What is the fuel tank capacity of the Volkswagen Golf?

What are the best solutions for BMW 523 burning engine oil?

BMW 523 burning engine oil best solutions are as follows: 1. Check whether it is really burning engine oil: In many cases, excessive oil consumption is caused by oil leakage and is mistaken for burning engine oil. You can place a white cloth under the engine, then start the engine, and check for oil leakage based on the oil stains on the white cloth. 2. Check whether carbon deposits in the cylinders cause the piston rings to stick. 3. Replace the valve stem seals: The probability of BMW burning engine oil due to damaged valve stem seals is quite high, and they can be replaced without disassembling the cylinder. Solving the burning engine oil issue by replacing the valve stem seals can be said to be a cost-effective method. 4. Check whether the cylinder walls and pistons are severely worn with excessive clearance: This actually requires an engine overhaul, and the car's value will be greatly reduced after the overhaul.

11

1

Share

Can Flood-Damaged Vehicles Be Insured?

Flood-damaged vehicles can be insured. Here are the relevant details: 1. Introduction to flood-damaged vehicles: Flood-damaged vehicles refer to cars that have been submerged in water and are sold through certain channels to used car markets across China. 2. Introduction to partially submerged vehicles: Partially submerged vehicles typically have water levels just above most of the wheel hubs, with the floor mats definitely submerged. However, the water does not reach the engine compartment, leaving the engine and wiring harnesses undamaged. 3. Introduction to fully submerged vehicles: Floodwaters completely submerge the entire vehicle body, including the engine and all interior equipment. Such vehicles are essentially rendered useless and should not be purchased, no matter how new they appear. Not only is the engine likely damaged from water ingress, but the wiring harnesses in the engine compartment have also been soaked, significantly increasing the risk of short circuits and potential self-ignition.

17

1

Share

Will Driving with the Handbrake On Damage the Car?

Driving with the handbrake on can damage the car. The specific hazards of driving with the handbrake engaged are as follows: 1. Increased brake wear: The most direct impact is accelerated wear on the brake discs and hardening of the brake pads due to overheating, as well as stretching of the handbrake cable. This leads to a decline in braking performance, and the burnt smell sometimes noticed by drivers originates from this. In severe cases, smoke may emerge from the rear of the vehicle. 2. Damage to brakes and tires: The faster the speed while driving with the handbrake on, the greater the wear on the braking components, and it can also cause some damage to the tires. If the handbrake is left engaged for too long, it can cause the rear wheels to lock up, leading to smoke from friction and a significant loss of braking performance.

17

1

Share

Will Installing an OBD Fuel Saver Damage the Car?

Installing an OBD fuel saver will not cause any damage to the car. An OBD fuel saver is a power and fuel optimization device (based on OBD protocol) that can adjust the vehicle according to the driver's habits, remap the car's ECU, and self-regulate. It not only enhances and optimizes the car's engine and power, giving the driver a refreshing new feel, but also improves fuel efficiency, significantly aiding in reducing the car's fuel consumption. Overall, it can save a small amount of fuel, but the effect is certainly not as much as advertised by sellers. Moreover, whether it saves fuel or not depends on the car model, as some models are completely immune to OBD fuel savers. Since modern cars are largely electronically controlled, parameters such as ignition timing, fuel injection volume, and mixture concentration in the engine are all controlled by the engine ECU's program.

13

3

Share

Where is the throttle located in a minivan?

The throttle in a minivan is positioned behind the air filter of the intake system and in front of the intake manifold. The upper part is connected to the air cleaner, while the lower part links to the engine block. The throttle serves as the throat of the car engine, connecting the air cleaner and the cylinder block. It controls the engine's air intake. When the driver presses the accelerator pedal, it doesn't directly control the fuel injection but rather adjusts the throttle's opening. There are two types of throttles: traditional cable-operated and electronic. In traditional engines, the throttle mechanism operates via a cable connected at one end to the accelerator pedal and at the other to the throttle linkage plate. Electronic throttles use a throttle position sensor to regulate the opening angle based on the engine's energy requirements, thereby adjusting the air intake. If the throttle is not cleaned regularly, carbon deposits can accumulate. How to determine if the throttle needs cleaning: Use a diagnostic tool to read the throttle's opening at idle. If it's significantly larger than when the vehicle was new, cleaning is required. Alternatively, base it on mileage—typically around 20,000 kilometers, though this varies with usage (e.g., vehicles frequently driven on dusty roads require more frequent cleaning). Another method is to remove the intake duct and inspect the throttle for carbon buildup. Throttle cleaning methods include disassembly cleaning and non-disassembly cleaning. Disassembly cleaning involves removing the entire throttle assembly and thoroughly cleaning it with a specialized cleaner. This method is more labor-intensive but ensures a thorough clean. Non-disassembly cleaning has two approaches: one involves removing the intake duct and spraying cleaner onto the throttle while the engine is running; the other involves spraying cleaner onto the throttle and wiping it, requiring two people. This method is convenient but less effective, suitable for throttles with minimal carbon buildup. Electronic throttles integrate a throttle control unit, so care must be taken during cleaning to avoid damaging the internal circuit board.

20

5

Share

What does 'Refer to the owner's manual for coolant refill' mean?

Refer to the owner's manual for coolant refill is a reminder to the vehicle owner that coolant needs to be refilled. The following is an introduction about coolant: 1. Introduction to coolant: Coolant, the full name should be antifreeze coolant. It means coolant with antifreeze function. 2. Coolant can prevent the coolant from freezing and cracking the radiator and freezing the engine cylinder block during parking in cold seasons. 2. Functions of coolant: (1) Winter antifreeze: Prevents the coolant from freezing and causing the radiator and engine block to crack after the car is parked in winter. (2) Anti-corrosion: Prevents corrosion in the cooling system. (3) Anti-scaling: Reduces the formation of scale to avoid clogging the circulation pipes and affecting the heat dissipation function of the cooling system. (4) Anti-boiling: Meets the heat dissipation and cooling needs of high-load engines.

3

1

Share

What is the fuel tank capacity of the Volkswagen Golf?

What are the best solutions for BMW 523 burning engine oil?

Can Flood-Damaged Vehicles Be Insured?

Will Driving with the Handbrake On Damage the Car?

Will Installing an OBD Fuel Saver Damage the Car?

Where is the throttle located in a minivan?

What does 'Refer to the owner's manual for coolant refill' mean?

What is the actual lifespan of a dry dual-clutch transmission?

Which country does Giti Tire belong to?

After refueling, the fuel gauge doesn't move. Was I not given fuel?

Can Adding Fog Lights Pass the Annual Inspection?