What is the fuel tank capacity of the Vios in liters?

2 Answers
VincentMarie
08/29/25 4:52am
The currently available Vios models consist of 6 variants, all featuring a fuel tank capacity of 42 liters. These vehicles are equipped with a 1.5L naturally aspirated engine, delivering a maximum power output of 82kW (112 horsepower) at 6000 rpm. Among its peers, the 2020 Kia Pegas has a 43-liter tank capacity while the 2022 Yaris L (Chinese version) shares the same 42-liter capacity. During actual refueling, the amount filled may exceed the calibrated volume. This occurs because manufacturers specify tank capacity from the base to the safe fill level, leaving space between this level and the tank neck to accommodate fuel expansion due to temperature increases without overflow. Filling beyond the safe level to the neck results in exceeding the nominal capacity. To check remaining fuel, observe the fuel gauge on the right side of the instrument cluster marked with E (Empty) and F (Full). The needle approaching E indicates low fuel, while nearing F shows sufficient levels.
Was this review help?
13
1
Share
AaronFitz
09/11/25 2:40am
I remember when I first bought my Vios, I specifically checked the fuel tank capacity. The official specs stated it was around 45 liters, which is a decent size. For city commuting, a full tank could get me nearly 500 kilometers, saving me frequent refueling stops—quite convenient. I think when driving, it's better not to wait until the fuel gauge warning light comes on before heading to the gas station. Filling up in advance helps avoid the embarrassment of running out of fuel. Paying attention to driving habits, like maintaining a steady speed and avoiding harsh braking, can slightly improve mileage and extend the time between refuels. Also, when filling the tank, don’t go beyond the safety line—stop as soon as the pump clicks off to prevent overflow and waste. These small details help with both saving money and safety, so it’s worth keeping them in mind.
Was this review help?
14
2
Share
Expand All
More Forum Discussions

Why is there no fog light installed on the Audi A4L?

Audi A4L does not have fog lights installed because the headlights have a wide coverage area and a broad illumination range. Introduction to fog lights: In general, in addition to the front high beams, low beams, headlights, and parking lights, as well as the rear running lights and brake lights, there is also a set of fog lights installed in an inconspicuous place at the rear of the car. Rear fog lights are red signal lights installed at the rear of the vehicle to make it easier for road traffic participants behind to detect the vehicle in environments with low visibility such as fog, rain, or dust, and they emit a stronger light intensity than the tail lights. Classification of fog lights: Fog lights are divided into front fog lights and rear fog lights. Front fog lights are generally bright yellow, while rear fog lights are red. The symbol for the rear fog light is slightly different from that of the front fog light. The light lines of the front fog light symbol point downward, while those of the rear fog light are parallel, usually located on the dashboard inside the car.
9
1
Share

What Causes Loud Noises During Cold Starts in BMW Vehicles?

Introduction to the causes of loud noises during cold starts in BMW vehicles: Engine Carbon Buildup: This occurs because old engine oil becomes increasingly thin with use, leading to more carbon deposits. Thin oil is prone to leakage, resulting in increased carbon buildup and significant power loss. When new oil is added, the engine may struggle to adapt to the oil's viscosity, potentially causing higher RPMs and consequently louder engine noises. The most effective way to reduce carbon formation is to periodically clean the vehicle's intake system at a 4S dealership. It is recommended to perform necessary cleaning of the intake system around every 30,000 kilometers. Incorrect Engine Oil Specifications: Or excessive oil levels can cause unnecessary resistance to crankshaft rotation, affecting power output and increasing fuel consumption. Carbon deposits in the cylinders, which can become red-hot, may lead to premature ignition. Additionally, carbon buildup accelerates wear on cylinders and pistons and negatively impacts oil quality. In summary, excessive oil increases the stirring resistance of the crankshaft and connecting rods, leading to louder noises. Regularly change the engine oil, maintain an appropriate oil level (generally slightly below the upper limit on the dipstick), and periodically clean or replace the oil filter cartridge.
1
4
Share

How many liters of engine oil should be added to the BMW 2 Series Gran Tourer?

