What is the full name of Audi?

Is the port on the ETC used for charging?

The port on the ETC is not used for charging. That port is a data interface specifically designed by the manufacturer for testing equipment. Therefore, do not use that port for charging, as it not only cannot charge but also carries the risk of damaging the ETC. The ETC is a device that can be charged via solar power. If the ETC runs out of power, there are two possible reasons: first, when it is newly installed, long-term storage and transportation time may lead to insufficient battery power; second, the solar charging panel of the ETC may be blocked by the car's heat-insulating window film, preventing the ETC from receiving solar power. The installation height of the ETC device should be no less than 1.2 meters and no higher than 2.5 meters. For small vehicles such as cars and minivans, the OBU device should be installed in the upper-middle part of the front windshield. For large vehicles like trucks and buses, it should be installed in the lower-middle part. For vehicles with factory-installed or aftermarket anti-explosion film, since the film contains metal ions that may interfere with microwave communication signals, the ETC should be installed in the microwave window area or a rectangular area of 8cm x 10cm should be cut out from the anti-explosion film.

10

5

Share

What are the effects of a faulty oxygen sensor on a car?

The effects of a faulty oxygen sensor on a car include: excessive emissions, deterioration of engine performance, stalling at idle, inaccurate engine operation, and reduced power. The function of the oxygen sensor is to control vehicle exhaust emissions, reduce environmental pollution caused by the vehicle, and improve the fuel combustion quality of the car engine. Common faults of the oxygen sensor include: oxygen sensor poisoning, carbon buildup, ceramic breakage in the oxygen sensor, burnout of the heater resistance wire, and internal wiring disconnection. Cars have a front oxygen sensor and a rear oxygen sensor: the front oxygen sensor serves as a feedback mechanism, detecting the oxygen content in the exhaust gases produced after the combustion of the air-fuel mixture in the cylinders. A high oxygen content indicates a lean mixture, while a low oxygen content indicates a rich mixture. The rear oxygen sensor checks the purification effectiveness of the catalytic converter by measuring the oxygen content in the purified exhaust gases.

1

2

Share

Where is the rearview mirror heating switch located?

The rearview mirror heating switch is located next to the exterior rearview mirror adjustment button, featuring a rectangular pattern with wavy lines. Rearview mirror heating refers to the function where, when driving in rainy, snowy, or foggy weather, the rearview mirror can be heated via electric heating wires embedded behind the mirror to ensure a clear surface. The operational steps for using the rearview mirror heating function are as follows: 1. Press the car's brake pedal to prepare for turning on the vehicle's power; 2. Press the vehicle's one-touch start button; 3. The car's dashboard lights up, indicating the vehicle's power is on; 4. Press the heating button located next to the exterior rearview mirror switch to activate it.

9

3

Share

Where is the license plate number Lu K from?

Lu K is the license plate number for Weihai City, Shandong Province. The license plate codes for various regions in Shandong Province are as follows: Lu A for Jinan, Lu B and Lu U for Qingdao, Lu C for Zibo, Lu D for Zaozhuang, Lu E for Dongying, Lu Y for Yantai, Lu G and Lu V for Weifang, Lu H for Jining, Lu J for Tai'an, Lu K for Weihai, Lu L for Rizhao, Lu M for Binzhou, Lu N for Dezhou, Lu P for Liaocheng, Lu Q for Linyi, Lu R for Heze, Lu S for Laiwu, and Lu W for provincial government agencies. License plates, commonly referred to as tags, not only indicate the region to which the vehicle belongs but also allow for tracking the vehicle's owner and registration details through the plate number. If a license plate is accidentally scratched and affects daily recognition, the owner should bring the necessary documents to the vehicle management office to apply for a replacement plate. Failure to do so may result in a 12-point deduction for a damaged or soiled license plate.

8

1

Share

What does it mean when the car's EPC light is on?

The EPC indicator light can illuminate in two scenarios: during the power-on self-test and under other circumstances. The power-on self-test is an indication that the vehicle is checking the status of all sensors before driving. Generally, if the engine is not started after powering on, the light will turn off by itself after about 3 seconds. If the EPC light remains on after the vehicle starts or illuminates under other conditions, the possible causes include faults in the engine intake system, throttle, fuel system, engine, ECU control unit, or brake lights. Below is a detailed explanation of the reasons for the EPC light illuminating under other conditions: Engine intake system fault: The EPC light will illuminate if the engine intake is obstructed or insufficient. Throttle fault: Carbon buildup is a common issue with the throttle. Additionally, dirt accumulation can affect intake, triggering the indicator light. Fuel system fault: This includes issues such as substandard fuel, degraded fuel, or poor fuel atomization. Engine fault: Insufficient engine pressure or problems with components like the intake valves can also cause the EPC light to illuminate. ECU control unit fault: Examples include interference with the vehicle's computer signals or false alarms from the computer. Brake light fault: This may involve issues like non-functioning brake lights, faulty brake switches, or brake circuit problems. Solutions for the EPC light illumination: Troubleshoot the intake system, use fuel with the appropriate octane rating, clean the throttle, etc. Remove carbon deposits from relevant components. Re-flash the ECU data. If the EPC light illuminates, the owner can first try turning off the engine and restarting it to see if the light remains on. If it does not, the issue may have been a temporary glitch. If the light stays on or frequently illuminates, the vehicle should be taken to the nearest service center for professional diagnosis and repair to eliminate potential safety hazards. The full English name of EPC is Electronic-Power-Control, which translates to electronic power control. Most people refer to it as the engine electronic stability system. The EPC system primarily includes controllers and sensors related to the powertrain. When sensor data is abnormal, the EPC system will take predefined actions to address the issue. Common EPC indicator lights are displayed in two colors: yellow and red. A yellow EPC fault light indicates that the vehicle can still be driven, but it should proceed slowly to a repair point. A red EPC fault light signifies a more serious issue, and the vehicle should be pulled over immediately, with professional assistance sought. Continuing to drive could damage core components or compromise safety.

9

2

Share

Which city does the license plate 'Hei N' belong to?

Hei N is the license plate code for Heihe City in Heilongjiang Province. The license plate codes for various regions in Heilongjiang Province are as follows: Hei A for Harbin, Hei B for Qiqihar, Hei C for Mudanjiang, Hei D for Jiamusi, Hei E for Daqing, Hei F for Yichun, Hei G for Jixi, Hei H for Hegang, Hei J for Shuangyashan, Hei K for Qitaihe, Hei L for counties and county-level cities under Harbin, Hei M for Suihua, Hei N for Heihe, Hei P for Daxing'anling Prefecture, and Hei R for Heilongjiang Agricultural Reclamation Administration Bureau. License plates, commonly known as vehicle plates, refer to the plates hung on the front and rear of vehicles. They are usually made of aluminum, iron, plastic, or paper, and bear the vehicle's registration number, registration region, or other relevant information.

3

1

Share

What is the full name of Audi?

Is the port on the ETC used for charging?

What are the effects of a faulty oxygen sensor on a car?

Where is the rearview mirror heating switch located?

Where is the license plate number Lu K from?

What does it mean when the car's EPC light is on?

Which city does the license plate 'Hei N' belong to?

How to Check if ETC is Successfully Activated?

What are the 6 non-recognition situations for hit-and-run?

Where does the G25 Changshen Expressway run from and to?

What are the reasons for the car making a clicking sound and failing to start?