What is the fuel tank capacity of the Wuling Zhiguang minivan?

What Causes Electric Power Steering to Become Heavier?

Electric power steering becoming heavier can be attributed to the following reasons: 1. Low tire pressure: If you notice the steering wheel is slightly heavier than before, it's advisable to first check the tire pressure. Sometimes, low tire pressure can also cause the steering wheel to become heavier, making it harder to turn. 2. Low vehicle speed naturally makes the steering heavier: Whether the steering wheel becomes heavier depends on its relation to vehicle speed. The assistance level of the electric power steering system is inversely proportional to the vehicle speed—it's heavier at high speeds and lighter at low speeds. Moreover, it only operates when steering, which helps reduce fuel consumption. If it's confirmed to be related to vehicle speed, this is normal. 3. Vehicle battery discharge: The energy for the electric power steering system's motor comes from the battery or the engine. Energy from the motor is only required during steering operations. If the car battery has been used for a long time, it might affect the normal output of the electric power assistance. The lifespan of a car battery is typically around 3-5 years. Batteries used for more than 3 years should be replaced promptly when necessary. 4. If it's confirmed that the issue is unrelated to vehicle speed and both tire pressure and battery are normal, it's recommended to visit a professional auto repair shop or 4S store for inspection. It's likely that the electric power steering system itself has developed a problem, such as overly tight bearings or poor lubrication.

18

5

Share

Does the car transmission fluid need to be replaced?

Transmission fluid needs to be replaced. Here is the relevant information about transmission fluid replacement: 1. Dry dual-clutch transmissions and manual transmissions have similar structures, so they both use synthetic transmission fluid with a service life of approximately 150,000 kilometers. Most automatic transmissions require fluid replacement every 60,000 to 80,000 kilometers. 2. The transmission fluid replacement cycle is just a general guideline. Due to factors such as driving conditions and habits, the condition of the transmission fluid may vary. If the vehicle experiences issues like rough shifting, strong jerking sensations, or significantly increased noise during use, it is necessary to check whether the transmission fluid needs replacement. 3. There are three common methods for replacing transmission fluid in vehicles: (1) Gravity drain: Similar to changing engine oil, the transmission fluid drain bolt is loosened to drain the fluid, and then new fluid is added through the fill port. The drawback is that gravity draining does not completely remove all the old fluid. (2) Machine flush: A transmission flush machine is connected to the transmission's fluid lines, and new fluid is added to the machine. The new fluid is then used to "push" out the old fluid from the transmission. The advantage is a thorough replacement, but the process is time-consuming and requires more transmission fluid. (3) Removing the transmission pan: The advantage is that the transmission filter can be cleaned or replaced directly, and the replacement is more thorough. The downside is that the procedure is more complicated.

2

0

Share

Can Reducing Tire Pressure Prevent Blowouts?

No. Here are specific details about tire pressure: 1. Low tire pressure increases the contact area with the ground, causing excessive deformation of the cord ply and raising tire temperature. Under intense deformation, the inner airtight layer generates extreme heat, leading to rubber and cord ply separation, drastically increasing blowout risks. 2. Tire pressure affects not only the contact area and position with the ground but also the tire's shape, particularly the sidewall - the weakest part. 3. When the sidewall contacts the ground, it deforms, causing unstable rotation during driving. With insufficient pressure, tires undergo irregular multidirectional deformation on roads. Continuous compression and friction on the cord ply can cause fractures, forming bulges until a blowout occurs.

2

0

Share

How Thick Should Homemade Car Jumper Cables Be?

For general household cars, it is recommended to use copper wires with an outer diameter of 10mm or more. Here is the relevant information: 1. Introduction: Car jumper cables are usually about 3 meters long, not too long as increased resistance will consume power; nor too short, as it will be difficult to connect. 2. Function: When a car battery is low on power, it affects the entire vehicle's power supply system, making it difficult to start the car. If the car stalls midway and cannot be restarted, calling for a tow truck can be expensive. In such cases, jumper cables from another car can be used for emergency assistance. If the battery is low on power, the car should start quickly. After starting, keep the engine running for 15 to 20 minutes to allow the alternator to recharge the battery.

12

2

Share

How to Deal with a Leaking Car Sunroof?

It is necessary to check the drainage holes and determine whether the sunroof drainage holes are blocked by observing the drainage situation. If it is confirmed that the car's drainage pipe is clogged, promptly visit a professional repair shop for treatment to avoid greater losses. A leaking car sunroof may also be caused by aging sealing strips, which should be inspected in a timely manner. The methods to prevent sunroof leakage are as follows: 1. Regularly inspect the sunroof's drainage outlets: The drainage outlets of a car sunroof are an important pathway for water drainage. If not cleaned for a long time, the drainage holes can easily become blocked, leading to water seepage. It is necessary to regularly inspect the sunroof's drainage outlets and promptly remove any dust or fallen leaves to ensure normal drainage. 2. Regularly inspect the sunroof's guide rails: Due to lack of attention during use, sand, fallen leaves, and other debris may accumulate on the sunroof guide rails. If not cleaned for a long time, the guide rails can be damaged, preventing the sunroof from closing properly and causing leaks. 3. Regularly inspect the sunroof's sealing strips: With prolonged use, the sealing strips of the sunroof may age. When the sealing strips are severely aged, the car sunroof may start to leak. 4. Try not to open the sunroof on bumpy roads: It is advisable to avoid using the car sunroof on bumpy roads, as such conditions can easily deform the sunroof guide rails, affecting their normal sealing performance.

2

0

Share

What is the horsepower of the BMW 525?

BMW 525Li-2.0T has a maximum horsepower of 184Ps, 135 kilowatts, with a rotation speed of 5000-6500 rpm. Below is a detailed introduction about BMW cars: 1. Overview: BMW cars, produced by Bayerische Motoren Werke AG (abbreviated as BMW), mainly include series such as 1, 2, 3, 4, 5, 6, 7, and 8. BMW is renowned worldwide for manufacturing luxury cars, motorcycles, and high-performance engines. 2. Logo: The BMW logo features a double-circle design with the 'BMW' inscription above the double rings. The entire emblem resembles the blue sky, white clouds, and a continuously rotating propeller, symbolizing the company's long history and its consistent goals and purposes.

9

1

Share

What is the fuel tank capacity of the Wuling Zhiguang minivan?

What Causes Electric Power Steering to Become Heavier?

Does the car transmission fluid need to be replaced?

Can Reducing Tire Pressure Prevent Blowouts?

How Thick Should Homemade Car Jumper Cables Be?

How to Deal with a Leaking Car Sunroof?

What is the horsepower of the BMW 525?

What are the differences between Paladin and Odin?

What happens if a car that requires 95-octane gasoline is filled with 92-octane?

What is Engine Cylinder Scoring?

Is Driving in Heavy Rain Harmful to the Car?