BMW 2 Series Gran Tourer requires approximately 4L of engine oil. Precautions after adding engine oil: When changing the engine oil, the oil filter must also be replaced. Check whether there is engine oil inside the newly replaced oil filter. After starting the vehicle, the engine oil will flow into the oil filter. Turning off the engine for 3 minutes allows the oil to flow into the oil pan, ensuring a more accurate oil level check. Remember not to check the oil level on a slope, as the vehicle's tilt will cause the oil in the oil pan to tilt as well, resulting in an inaccurate oil level reading. Effects of improper oil level: Overfilling engine oil can affect the normal operation of the crankshaft and increase the vehicle's fuel consumption. When the crankshaft journal reaches the bottom dead center, it may come into contact with the excess oil, creating resistance and hindering normal operation. Insufficient engine oil will not provide adequate lubrication for circulation, leading to accelerated wear of internal engine components and potential engine damage.
16
0
Share

How often should a car be waxed for maintenance?

In summer, it is recommended to wax the car approximately every three months, while in winter, waxing every 3 to 4 months is sufficient. Generally, waxing every two to three months is advisable. New cars should be waxed as soon as possible after purchase. Before waxing, it is best to wash the car with water to remove dirt and dust from the body. Waxing should be done in a shaded area to ensure the car body does not become too hot. When applying wax, use a sponge to apply an appropriate amount of car wax, then polish it with a microfiber towel in straight, back-and-forth motions on the car body. Avoid pouring wax directly onto the car or applying it in circular motions. The waxing process should be completed in one continuous session without interruptions. Typically, after the wax layer is evenly applied, it should be polished with a new towel within 5 to 10 minutes. However, for quick waxes, polishing should be done simultaneously with application. After waxing the car body, some wax residue may remain in gaps such as around the lights, license plate, doors, and trunk. It is important to maintain an appropriate waxing frequency.
15
4
Share

What to Do If You Can't Find Your Old Driver's License When Renewing It?

If you lose your driver's license when renewing it, you can directly apply for a replacement. The replaced driver's license is equivalent to a renewal. Time Regulations: If it has been expired for less than one year, you can renew it normally; if it has been expired for more than one year but less than three years, the license will be canceled, but you can renew it by passing the subject one test; if it has been expired for more than three years, the license will be invalid and cannot be renewed. Renewal Deadline: The motor vehicle driver should apply for renewal at the vehicle management office of the driver's license issuing place within 90 days before the expiration of the motor vehicle driver's license. When applying, you should fill in the "Motor Vehicle Driver's License Application Form". Renewal Materials: Bring two copies of ID card, two 1-inch color photos without hats, original ID card, original driver's license, and physical examination certificate from a county-level or above hospital (you can also get a free physical examination at the vehicle management office).
4
3
Share

Where is the cruise control on the Cayenne?

The cruise control switch for the Cayenne is located on the steering wheel. Press the (ON/OFF) button to activate the system, and the cruise indicator light on the dashboard will illuminate. Accelerate to the desired speed, then press the SET button. You can then remove your right foot from the accelerator pedal, and the speed setting is complete. You can fine-tune the speed by pressing the SET +/- buttons on the steering wheel. Meaning of cruise control system: Also known as a speed control device, speed control system, or autonomous driving system, its function is to automatically maintain the vehicle speed as set by the driver without the need to press the accelerator pedal, allowing the vehicle to travel at a fixed speed. Features of cruise control system: With advancements in automotive technology, traditional cable-type throttle control methods are rapidly being replaced by electronic throttle control methods. Cable-type cruise control systems mainly consist of a control switch, control module (cruise computer), and servo (mechanical actuator). The working principle of the cruise control system, simply put, involves the cruise control module comparing the pulse signal from the speed sensor with the set speed and then issuing commands to the servo to mechanically adjust the throttle opening to increase or decrease, ensuring the vehicle maintains the set speed. Electronic multifunction cruise control systems eliminate the mechanical control parts of cable-type cruise control systems, relying entirely on precise electronic control for more accurate operation and avoiding the risk of mechanical failures.
18
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.