What is the fuel tank capacity of the Tang DM in liters?

1 Answers
ColtonDella
07/29/25 8:04pm
BYD Tang DM has a fuel tank capacity of 53L. Below is information about the fuel filler location of the Tang DM and an introduction to fuel tank capacities of other vehicles: Fuel filler location of Tang DM: The fuel filler of the Tang DM is located on the left rear side of the vehicle and can be opened using the unlock button on the driver's side door panel. Additionally, there is an emergency release cable on the left trim panel of the luggage compartment for emergency opening of the fuel filler door. Fuel tank capacities of other vehicles: The fuel tank capacity refers to the maximum safe capacity announced by the manufacturer. Micro and small cars typically have capacities between 35-55 liters, compact and mid-size cars between 55-70 liters, while some large full-size SUVs may exceed 100L in fuel tank capacity.
Was this review help?
20
2
Share
More Forum Discussions

How Often Should Car Engine Oil Be Changed Based on Time?

Car engine oil should generally be changed approximately every 6 months. Engine oil, also known as engine lubricant, serves the following functions: 1. Reducing friction and high temperatures; 2. Cooling and lowering temperature; 3. Cleaning and removing contaminants; 4. Dampening vibrations and cushioning impacts; 5. Preventing rust and corrosion. The steps for changing car engine oil are as follows: 1. Start the vehicle's engine to warm it up; 2. Unscrew the oil drain bolt; 3. Remove the oil filter; 4. Apply new oil to the gasket of the new oil filter; 5. Pour the new oil into the oil pan; 6. Check for leaks under the engine and verify the oil level using the dipstick before starting the engine for testing. Engine oil consists of base oil and additives. The base oil is the primary component of lubricating oil, determining its fundamental properties, while additives compensate for and enhance any shortcomings in the base oil's performance.
1
1
Share

What Are the Differences Between Good and Bad Car Window Tints?

Car window tints differ in quality based on texture, visibility, color, and odor. Texture differences: High-quality window tints undergo multiple manufacturing processes and surface hardening treatments, resulting in a smooth and premium feel. They are highly resistant to scratches even after prolonged use. In contrast, low-quality tints are often just ordinary colored films with a rough, thin, and brittle texture, prone to scratches and poor durability. Visibility differences: The primary performance metric of car window tints is clarity. A qualified tint should maintain excellent visibility regardless of how dark the color is, which is crucial for driving safety. Color differences: When selecting a tint, car owners can spray a small amount of carburetor cleaner on the film and scratch it lightly. High-quality tints will retain their color, whereas low-quality ones will show severe color fading. Odor differences: Premium tints involve complex manufacturing processes and high technical standards, passing health and safety inspections before entering the market. They do not release harmful volatile substances even under intense sunlight. Low-quality tints, however, use simple manufacturing techniques and cheap materials, often emitting hazardous substances like formaldehyde and benzene during use.
20
0
Share

Is the Explosion Probability of Automotive Natural Gas Tanks High?

The probability of a gas tank explosion is almost zero. An explosion would only occur if the tank is deliberately exposed to direct sunlight or subjected to open flame roasting, causing excessive internal gasification pressure, tank rupture, gas leakage mixing with air, and encountering open flames or sparks. However, this would result in an air explosion rather than the tank itself exploding. Specific details about automotive natural gas tanks are as follows: Automotive Liquefied Natural Gas (LNG) Storage Tanks: These refer to high-vacuum insulated containers installed in vehicles for storing liquefied natural gas. They feature a double-layer (vacuum) design. The inner tank is used to store cryogenic liquid LNG, with multiple layers of insulation material wrapped around its outer wall, providing superior thermal insulation. The jacket (the space between the two layers) is evacuated to a high vacuum, collectively forming an excellent insulation system. The outer shell and support system are designed to withstand the external forces generated during vehicle operation. Purpose: Automotive Compressed Natural Gas (CNG) cylinders are primarily used for long-term, fixed installation of compressed natural gas in vehicles. They offer advantages such as high pressure, large capacity, lightweight, and safety reliability. They are mainly used in taxis, minibuses, buses, and other vehicles in major and medium-sized cities.
17
2
Share

What is the actual fuel consumption of the Equinox?

