What is the fuel tank capacity of the Toyota Yaris L in liters?

1 Answers
Kaylee
07/30/25 5:27am
The 2022 Toyota Yaris L 1.5L CVT Luxury PLUS edition has a fuel tank capacity of 42 liters. It is equipped with a 1.5L naturally aspirated engine and an 8-speed continuously variable transmission (CVT). The drivetrain configuration is front-engine, front-wheel drive. The front suspension uses a MacPherson strut independent suspension, while the rear suspension employs a torsion beam non-independent suspension. Among comparable models in its class, the 2021 Volkswagen Polo Plus 1.5L Manual Panorama Enjoy edition has a 42.5L fuel tank, while the 2021 Honda LIFE 1.5L CVT SPORT edition features a 40L fuel tank. During actual refueling, the amount of fuel filled may exceed the nominal capacity. This occurs because automakers measure tank capacity from the tank bottom to a safe fill level, leaving space between this level and the tank opening. This design accommodates fuel expansion due to temperature increases, preventing overflow. If fuel is filled up to the tank opening, the actual refueled quantity will surpass the nominal capacity. To check remaining fuel levels, drivers can observe the fuel gauge on the right side of the instrument cluster, marked with 'E' (Empty) and 'F' (Full). When the needle approaches 'E', it indicates low fuel, while proximity to 'F' shows sufficient fuel levels.
Was this review help?
11
2
Share
More Forum Discussions

Should the clutch be fully released or partially engaged when starting on a slope?

When starting on a slope, the clutch should be partially engaged because, whether on flat ground or an uphill slope, fully depressing the clutch cuts off power output. If the clutch is suddenly depressed on flat ground, the car will continue to move forward slowly due to inertia but will gradually slow down until it stops because of frictional resistance. However, if the clutch is suddenly depressed on an uphill slope, the car will usually stop quickly and even roll backward. The "slope fixed-point parking and starting" test item has been removed from the Category 2 driving test for small automatic transmission vehicles. Tips for the Category 2 driving test: 1. Pre-test preparation: After getting into the car, adjust the seat, rearview mirrors, and fasten the seatbelt. 2. Adjust the car's position relative to the boundary line: Adjust the distance between the car and the boundary line before entering the reverse parking area. 3. Control the speed: When depressing the clutch, do not do it too quickly or too slowly.
17
1
Share

What are the differences between the Baojun 510 and Baojun 530?

The differences between the Baojun 510 and Baojun 530 can be seen in the following aspects: In terms of body dimensions, the Baojun 510 measures 4220mm in length, 1740mm in width, and 1615mm in height; the Baojun 530 measures 4655mm in length, 1835mm in width, and 1760mm in height. In terms of wheelbase, the Baojun 510 has a wheelbase of 2550mm, while the Baojun 530 has a wheelbase of 2750mm. In terms of power, the Baojun 510 is equipped with a 1.5L naturally aspirated engine from General Motors, with a maximum power of 112 horsepower and peak torque of 147 Nm; the Baojun 530 is equipped with either a 1.5T or a 1.8L engine, with maximum power outputs of 150 horsepower and 137 horsepower, respectively.
12
4
Share

Can CarPlay Connect to Android Phones?

CarPlay cannot connect to Android phones. This system is only compatible with Apple devices. Many cars are equipped with CarPlay functionality, which allows you to connect your Apple iPhone to the car's infotainment system. This enables features like navigation, making and receiving calls, using voice assistants to control the car's system, listening to music, and more. However, connecting your phone to the car's system requires a data cable, and it is recommended to use the original cable. There are three ways to control CarPlay: 1. Siri: You can communicate with your car using Siri, listen to system-read messages from your phone, and reply via voice dictation; 2. Touchscreen Display: Some CarPlay-compatible cars come with a touchscreen display, allowing you to open or close apps directly from the main screen; 3. Physical Buttons: Some cars have physical buttons, which are another way to control CarPlay.
20
1
Share

How to Know If the Car Battery Still Has Power

Methods to determine if the car battery still has power: 1. Observe the feedback when starting the car—if it feels particularly sluggish, the battery may be running low; 2. Check the battery warning light—if it stays on, it indicates the car battery is nearly depleted and requires immediate charging; 3. Press the car horn directly—if the horn sounds weaker than usual, it may be due to the battery running low. Reasons for a depleted car battery: 1. Prolonged vehicle inactivity; 2. The car battery has reached the end of its lifespan; 3. Generator damage; 4. Insufficient electrolyte or leakage causing battery depletion; 5. Blown fuse leading to battery failure; 6. Corrosion of battery terminals resulting in power loss.
5
3
Share

What Components Make Up a Lock-Up Clutch?

A lock-up clutch consists of components such as the lock-up piston, damper plate, and turbine drive plate. The lock-up piston and damper plate are connected via splines, allowing for forward and backward movement. The damper plate and turbine drive plate are linked by damping springs, which help attenuate torsional vibrations during clutch engagement. The turbine drive plate is secured to the front of the turbine with rivets, while the front surface of the torque converter housing is lined with friction material. The working principle of the lock-up clutch involves its engagement and disengagement being controlled by the electronic control unit through a lock-up solenoid valve. When the vehicle starts or travels on poor road surfaces, the lock-up clutch can be disengaged to allow the torque converter to function, fully leveraging the advantage of hydraulic transmission's automatic adaptation to drastic changes in driving resistance. Conversely, when the vehicle is driven on good road surfaces, the lock-up clutch should be engaged to create a rigid connection between the torque converter's input and output shafts, effectively converting to direct mechanical transmission.
18
5
Share

What are the hand signals for a right turn on standby?

There are three hand signals for a right turn on standby: 1. Stop signal: The traffic officer extends their left arm forward and upward, palm facing forward. This is the stop signal, indicating that vehicles facing the officer's direction should stop; 2. Go straight signal: The traffic officer extends their left arm horizontally while turning their head to the left, palm facing forward; simultaneously extends their right arm horizontally while turning their head to the right, palm facing forward, and swings it to the left. This is the go straight signal, indicating that vehicles to the officer's right should proceed straight; 3. Right turn signal: The traffic officer extends their left arm forward, palm facing forward, indicating that vehicles directly ahead should stop; then the officer turns their head to the right, with their right arm and palm extended straight and swinging to the left front, palm facing left, indicating that vehicles should make a right turn in the direction the officer's head is facing.
13
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.