What is the function of the buttons on the right-hand door of the Volkswagen Jetta?

1 Answers
AdalynnFitz
07/29/25 11:34pm
The buttons on the right-hand door of the Volkswagen Jetta are used to control the vehicle's window lift. Below is a detailed explanation of the various buttons in the Volkswagen Jetta: Central Control Buttons: SYNC is the dual-zone air conditioning switch. Models equipped with dual-zone air conditioning allow separate temperature control for the driver and front passenger. The Electronic Stability Program (ESP) effectively prevents loss of control such as skidding or fishtailing, and it is generally not recommended for drivers to manually turn it off. The hazard warning lights, commonly known as the emergency flashers, serve to alert surrounding vehicles to prevent rear-end collisions. The volume adjustment buttons control the multimedia volume and can also be used to skip tracks. Door Buttons: The driver's door features a rear window lock button, one-touch up/down window control switches for all four doors, an exterior rearview mirror adjustment switch, and the trunk release button located below the door handle. Ceiling Buttons: These include the welcome light, driver's reading light, front passenger reading light, interior light switch, and sunroof switch.
Was this review help?
15
2
Share
More Forum Discussions

How many kilometers can a 48-volt battery run?

How far a 48-volt battery can run depends mainly on the battery capacity and the power of the electric vehicle's motor. A 48V12A battery can run approximately 40 kilometers, a 48V20A battery can run about 60 kilometers, and a 48V24A battery can run around 80 kilometers. Below are the correct methods for maintaining a car battery: 1. Regular cleaning of the battery: During daily use, pay attention to the battery's condition. Over time, the battery may become covered with dust, powder, grease, etc. To ensure normal operation, promptly clean the dirt from the battery's panel and the positive and negative terminals to extend its lifespan. 2. Avoid prolonged parking: If the vehicle is left unused for a long time, the battery will self-discharge. Therefore, even if the car is not used regularly, it is recommended to start it once a week and take it for a short drive to keep the battery fully charged. 3. Regular inspection: The typical lifespan of a vehicle battery is 3-4 years. For high-end models with more electronic systems, the battery's lifespan may be shorter. Regular checks of the battery's charge level can help maintain it in optimal working condition.
11
1
Share

The Difference Between Cold Start and Hot Start of a Car

Here are the specific differences between cold start and hot start of a car: 1. Starting method: Cold start refers to starting the engine after it has been turned off for a period of time, during which the engine has cooled down and its temperature is much lower than the normal operating temperature, and the engine oil has mostly flowed back. Generally, the ambient temperature can be used as a measure. After the engine is turned off, it gradually cools down to below 40℃, usually taking about 2 hours. Starting the engine at this point is considered a cold start. Hot start refers to starting the engine after it has been turned off, but the engine temperature is still near the normal operating temperature, and the engine oil on the friction surfaces has not yet flowed back, with the oil film still present. 2. Impact on the car: Cold start is more damaging to the car compared to hot start, with over 80% of engine wear occurring during the cold start phase. Cold start is also more difficult and takes longer to start the car compared to hot start.
12
0
Share

What does the red triangle exclamation mark light indicate?

A triangle with an exclamation mark inside indicates a malfunction in the vehicle's general performance, components, or functions. Common causes include parking sensor failure, fuel cut-off system intervention or malfunction, external light failure, or engine oil pressure sensor failure. Solution: It is necessary to visit a 4S shop for inspection to identify the source of the fault. The exclamation mark is a common fault warning in vehicles. Besides the triangle with an exclamation mark, there are four other forms of exclamation mark warnings: a yellow gear with an exclamation mark inside, a red circle with parentheses and an exclamation mark in the middle, a yellow parenthesis with a horizontal line and an exclamation mark in the middle, and a yellow bulb with an exclamation mark. Below is a detailed analysis of these four scenarios: Automatic transmission fault: A yellow gear with an exclamation mark inside is the automatic transmission fault warning light, indicating a malfunction in the transmission or transmission fluid level below the normal range. The transmission fluid should be replaced promptly. Brake system fault: A circle with parentheses and an exclamation mark in the middle represents a brake system warning, primarily indicating brake system failure or low brake fluid level. Immediate inspection and repair of the brake system are required to avoid accidents. Tire pressure abnormality: A parenthesis with a horizontal line and an exclamation mark in the middle represents the tire pressure monitoring warning light, which illuminates when the tire pressure is too low. Check the tire pressure and restore it to the normal range. Lighting fault: A yellow bulb with an exclamation mark is the lighting fault indicator, signaling a malfunction in the vehicle's lights. Solution: Visit a 4S shop for inspection as soon as possible, or conduct a self-check focusing on commonly used bulbs such as turn signals, fog lights, and interior lights to identify the issue.
8
0
Share

What is the wading depth of the CR-V?

The wading depth of the CR-V is 300mm. The wading depth of the CR-V is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, SUVs and off-road vehicles have obvious advantages. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a reference when passing through waterlogged roads. If the air intake is below the water level when the CR-V is wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct procedures should be followed: Before driving through water, always turn off the auto start-stop function to prevent the engine from automatically restarting if the vehicle stalls in the water, which could lead to severe engine damage due to water ingestion. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at a low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, use warning water level markers, trees, or the wheels and doors of other vehicles as reference points to estimate the water depth before deciding whether to proceed. Be aware of your vehicle's safe wading depth. If the water depth exceeds half of the tire height or the engine's air intake, do not attempt to drive through. Instead, choose an alternative route.
8
2
Share

What to Do When an Automatic Transmission Car Lacks Power Going Uphill?

When an automatic transmission car lacks power going uphill, shift to the L gear. If there is no L gear, switch to manual mode and keep the gear in a lower position. If manual mode is not available, use the S gear for climbing. Climbing requires high torque output combined with power to maintain stable vehicle performance. Reasons for an automatic transmission car lacking power uphill: 1. The engine tachometer rises slowly, primarily reflecting engine power issues; 2. The engine speed increases quickly but the vehicle speed remains slow, directly indicating problems with clutch components. In such cases, it is advisable to visit a 4S shop for professional inspection and repair by qualified technicians.
19
1
Share

What brand are the original tires on the Roewe RX5?

Roewe RX5 uses different tire brands depending on the vehicle model. The high-end models are equipped with Michelin tires, while the mid-range models use Maxxis tires. Both Michelin and Maxxis tires focus on quietness and comfort. The following are the functions of car tires: 1. Support the entire weight of the vehicle, bear the load of the car, and transmit forces and moments in other directions. 2. Transmit traction and braking torque to ensure good adhesion between the wheels and the road surface, improving the car's power, braking, and passability; work with the car suspension to mitigate impacts during driving and dampen resulting vibrations. 3. Prevent severe vibrations and early damage to car components, adapt to the vehicle's high-speed performance, reduce driving noise, and ensure driving safety, handling stability, comfort, and energy efficiency.
15
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.