···
Log in / Register

What is the fuel tank capacity of the Scirocco 2.0 in liters?

4 Answers
AustinLee
07/29/25 1:06pm

The fuel tank capacity of the Scirocco 2015 2.0TSI Luxury Edition is 55L. It is equipped with a 2.0L turbocharged engine and a 6-speed wet dual-clutch transmission (DCT). The drivetrain is front-engine, front-wheel drive. The front suspension is a MacPherson strut independent suspension, and the rear suspension is a multi-link independent suspension. Among vehicles in the same class, the BMW Z4 2022 sDrive25i M Sport Package has a fuel tank capacity of 52L, while the Mustang 2021 2.3L EcoBoost has a fuel tank capacity of 58.9L. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity marked by the manufacturer is measured from the bottom of the tank to the safe fill level. There is additional space from the safe fill level to the tank opening, which is designed to allow for fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked tank capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the instrument panel, which is marked with E (Empty) and F (Full). When the needle is close to E, it indicates low fuel, while proximity to F indicates sufficient fuel.

Was this review help?
12
0
Share
DelJaxson
08/14/25 2:36am

I drive a Scirocco 2.0, and its fuel tank capacity is exactly 55 liters. This size is quite suitable for daily commuting. A full tank of 95-octane gasoline can last around 550 kilometers, depending on road conditions and driving habits. In city traffic with congestion, fuel consumption can rise to about 10 liters per 100 km, but on the highway, it can drop to 7 liters. Remember not to wait until the fuel light comes on to refuel; I usually go to the gas station when there's a quarter left to protect the fuel pump's lifespan. Additionally, the fuel cap has a push-to-close design—just press it lightly after refueling to lock it securely, which is very convenient. It's also advisable to regularly check the pipes near the fuel tank, as older cars are prone to leakage risks.

Was this review help?
1
0
Share
Expand All
Ramirez
10/09/25 7:46am

The fuel tank design of the Scirocco 2.0 is 55 liters, which I've tested several times. It's best to use 95-octane gasoline, and filling up every two weeks is generally sufficient. Last week, I tested the range on the highway—with cruise control set at 110 km/h, it ran for 620 km before the fuel light came on, exceeding the official data. I recommend refueling in the morning when the oil temperature is lower and the density is higher, allowing you to get slightly more fuel. Once at a gas station, I saw someone shaking their car vigorously to squeeze out a few extra drops—totally unnecessary, as the fuel tank's structural design already accounts for expansion space. Just be careful not to use low-quality gasoline, as it can easily clog the fuel injectors.

Was this review help?
10
0
Share
Expand All
EvelynLee
11/23/25 2:13am

My Scirocco 2.0 has a standard fuel tank capacity of 55 liters, with the dashboard displaying an 8-segment fuel gauge. When the car was new, I specifically asked the salesperson at the 4S dealership and confirmed that the fuel tank is made of engineering plastic, which is lighter and more corrosion-resistant than traditional steel tanks. For daily refueling, it usually costs just over 300 yuan to fill up, which lasts me more than ten days for commuting. When the low fuel light comes on, there's approximately 5 liters of reserve fuel left, enough to get to a gas station. Remember that the fuel tank cap might freeze in cold weather, so applying some rust remover in advance can help prevent this. Don't overfill the tank—stop when the pump clicks, as excessive filling might cause fuel vapors to enter the carbon canister.

Was this review help?
16
4
Share
Expand All
More Forum Discussions

What is the method for judging the distance between cars through the rearview mirror?

The method for judging the distance between cars through the rearview mirror is: 1. Use the center of the rearview mirror as a reference line. When the car body is on the outside of the reference line and the rear vehicle cannot be fully seen, the distance is 5 meters; 2. When the rear vehicle can fully appear in the rearview mirror and the car body is pressed against the reference line, the distance is 10 meters; 3. When the rear vehicle is pressed against the central axis of the rearview mirror and there is still a width of one car between the vehicle in the rearview mirror and the outer edge of the rearview mirror, the distance is 15 meters; 4. When the rear vehicle is pressed against the central axis of the rearview mirror and there is a width of two cars between the rear vehicle and the outer edge of the rearview mirror, the distance is 20 meters.
17
1
Share

How many hours can the parking air conditioner be used?

Parking air conditioner can be used for 1 to 2 hours. The components of the air conditioner are: compressor, condenser, evaporator, liquid storage dryer and expansion valve. The functions of the air conditioner: 1. Use the continuous abnormal cycle of refrigerant to achieve the cooling effect; 2. Remove dust, odor, smoke and toxic gases in the car air to make the air in the car fresh, humidify the air in the car, and increase the relative humidity of the air in the car. Precautions for using the air conditioner: 1. The temperature should not be too low; 2. Control the direction of the air outlet; 3. Avoid long-term use; 4. Turn on the high air volume appropriately; 5. Turn off the air conditioner when driving at low speed.
8
2
Share

Can You Add Water to Windshield Washer Fluid?

The method for adding water to windshield washer fluid is as follows: 1. Turn on the wiper switch to spray the windshield washer fluid from below the front windshield; 2. Continue until the spray nozzles stop spraying fluid, then open the windshield washer fluid filler cap and add a small amount of windshield washer fluid; 3. Turn on the wiper switch again to clear out any remaining windshield washer fluid; 4. When no more fluid sprays out from the nozzles the second time, add windshield washer fluid and securely close the filler cap. The functions of windshield washer fluid include: 1. Cleaning debris off the windshield; 2. Lowering the freezing point of the liquid; 3. Ensuring the windshield remains clear and transparent for optimal visibility; 4. Eliminating static charges on the glass surface; 5. Reducing friction between the wipers and the glass to prevent scratches.
1
4
Share

Will the Engine Stall If You Brake Without Pressing the Clutch?

Directly braking to a complete stop without pressing the clutch will definitely cause the engine to stall. Here is relevant information about the engine stalling when braking without pressing the clutch: 1. The engine and wheels are still "connected," so if the wheels stop turning, the engine naturally stops as well. 2. The clutch is located within the flywheel housing between the engine and the transmission. The clutch assembly is secured to the rear plane of the flywheel with screws, and the output shaft of the clutch is the input shaft of the transmission. 3. During driving, the driver can press or release the clutch pedal as needed to temporarily separate or gradually engage the engine and transmission, thereby cutting off or transmitting the engine's power input to the transmission.
11
2
Share

Where is the fuse box located in the Geely Vision?

The fuse box in the Geely Vision is located under the dashboard (on the driver's side) and in the engine compartment (on the left side). Spare fuses and the fuse clip are secured inside the cover of the cabin fuse box. If a fuse is blown, use the fuse puller to remove it and replace it with a new one. Below are the steps to check and replace a fuse: 1. Switch the power mode to ON and turn off the headlights and all accessories. 2. Remove the fuse box cover. 3. Check the large fuses in the engine compartment. If a fuse is blown, use a cross-head screwdriver to remove the screw and replace it with a new fuse. 4. Check the small fuses in the engine compartment and inside the vehicle.
6
3
Share

How to install fog lights on BYD F3?

Installation process for BYD F3 fog lights: 1. First, turn the steering wheel to the extreme (turn right for left fog light replacement, turn left for right fog light replacement to expose the working area), then remove the screws on the cover plate. 2. Next, remove the two plastic fasteners under the front bumper, use a flat-head screwdriver to remove the cover plate behind the tire, and then pry open a gap with your hand. The width of the gap only needs to be enough for your hand to reach in. 3. Pry open the clip next to the connector to remove the power connector, then rotate the fog light counterclockwise to remove it. 4. Install the new fog light and reassemble it following the original method.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.