What is the fuel tank capacity of the Zhonghua Junjie FRV?

2 Answers
StCole
08/29/25 8:41am
The fuel tank capacity of the Zhonghua Junjie FRV is 55 liters. It is a compact car under the Zhonghua brand. Among similar vehicles, the Nissan Sylphy has a fuel tank capacity of 55 liters, while the Volkswagen Santana has a capacity of 52 liters. If the owner wants to know the remaining fuel level, they can observe the fuel gauge on the right side of the dashboard, which is marked with E and F. When the needle is close to E, it indicates low fuel, and when it is near F, it means the fuel level is sufficient. Maintenance of the fuel tank is as follows: Drain any accumulated water and sediment from the fuel tank, and check for oil leaks at the fuel pipe joints and switches. For fuel tank caps equipped with air valves and steam valves, also check if the ventilation holes are clear. The filter screen at the fuel filler neck should be kept intact to prevent impurities from entering the tank and clogging the fuel lines during refueling. The sealing gasket on the fuel filler cap should also be intact to prevent fuel from spilling out while driving.
Was this review help?
4
0
Share
HenryLynn
09/11/25 6:05am
My old Zhonghua Junjie FRV is a 2010 manual transmission model. There's a label inside the fuel filler cap clearly stating a 55-liter capacity. It usually takes about 52 liters when the pump automatically stops during refueling. Daily city driving consumes around 8L/100km, while highway driving can reduce it to 6.5L. A reminder: don't wait until the fuel warning light comes on to refuel - the fuel pump relies on gasoline for cooling. A colleague of mine once burned out the pump core due to running too low on fuel. For long trips, filling up to three-quarters capacity is safest, as leaving some space in the tank reduces weight and saves fuel.
Was this review help?
11
0
Share
Expand All
More Forum Discussions

What Causes the Gurgling Sound from the Exhaust Pipe in Winter?

Winter exhaust pipe gurgling sounds occur because: the air-fuel mixture is too rich and not completely burned, combined with prolonged combustion time in the cylinder. When the engine begins the next power stroke, unburned combustible mixture enters the exhaust pipe along with the expelled exhaust gases. Upon encountering fresh air in the exhaust pipe, this mixture reignites, producing the gurgling sound. Methods for maintaining the exhaust pipe include: 1. Preventing water from entering the exhaust pipe interior; 2. Applying anti-rust oil inside the exhaust pipe; 3. Regularly inspecting the exhaust pipe condition; 4. Avoiding prolonged high-revving while stationary.
3
5
Share

What Causes the Clicking Sound When Turning with Winter Tires?

The reason for the clicking sound when turning with winter tires is: Low temperatures cause the tires to harden, reducing the grip limit. When turning, the tire exceeds its grip limit, resulting in slipping. The unusual noise is the sound of friction between the tire and the ground. Methods for maintaining car tires: 1. Regularly check tire pressure; 2. Remove debris from tire treads; 3. Inspect tire wear and replace them promptly if necessary; 4. Perform tire rotation. Tire rotation ensures even wear across all four tires, preventing excessive wear. The functions of tires are: 1. Supporting the entire weight of the vehicle and bearing the load; 2. Transmitting traction and braking torque to ensure adhesion between the wheels and the road surface.
16
2
Share

What is the method for replacing a car antenna?

Car antenna replacement method is: 1. Open the rear trim panel and forcefully release the two clips on the right side; 2. Slide the trim panel to the right, remove the three clips on the left side, and disconnect the antenna connector; 3. Peel back the roof lining to locate the antenna screw; 4. Use a wrench to remove the screw, take off the original antenna, install the new antenna, and reassemble everything. The function of a car antenna: It is used to receive external signals. Besides signal reception, the car antenna also serves as a static electricity discharger, releasing accumulated static electricity from the car body to protect passenger safety and the vehicle's circuitry. In some high-end cars, the antenna also has an aerodynamic function to manage air turbulence.
16
2
Share

What are the steps for starting a car on an uphill slope?

Car starting steps on an uphill slope are: 1. Press the accelerator pedal to increase engine speed while slowly releasing the clutch and holding the handbrake lever; 2. Gradually release the parking brake lever while pressing the accelerator pedal and slowly lifting the clutch pedal; 3. After the clutch is fully engaged, continue pressing the accelerator pedal to allow the vehicle to start smoothly. Precautions for manual transmission car starting: 1. Do not release the clutch too quickly, lift it slowly; 2. Press the accelerator after the engine and drive shaft are connected; 3. Gently press the accelerator at the semi-engagement point, then release the clutch; 4. Release the handbrake before starting. The principle of manual transmission vehicles is that the power input shaft is connected to the clutch, and the power transmitted from the clutch is directly passed to the gear set through the input shaft.
2
4
Share

What is the method to start a Django when the battery is dead?

Django's method to start when the battery is dead is: by kicking the starter lever for a quick start. The functions of the battery are: 1. When starting the engine, the battery supplies power to the starting system, ignition system, and electronic fuel injection system; 2. When the engine is stopped or idling at low speed, it powers the vehicle's electrical equipment; 3. It assists in powering the electrical equipment when the generator's output is insufficient. Motorcycles are driven by gasoline engines, with handlebars controlling the front wheel for steering, available in two or three wheels, being lightweight and flexible, and capable of rapid movement. Motorcycles are also categorized into street bikes, road racing motorcycles, off-road motorcycles, cruisers, and touring bikes.
18
5
Share

What is the method to restore the one-touch window lift function for the Lavida?

The method to restore the one-touch window lift function for the Lavida is: 1. Click on the central control screen settings; 2. Click on the door and window switches; 3. Click on convenience opening; 4. Select all windows. Taking the 2019 Lavida as an example, it belongs to the compact car category, with body dimensions of: length 4613mm, width 1765mm, height 1460mm, wheelbase 2610mm, and curb weight 1210kg. The 2019 Lavida features a front MacPherson independent suspension and a rear torsion beam non-independent suspension. It is equipped with a 1.5L naturally aspirated engine, delivering a maximum horsepower of 112PS, maximum power of 82kW, maximum torque of 145Nm, and is paired with a 5-speed manual transmission.
20
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.