The Equinox currently has 6 models on sale, which are divided into the Equinox 2022 Light Hybrid 550TRS Four-Wheel Drive Smart Guard Edition, Equinox 2022 Light Hybrid 550TRS Four-Wheel Drive Smart Pioneer Edition, and Equinox 2022 Light Hybrid 550TRS Smart Pioneer Edition, all equipped with a 2.0T 237 horsepower L4 engine, with an NEDC fuel consumption of 9.2L per 100km. The Equinox 2022 535T Lead Edition, Equinox 2022 535T Chase Edition, and Equinox 2022 535T Drive Edition are equipped with a 1.5T 169 horsepower L4 engine, with an NEDC fuel consumption of 6.8L per 100km. Different models have different fuel tank capacities, and the distance that can be covered with a full tank of fuel is as follows: Models equipped with the 2.0T 237 horsepower L4 engine have a fuel tank capacity of 59L, and the distance that can be covered with a full tank is 59/9.2*100=641km. Models equipped with the 1.5T 169 horsepower L4 engine have a fuel tank capacity of 56L, and the distance that can be covered with a full tank is 56/6.8*100=823km. The fuel consumption of a car is directly related to five major factors, namely driving habits, the car itself, road conditions, natural wind, and environmental temperature. Specific factors that can increase a car's fuel consumption are as follows: Driving habits: Rough driving, such as sudden acceleration, frequent overtaking, and not easing off the throttle in advance when approaching a red light, can increase fuel consumption. The car itself: Cars with larger displacements consume more fuel than those with smaller displacements because larger displacements generally mean greater power, requiring more gasoline to burn and perform work. Cars with greater self-weight consume more fuel because greater self-weight requires larger driving torque. Road conditions: Dirt roads, muddy roads, soft surfaces, mountain roads, etc., where driving resistance is high, can increase fuel consumption. Natural wind: Driving against the wind or on windy days increases car resistance and fuel consumption. Low environmental temperatures mean the engine block temperature is low, and the gasoline injected during cold starts is not easily atomized, requiring more gasoline to be injected for combustion, thus increasing fuel consumption. At the same time, low temperatures cause the engine computer to control the car to warm up at higher RPMs, which also increases fuel consumption.
15
2
Share

What is the normal tire pressure for Geely Emgrand GS?

The recommended tire pressure range for Geely Emgrand GS is 2.4-2.5 bar. Due to seasonal factors, the normal tire pressure may vary slightly between different models. In winter, the tire pressure can be appropriately increased by 0.2 bar, while in summer it can be reduced by 0.1 bar. This data complies with the international GBT2978-2008 standard. The Geely Emgrand GS comes equipped with a tire pressure monitoring system that automatically alerts the driver without manual operation. The Emgrand GS tire pressure monitoring system does not have a digital display. The tire pressure warning light will only illuminate when the tire pressure is too low (below 1.8 bar) or too high (above 2.8 bar). If the warning light is off, it indicates normal tire pressure. Generally speaking, a tire pressure above 2.8 bar is considered too high, while a tire pressure below 2.0 bar is considered too low. Hazards of excessive tire pressure: Reduced tire friction and adhesion, affecting braking performance; Causes steering wheel vibration and deviation, reducing driving comfort; Accelerates wear on the central tread pattern, shortening tire lifespan; Increases vehicle vibration, indirectly affecting the lifespan of other components; Overextends tire cords, reducing tire elasticity and increasing the load on the vehicle during driving. Hazards of insufficient tire pressure: Increases friction coefficient with the road surface, leading to higher fuel consumption; Makes the steering wheel heavy and prone to deviation, compromising driving safety; Increases movement of tire components, causing abnormal heat due to excessive rolling; Weakens cord and rubber functions, leading to delamination or cord breakage and excessive friction with the rim, damaging the bead area and causing abnormal wear; Multiplies friction between the tire and the ground, sharply increasing tire temperature, softening the tire, and drastically reducing its strength. High-speed driving may result in a tire blowout. If the tire pressure monitoring indicator light illuminates (a yellow symbol with an irregular circle, no stamp on top, four small spikes at the bottom, and an exclamation mark inside), it is generally due to one of the following three reasons: Abnormal tire pressure: The system typically alerts when the pressure is below 1.8 bar or above 3.0 bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure is not reset promptly, the system may still record the previous data, causing the indicator light to illuminate. Simply reset the tire pressure to resolve this issue. Damaged tire pressure sensor: The tire pressure sensor, installed inside the tire and connected to the inflation valve, monitors tire pressure. If the sensor is damaged due to impact while driving, the tire pressure warning light will illuminate. In such cases, the only solution is to replace the sensor with a new one.
3
4
Share

How to Drive in Deep Water?

Drive slowly in deep water using a low gear. Here are some precautions when driving through water: 1. Slow down and stop if necessary: Be cautious of 'hydroplaning' when driving on water-covered roads. At high speeds, water between the tires and the road surface cannot be displaced, leading to a loss of friction between the vehicle's weight and the road, increasing the risk of hydroplaning. Therefore, reduce speed to avoid hydroplaning and prevent accidents. 2. Do not restart the engine if it stalls in water: Once the engine stalls due to water, restarting it may cause significant damage to the engine.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.