 200,000 km without replacement—a phenomenon that is not uncommon. The actual inspection should be the determining factor.2. Post-Replacement Considerations: There may be slight machining and assembly tolerances with new piston rings, resulting in increased friction between the piston and cylinder walls. After replacing piston rings, a break-in period similar to that of a new car is required, typically around 1,000 km. During this period, maintain steady speeds and avoid aggressive driving to achieve optimal performance.

8

5

Share

Can I Take the Replaced Car Tires Back by Myself?

Yes, you can, but the price you get is based on the value of waste materials. Old tires are generally recycled by auto parts markets. More extended information is as follows: 1. Tire Retreading: Tire retreading technology involves refurbishing and processing tires that have been worn out or damaged due to other reasons, making them usable again. 2. Waste Tire Oil Refining: By adding catalysts, waste tires can be refined into oil. The technology of refining waste tires into oil involves heating, pressurizing, and other methods to extract fuel from waste tires. 3. Tire Rubber Powder and Recycled Rubber: The technology for tire rubber powder and recycled rubber first involves using equipment to crush waste tires into 20~30 mesh rubber powder, followed by desulfurization treatment to soften the rubber powder into malleable recycled rubber, which can then be reprocessed into various rubber products.

16

1

Share

What is the general seat height for 165cm?

Are there any national regulations on stock vehicles?

How to Unscrew the Coolant Cap?

What is the difference between 4H and 4L?

Will the seat belt camera capture the passenger seat?

At what mileage should piston rings be replaced in a car?

Can I Take the Replaced Car Tires Back by Myself?

What Causes the Steering Wheel to Make a Clicking Sound?

What does deducting 24 points mean?

How often is the annual vehicle inspection required?

What are the reasons for the sudden increase in fuel consumption of the Tiguan?